2012 Citroen C1 RHD key battery

2
27 Access
Electronic engine immobiliser
Changing the remote
control battery
Reinitialising the remote
control
Following replacement of the remote control
batter
y or in the event of a remote control fault,it may be necessary to reinitialise the system. ) Switch off the ignition.)
Switch the ignition on again.)
Press one of the remote control buttons
immediately for a few seconds.) Switch off the ignition and remove the key
from the ignition lock.The remote control is now working again.
If the fault persists, contact a CITROËN dealer
or a qualified workshop.
Do not discard the remote control batteries, they contain metals which areharmful to the environment. Take them to a CITROËN dealership, or
to any other approved collection point. Driving with the doors locked may make
access to the passenger compar tment
by the emergency ser vices more
difficult in an emergency.
As a safety measure (with children on
board), remove the key from the ignition
when leaving the vehicle, even for a
shor t time.
Do not make any modifications to the
electronic immobiliser system.

To change the battery, remove the screw then
unclip the housing using a coin inser ted at the
rin
g.
Battery CR 2016/3 volts.
If the remote control does not work after thebattery has been changed, reinitialise it. The high frequency remote control is
a sensitive system; do not operate it
in your pockets as there is a risk that
it may unlock the vehicle without you
being aware of this.
Avoid pressing the buttons of your
remote control out of range of
your vehicle, you risk rendering it
inoperative. It would then have to be
reinitialised. This locks the engine management system as
soon as the ignition has been switched off and
therefore prevents star ting of the vehicle byanyone who does not have the key.
The ignition key has an electronic chip whichhas a special code. When the ignition is
switched on, the code must be recognised for
starting to be possible.
In the event of a malfunction, your vehicle willnot start.
Contact a CITROËN dealer or a qualifiedworkshop.

9
71 Practical information




















Changing a fuse
Good


Removing and fitting a fuse
Failed
Tweezer A
Th
ese are located on each side of the
instrument panel under the trim.
) If necessary, unlock the steering using the
key. ) Turn the steering wheel to the left, remove bolt B.
)
Turn the steering wheel to the right, removebolt C.


Always replace a failed fuse with a fuse of the same rating (same colour).


Instrument panel fuseboxes


The fuseboxes are located under the instrument panel trim and next to the battery in the engine compartment.

Before chan
ging a fuse, the cause of the
incident must be found and rectified. )Use the tweezer A located in the fusebox under the bonnet.

78Practical information
Before disconnecting the battery
Wait 2 minutes after switching off the ignition
before disconnecting the battery.
Close the windows and the doors before disconnecting the battery.


Following reconnection of thebattery

Following reconnection of the battery, switch on
the i
gnition and wait 1 minute before star ting to
permit initialisation of the electronic systems.However, if problems remain following this
operation, contact a CITROËN dealer or aqualified workshop.
Referring to the corresponding section, you
must yourself reinitialise:


- the remote control key,

- the audio system.

01
118
FIRST STEPS
With the ignition key in the accessories position or with the ignition on, press this button to switch the
audio equipment on or off.

You exit
from this mode automatically after a fewseconds without any action.










GENERAL FUNCTIONS

When the parameter is displayed, change thesetting using these two buttons.
Pr
ess this button several times in succession togain access to the bass (BASS)
, treble (TREB)
,
front / rear balance (FA D)and left / right balance(BAL) settings.
After the en
gine has been switched off, the audio equipmentcan only operate for approximately 30 minutes, to preventdischarging of the battery.
AUDIO SETTINGS
ON / OFF

Press the upper part o
f this button several times
in succession to increase the volume of theaudio system or the lower part of this button todecrease it.
VOLUME ADJUSTMENT

The audio s
ystem controls enable you to adjust the volume and the
audio settings.
T
o exit from the AUX
source, press AM/FM.
When using an MP3 player:
increase the volume of the radio signifi cantly (between 30 and 60) to obtain a satisfactory playing
volume.

In order to listen to it, connect
your equipment then press this button.
An auxiliary socket "AUX"
is provided for the connection of portable equipment (MP3 player, etc.).
AUXILIARY SOCKET

128Visual search
Exterior


Keys, remote control, locating the vehicle 4, 26
Remote control battery 27
Starting 4, 42

Opening the bonnet 84


To w i ng 80-81


Tyres, pressures 65, 92


Parking brake 48, 88
ABS (EBFD-CSC) 49
ASR/ESP 50

Fuel tank, filler cap,filling with fuel 5, 30
Fuel gauge 23


Mirrors 37
Roof bars 81

Opening/closing, locking/unlocking doors 28


Front lamps, foglamps 44
Direction indicators 45 Changing bulbs 67- 68
Adjusting the headlamps 46


Boot 29, 41
Spare wheel, jack, changing,fitting 41, 65 - 67


Rear lamps, foglamp 44
Changing bulbs 69
Number plate lamps, 3rd brake lamp,side repeaters 70

LED daytime running lamps 45