73
2
Access
  For all work on the alarm system, contact a CITROËN dealer or aqualified workshop.  
 
 
 
 
 
 
Alarm *   System which protects and provides a deterrent against theft and break-ins. It provides the following types of monitoring:  
 
 
 
 
- perimeter 
 
The system checks for any opening of the vehicle. 
  The alarm is triggered if anyone tries to open adoor, the boot, the bonnet.... 
 
 
- volumetric 
 
The system checks for any variation in the 
volume in the passenger compartment. 
  The alarm is triggered if anyone breaks a
window, enters the passenger compar tment or moves inside the vehicle.
   
- tilt
 
The system checks for any change in theattitude of the vehicle.
  The alarm is triggered if the vehicle is lifted,moved or knocked.
 
 
Self-protection function
 
The system checks for the putting out of service of its components.
  The alarm is triggered if the battery, the centralcontrol or the siren wiring are put out of service 
or damaged.  
Locking the vehicle with full 
alarm system 
Activation
 ) 
 Switch off the ignition (OFF mode if your 
vehicle has the Keyless Entry and Star ting system). )    Remove the key from the ignition switch, 
if your vehicle does not have the "Keyless
Entry and Starting" system. )   Leave the vehicle, and close all the doorsand the bonnet.  ) 
  Press the locking button on the remote control or one of the door or boot buttons 
if your vehicle has the "Keyless Entry and Starting" system.
   Deactivation
 
Do one of the the following to deactivate thealarm: ) 
 Press the unlocking button on the remotecontrol or one of the door or boot buttonsif your vehicle has the "Keyless Entry andStarting" system. 
 ) 
  Switch on the ignition (ON mode if your 
vehicle has the "Keyless Entry andStarting" system).  )   Open a door or the boot while the system is being activated.  
 The alarm system is deactivated: the indicator 
lamp A 
 goes off.  
    The alarm is bein
g activated: the indicator 
lamp A   flashes rapidly accompanied byan intermittent audible signal for about 
20 seconds. 
 
Once the 20 seconds have expired,  the 
system is active  . The audible signal stops and 
the indicator lamp in the button flashes slowly.  
   
* 
  According to equipment. 
         
        
        75
2
Access
   
Tr iggering of the alarm
 
 
This is indicated by sounding of the siren andflashing of the direction indicators for thirtyseconds. 
 A message then appears in the instrument
panel screen while the siren is operating. 
  When the ignition is next switched on (ONmode if your vehicle has the "Keyless Entry and Starting" system), an audible signal sounds four 
times to inform you that the alarm was triggeredduring your absence.  
Complete deactivation of 
the alarm 
 ) 
 Switch off the ignition (OFF mode if your vehicle has the "Keyless Entry andStarting" system).  ) 
  Remove the key from the ignition switch, 
if your vehicle does not have the "Keyless
Entry and Star ting" system. )   Open the driver's door.  ) 
 Place the lighting control stalk in the "OFF"position.  ) 
  Pull the wiper control stalk towards you and
hold.  
After about ten seconds there is an audible signal. )    When the audible signal stops, continue to 
hold the wiper stalk pulled towards you and
press the remote control locking button. 
You can completely deactivate the alarm 
system. To do this, proceed as follows:
 )    The state of the system is then signalled to you by the number of beeps:   
 One beep: the alarm system is completely deactivated.
  Two beeps: the alarm system is activated.
  Each new press of the remote control 
lockin
g button changes the state of thesystem.
   It is possible to adjust the sensitivity 
of the alarm sensor and to deactivatethe function via the colour screen"Equipment" menu.