Page 123 of 332
121
4
Driving
The system is reactivated automatically at every new star t using the key or the STA R T/STOP button.
Reactivation
Press the "AS&G OFF"switch again.
The s
ystem is active again; this is confirmed by
the "AS &G O FF "
warning lamp going off in the
instrument panel or instrument panel screen.
Operating fault
In the event of a malfunction with the system,
the "AS&G OFF"warning lamp flashes in theinstrument panel or instrument panel screen,and the system no longer operates.
have it checked by a CITROËN dealer or a qualified workshop.
This system requires a specific battery with a special specification and technology (reference numbersavailable from a CITROËN dealer or a qualified workshop).
Fitting a battery not listed by CITROËN
introduces the risk o
f malfunction of the system.
Maintenance
The "Auto Stop & Go" system makes use of advanced technology. All work on this type of battery must be doneonly by a CITROËN dealer or a qualified workshop.
In the event o
f a fault in STOP mode, the
vehicle may stall. The following warning lampscome on in the instrument panel or instrumentpanel screen:
It is then necessar
y to switch off the ignition,
then restart the engine using the key or theSTA R T/STOP button.
Page 126 of 332
124
Driving
Cruise control
System which automatically maintains the vehicle speed at the value programmed by the driver, without any action on the accelerator pedal.
The cruise control is switched on
manually:
the vehicle speed must be at least 25 mph(40 km/h) and second gear or higher must be engaged in the case of a manual gearbox.
Th
e cruise control is switched offmanually, byfan action on the brake or clutch pedal or if theASC system is triggered.
The pro
grammed speed can be exceeded
temporarily by pressing the accelerator pedal.
The cruise control cannot, in any circumstances, take the place of the need to comply with speed limits or of the vigilance and responsibility of the driver. The controls o
f this system are grouped
together on the steering wheel.1."ON/OFF"
button: activation / deactivation of the cruise control mode.
2
."COAST SET"button: store a drivingspeed and decrease the cruising speed. 3."ACC RES"
button: increase the cruising speed and recall the stored speed.4."CANCEL"button: stop control of the
vehicle's speed.
Steering mounted controls
When you press button 1, the "CRUISE"indicator comes on in the instrument panel.
Display in the instrument panel
Programming
)Press button 1. )Set the programmed speed by accelerating to
the required speed, then press button 2 "COAST SET".
To return to the programmed speed, simply release the accelerator pedal.
Switching off the ignition cancels any programmed speed value.
Page 135 of 332
133
5
Visibility
Model with a rear foglamp only
rear foglamp
Rotate and release the rin
g C: ) forwards a first time to switch on the front foglamps, )
forwards a second time to switch on the rear foglamp, )
rearwards a first time to switch off the rear foglamp, )
rearwards a second time to switch of thefront foglamps.
In good or rainy weather, both dayand night, the front foglamps and the rear foglamps are prohibited. In these situations, the power of their beams
may dazzle other drivers.
Do not forget to switch off the front foglamps and the rear foglamps when they are no longer necessary.
Model with front foglamps anda rear foglamp
Foglamp selection ring
.
The
y operate if at least the sidelamps are on.
) To switch on the rear foglamp, turn the ring C
forwards. )
To switch off the rear foglamp, turn thering C
rearwards.
front and rear fo
glamps
Lighting on reminder
An audible signal when the driver's door is opened warns the driver if the vehiclelighting is on, with the ignition off.
Switching off the lighting stops theaudible signal.
Page 136 of 332
134
Visibility
The sensitivity of the automatic illuminationof headlamps can be configured via the colour screen "Equipment" menu.
In foggy weather or in snow, thesunshine sensor may detect sufficient light. The lighting will not come on automatically. Do not cover the sunshine sensor, the
associated functions will no longer becontrolled.
Automatic switching off
When the lighting control stalk is at "dipped or main beam headlamps", if the ignition switch
is at "LOCK" or "ACC" or if the key has been
removed from the ignition switch, the lamps switch off automatically when the driver's
door is opened .
Daytime running lamps
Daytime lighting which comes on automatically
when the engine is star ted making the vehicle
more visible to other users.
This
function is assured by special lamps.
The lighting control stalk must be placed in
position "0"
or "AU TO "(day mode).
