2012 Citroen C5 seats

CONTENTS
Monochrome screen C 43
Colour screen (eMyWay) 45
II - MULTIFUNCTION SCREENS 43 Î 46
Ventilation 47
Mono-zone digital
air conditioning 49
Dual-zone digital
air conditioning 52
Programmable heating 56
Front seats 60
Rear seats 64
Mirrors 65
Steering wheel adjustment 66
47Î 66
Remote control key 67
Alarm 73
Electric windows 75
Doors 77
Boot 79
Sunroof (Saloon) 82
Panoramic sunroof (Tourer) 83
Fuel tank 84
Misfuel prevention (Diesel) 85
67 Î 85
Lighting controls 86
Automatic illumination
of headlamps 88
Headlamp adjustment 89
Directional lighting 90
Wiper controls 92
Automatic rain sensitive
windscreen wipers 93
Courtesy lamps 94
Interior mood lighting 96
86 Î97
Interior fi ttings 98
Mats 99
Front armrest 99
Boot fi ttings 101
VI -FITTINGS 98Î104
Instrument panels 26
Trip computer 29
Warning and indicator lamps 32
Adjustment buttons 42
FAMILIARISATION 4 Î 23
I - MONITORING 26 Î42
Child seats 105
ISOFIX child seats 109
Child lock 113
VII - CHILD SAFETY 105Î113
ECO-DRIVING 24 Î 25

11
FAMILIARISATION


1.
Seat cushion height, angle and slide
adjustments.

2.
Adjustment of the backrest angle.

3.
Adjustment of top of backrest.

4.
Adjustment of lumbar support height
and level.

5.
Massage function.

6.
Heated seat control.


A.
Adjustment of the backrest angle.

B.
Adjustment of the seat height.

C.
Heated seat control.

D.
Longitudinal adjustment of seat.

E.
Adjustment of the backrest lumbar
support.


Storing settings

This function allows you to programme
and store the driver’s seat and the air
conditioning settings. The correct position
for the upper seat
belt anchorage places the belt across
the middle of the shoulder.


)
To adjust the seat belt for height,
compress the control and slide
it in
the desired direction.


Seat belt height adjustment

Front seats


Electric adjustments

Manual adjustments

60



61




120




63

16
FAMILIARISATION
MONITORING

Tyre under-inflation detection

The tyre under-infl ation detection sys-
tem is a driving aid which informs you
of the state of your tyres.
It does not replace either vigilance or
responsibility on the part of the driver.

Economy mode

After switching off the engine, some sys-
tems (radio, wipers, electric windows,
opening roof, electric seats, telephone,
video, interior lighting, motorised tail-
gate, etc.) are supplied electrically for a
maximum of no more than around one
hour, so as to avoid discharging the
battery.
This period may be reduced considerably
if the battery's state of charge is low.
Once this period is over, a message
is displayed in the instrument panel
screen and the active functions are
placed on standby.
These functions will be automatically re-
activated when the vehicle is restarted.


115




198

25

Limit the causes of excess
consumption

Spread loads throughout the vehicle;
place the heaviest items in the bottom
of the boot, as close as possible to the
rear seats.
Limit the loads carried in the vehicle
and reduce wind resistance (roof bars,
roof rack, bicycle carrier, trailer...). Use
a roof box in preference.
Remove roof bars and roof racks after
use.

At the end of winter, remove snow
tyres and refi t your summer tyres.



Observe the recommendations
on maintenance

Check the tyre pressures regularly,
when cold, referring to the label in the
door aperture, driver's side.
Carry out this check in particular:


- before a long journey,

- at each change of season,

- after a long period out of use.
Don't forget the spare wheel and the
tyres on any trailer or caravan.

Have your vehicle serviced regularly (en-
gine oil, oil fi lter, air fi lter...) and observe
the schedule of operations recommend-
ed by the manufacturer.


When refuelling, do not continue after
the 3 rd cut-off of the nozzle to avoid
any overfl ow.

At the wheel of your new vehicle,
it is only after the fi rst 1 800 miles
(3 000 kilometres) that you will see
the fuel consumption settle down to a
consistent average.

III
47
COMFORT
VENTILATION


A.
Sunshine sensor.

B.
Soft air diffusion grille.
The soft air diffusion grille located
in the centre of the dashboard pro-
vides optimum distribution of the
air for the front seats.
This system eliminates unpleas-
ant air currents while maintaining
an optimum temperature in the
passenger compartment.
To open the soft air diffusion
grille, turn the wheel upwards.
To close the soft air diffusion
grille, turn the wheel fully down-
wards.
In very hot weather, to obtain
more satisfactory central and
side ventilation, it is advisable to
close the diffused air grille.