Automatic illumination of headlamps
The sidelamps and the dipped beam headlamps come
on automatically, without any action on the par t of the
driver, if a low level of exterior light is detected or if the
wipers are switched on.
When the li
ght returns to a sufficient level or the wipers
are switched off, the lighting is switched off automatically.
The sensor is located at the base of the windscreen.
Contact a CITROËN dealer or a qualified workshop to
adjust the sensitivity of the sensor.
Page 137 of 332
135
5
Visibility
Switching off
The manual guide-me-home lighting switchesoff immediately if you.
- flash the headlamps again,
- place the lighting control stalk in another
position,
- switch the ignition on (or select "ON" mode
for vehicle with the "Keyless Entry and Starting" system).
Manual guide-me-home
lighting
Switching on
)
Place the lighting control stalk in the "OFF"
position, or "AUTO" for vehicles that have it. ) Place the ignition switch on "LOCK" and remove the key (or select "OFF" mode for
vehicles that have the "Keyless Entry andStarting" system). ) Within one minute after switching off the
ignition, "flash" the headlamps using the lighting control stalk.
The headlamps come on for around30 seconds. ) A further "headlamp flash" within 60 seconds of switching the ignition to OFF (or selection of "OFF" mode for vehicles
with the "Keyless Entry and Star ting" system) reactivates the function for a
further 30 seconds. Te m p o r a r i l
y keeping the dipped beam headlamps
on after the vehicle's ignition has been switched
o
ff makes the exit of the vehicle's occupants easier
when the light is poor.
The duration of the guide-me-home
lighting can be set in the colour screen"Equipment" menu.
Page 138 of 332
136
Visibility
Exterior welcome lighting Remote switching on of the lighting makes your approach to the vehicle easier in poor light.
It comes on when the vehicle is unlocked remotely.
Switching on
) Place the lighting control in
position "OFF" or "AUTO". ) Press the open padlock on the
remote control or the electronickey.
The sidelamps come on for about 30 seconds. For vehicles fitted
with automatic illumination of
headlamps, the welcome lightingonly comes on under conditions of low ambient light.
Switching off
The welcome lighting goes off immediately if:
- you press the open padlock on the remote control,
- you place the lighting control in another position,
- you switch on the ignition (or select "ON"
mode for vehicles fitted with the "Keyless
Entry and Star ting" system).
It is possible to choose the type of lamps switched on or to deactivate
the function via the colour screen"Equipment" menu.
Page 144 of 332
142
Visibility
Courtesy lamps
Front courtesy lamp
Position 1
The cour tesy lamp comes on when a door or
the tailgate is opened.
When the door or the tailgate is closed again,
the lighting gradually dims for a few seconds
before switching off.
However, the cour tesy lamp is switched off automatically in the following cases:
- When the doors and the tailgate are closedand the ignition switch is placed in the
"ON"
position.
- When the doors and the tailgate are closedand you lock the vehicle.
Position 2
The cour tesy lamp is permanently off.
There are two map reading lamps, one on eachside of the cour tesy lamp.
Press the corresponding lamp lens A.
Map reading lamps
The durations of lighting of the front courtesy lamps can be configured viathe colour screen "Equipment" menu.
Page 145 of 332
143
5
Visibility
Rear courtesy lamp
Position 1 "ON"
The cour tesy lamp is permanently on.
Position 2 "●"
The cour tesy lamp comes on when a door or
the tailgate is opened. When the door or the
tailgate is closed again, the lighting gradually
dims for a few seconds before switching off.
However, the cour tesy lamp is switched off immediately in the following cases:
- When the doors and the tailgate are closedand the ignition switch is placed in the"ON"
position.
- When the doors and the tailgate are closed
and you lock the vehicle.
Position 3 "OFF"
The cour tesy lamp is permanently off.
Courtesy lamps automatic
switch off
The duration of lighting of the rear courtesy lamps can be configured viathe colour screen "Equipment" menu. With the en
gine off, the cour tesy lamps,
map reading lamps and boot lamp switch off automatically after 30 minutes to prevent
discharging of the battery.
The cour tesy lamps are switched on again if
the ignition switch is placed in the "ON"
or "ACC"
position, if you open then close a door or the tailgate or if you use the remote control.