C.
Cooled glove box.

D.
Rear passenger vents.

III
48
COMFORT

Air conditioning

We recommend use of the automatic
regulation of the air conditioning.
It permits automatic and optimised
control of all of the following func-
tions: air fl ow, temperature in the
passenger compartment and air
distribution, by means of various
sensors (ambient temperature, sun-
shine). This eliminates any need for
you to change your settings other
than the temperature value dis-
played.


)
Take care not to cover the sun-
shine sensor A
.
If you select the automatic mode
(by pressing the "AUTO" control)
and leave all of the vents open, opti-
mum comfort will be maintained and
humidity and condensation will be
removed regardless of the exterior
climatic conditions.
The temperature in the passenger
compartment can only be lower than
the ambient temperature if the air
conditioning is on.
HEATING, VENTILATION
AND AIR CONDITIONING
RECOMMENDATIONS In order to be effective, the air con-
ditioning must be used with the win-
dows closed. If the vehicle has been
parked in the sun for a long period
and the interior temperature is very
high, fi rst ventilate the passenger
compartment with the windows
open for a few minutes, then close
the windows.
To keep the air conditioning system
in good working order it is essential
that it is operated at least once a
month.
The air conditioning uses engine pow-
er during its operation. As a result,
the fuel consumption of the vehicle
increases.
In certain cases of particularly ardu-
ous use (e.g. towing the maximum
load on a steep gradient in high tem-
peratures), switching off the air con-
ditioning saves engine power and
improves the towing capacity.


Air inlet

Check that the exterior grille for the
air inlet, at the bottom of the wind-
screen, is clean and free of dead
leaves, snow, etc.
When washing the vehicle using a
high pressure nozzle, avoid spray-
ing at the air inlet.


Air circulation

Maximum comfort is obtained by
means of a good distribution of air in
the passenger compartment, both in
the front and in the rear.
To obtain a uniform distribution of
air, take care not to block the ex-
terior air intake grille located at the
base of the windscreen, the vents,
the air outlets under the front seats
and the air extractor located behind
the fl aps in the boot.
The front and rear vents are fi tted
with thumbwheels to adjust the air
fl ow and direction. We recommend
that you leave all of the vents open.


Dust filter / Odour filter
(active carbon)
There is a fi lter for excluding odours
and dust.
This fi lter must be changed in line
with the vehicle's servicing schedule
(see the vehicle's servicing booklet).

III
60
COMFORT
FRONT SEATS MANUAL ADJUSTMENTS



1.
Adjustments to the height and
angle of the head restraint

To raise it, pull upwards.
To lower it, press on the control A

to unlock it, and simultaneously
on the head restraint itself. The
adjustment is correct when the
top edge of the head restraint
is at the same height as the top
of the head. It is also tilt adjust-
able.
To raise it, press control A
to
unlock it, then pull it upwards. It
may be necessary to adjust the
backrest angle.

2.
Adjustment of the backrest
angle

Operate the control and adjust
the position of the backrest to
the front or to the rear.

3.
Adjustment of the seat height

Raise or lower the control the
number of times required to ob-
tain the desired position.

4.
Longitudinal adjustment of
seat

Lift the control bar and adjust to
the desired position.

5.
Adjustment of lumbar support



Turn the control and adjust to the
desired position.

6.
Heated seat controls

The heated seats only operate
when the engine is running. Seat consisting of a seat cushion, seat back and head restraint which can all be
adjusted for optimum driving comfort.

For your safety, do not drive with
the head restraints removed; they
must be in place and correctly ad-
justed.

III
61
COMFORT
FRONT SEATS
ELECTRIC ADJUSTMENTS

To adjust the electric seats, switch on the ignition or start the engine if the ve-
hicle has gone into economy mode.
Seat adjustments are also possible for a short period after opening one of the
front doors or switching off the ignition.

2.
Adjustment of the backrest
angle

Move the control forwards or
backwards to adjust the backrest
angle.

3.
Adjustment of the angle of the
top of the backrest

Move the control forwards or
backwards to adjust the angle of
the top of the backrest.

1.
Adjustment of the seat height
and angle, and longitudinal
adjustment



)
Raise or lower the front of the
control to adjust the seat cush-
ion angle.

)

Raise or lower the rear of the
control to raise or lower the seat.

)
Simultaneously raise or lower
the front and rear of the control
in order to raise or lower the
entire seat.
4.
Adjustment of lumbar support



This function allows you to inde-
pendently adjust the height and
level of lumbar support.
Move the control:


)
Forwards or backwards to in-
crease or reduce the lumbar
support.

)
Upwards or downwards to raise or
lower the lumbar support zone.







Head restraint height and
angle adjustments on electric
seats


)
To adjust the angle of the head
restraint, push back or pull for-
ward section C
of the head re-
straint until you reach the desired
position.

)
To raise it, pull upwards.

)
To lower it, press on the control D

to unlock it, and simultaneously
on the head restraint itself.

)
To remove it, press on the
control D
to unlock it, then pull it
upwards.