2012 Citroen C1 RHD brake

48Safety
Audible warning system to aler t other road
users to an imminent danger.)Press the central part of the steering
wheel. Press the button
, the direction indicators flash.
They can operate with the ignition off.
When the vehicle is being driven,illumination of this warning lamp indicates that the parking brake is still
on or has not been properly released.











Parking brake


Applying

Pull the parking brake to immobilise your
vehicle.

Releasing

Pull on the handle and press the button to
release the parking brake.





Horn
Hazard warning lamps
When parking on a slope, direct your wheels towards the pavement and
pull the parking brake on.
Use the horn moderately and only in the following circumstances:
- immediate danger, - approaching a location lacking visibility.

7
49 Safety





Emergency braking
assistance


In an emergency, this system enables you to
reach the optimum braking pressure morequickly and therefore reduce the stoppingdistance.
It is triggered by the speed at which the brake pedal is pressed. This is felt by a reduction in
the resistance of the pedal and an increase in
the effectiveness of the braking.
*
The CSC system is linked with the EBFD on
vehicles which are not fitted with ASR/ESP
systems.














Anti-lock braking system (ABS) and
braking systems (EBFD and CSC * )
The ABS, in conjunction with the EBFD and
CSC *
braking systems, increases the stability and manoeuvrability of your vehicle on brakingand provides improved control, in particular on poor or slippery road surfaces.
The ABS prevents wheel lock in the event of
emergency braking.
The EBFD and CSC * systems provide fullcontrol of the braking pressure wheel by wheel.A distribution between:
- the front and the rear in the case of the
EBFD (Electronic Brake Force Distribution),
- the left and the right in the case of theCSC * (Cornering Stability Control).


When changing wheels (tyres), make
sure that these are approved.

The anti-lock braking system comesinto operation automatically when thereis a risk of wheel lock.
When this warning lamp comes on,
it indicates that there is a fault with
the ABS, which could cause a loss of control of the vehicle when braking.
Contact a CITROËN dealer or a qualified
workshop.

When these warning lampscome on simultaneously,
it indicates that there is afault with the braking system or that the parkingbrake has not been released fully, which cancause a loss of control of the vehicle when
braking. You must stop as soon as it is safe to do so. Contact a CITROËN dealer or a qualified
workshop.
Normal operation of the ABS may make itself felt by slight vibrations of the brake pedal.
In emergency braking, pressvery firmly without releasing thepressure.

VSC
50Safety














Anti-slip regulation (ASR) and electronic
stability programme (ESP)


Operating check
Operation of the ASR and
ESP systems

When one of these two systems is
operating, this warning lamp comes on.
If a fault occurs with the s
ystems, this
warning lamp comes on.
Contact a CITROËN dealer or aqualified workshop to have thesystems checked.
These systems are linked and supplement
the AB
S.
The ASR system optimises drive to prevent the
wheels skidding, by acting on the brakes of the
driving wheels and on the engine. It also allows
the directional stability of the vehicle to be
improved on acceleration.
If there is a variation between the trajectory followed by the vehicle and that required by
the driver, the ESP system automatically acts on the brake of one or more wheels and on theengine to put the vehicle back on course, within
the limits of the laws of physics.
The ASR/ESP systems offer exceptional safety during normal driving, but this should not encourage the driver to take extra risks or drive athigh speed. Correct operation of these systemsdepends on obser vation of the manufacturer's recommendationsregarding the wheels (tyres and rims), thebraking components and the electronic components as well as the repair procedures use by a CITROËN dealer or qualified workshop.
After an impact, have these systemschecked by a CITROËN dealer or aqualified workshop.

9
65 Practical information
)As far as possible, immobilise the vehicle
on level, stable, non-slippery ground. )Apply the parking brake, switch off the
ignition and engage first gear or reverse
for the manual gearbox, position Nfor theelectronic gearbox. The followin
g tools are installed in a carrier,
located in the centre of the spare wheel:
1
. Wheelbrace 2.Jack with handle 3.Removable towing eye

Access to the spare wheel and
the jack in the boot
) Remove the carpet then the plastic cover using the handle.



Tyre pressures

These are indicated on the label positioned on the inner pillar of the left door, see
"Identification markings".



























Changing a wheel
)
If necessary, chock the wheel diagonally
opposite the wheel to be changed.) You must ensure that the occupants leave
the vehicle and wait in a safe location.

Parking the vehicle
To o l s

9
69 Practical information
Rear lamps
1.Brake lamps / sidelamps (P 21/5 W)2. Direction indicators (P 21 W)3.Reversing lamp (P 21 W), left-hand sideFoglamp (P 21 W), right-hand side
These 3 bulbs are changed by removing thelamp unit:) open the boot,)
unscrew the two lamp unit fixing nuts A , )
remove the lamp unit by pulling outwards, )
unclip the harness,
When refittin
g, proceed in the reverse order
and take care to position the bulb holder, the
tabs and the lamp unit correctly.
) remove the bulb holder by spreading the four tongues B
, )
remove the bulb and change it.

70Practical information
repeaters (WY 5 W amber)
Third brake lamp
(Four W 5 W bulbs) Number
plate
lamps (W 5 W)
Do not tighten the screws more than isnecessary, to avoid the risk of breaking
the lamp.
)Pass your hand under the bumper. )Remove the bulb holder turning it onequar ter of a turn.)Remove the bulb and change it.
)
Unscrew the 2 fixing screws A.)
Release the lamp unit by pushing the two
tabs Binwards.)
Disconnect the connector and the rear screen wash pipe.)
Remove the bulb holder.)
Remove the bulb and change it.
When refitting, proceed in the reverse order
and ensure that the lamp unit seal and the rear
screen wash pipe have been put back in place correctly.
)Push the repeater forwards or rearwardsand detach it by pulling towards you. )Disconnect the bulb holder and change it.

9
73 Practical information
*
Fuses located behind the instrument panel. To change them, contact a CITROËN dealer or a qualified workshop.
FuseN°Rating(A)Functions
110Brake lamps - ABS - Electronic gearbox
225Central locking/unlocking - Remote control
320Rear screen demisting
47.5Rear lamps - Number plate lamps - Instrument panel - Screen - headlamp adjustment - LED daytime runninglamps - Sidelamps
57.5Diagnostic socket
67.5Electronic gearbox - Rear foglamp - ESP - LED daytime running lamps - Instrument panel - Rev counter
7-Not used
87.5
ABS/ESP - Power steering - Fan assembly
910Reversing lamps - Central locking/unlocking - Electric windows - Rear screen demisting - Speedometer -Air conditioning - Heating - Rev counter - Remote control
1020Front and rear wipers and screenwash
1115
Audio equipment - 12 V socket (120 W max)
127.5
Heated rear screen - ABS - Fan assembly - Front and rear wipers and screenwash - Power steering - Central
locking/unlocking - Air conditioning - Heating - Electric windows - Speedometer - Rev counter - Remote control -Reversing lamp
1315
Airbag - Fuel injection system - Electronic gearbox - Instrument panel - Rev counter - LED daytime running lamps
147.5 Air conditioning - Heating
15 *40
Audio system - 12 V socket - Front and rear wipers - Power steering - ABS/ESP - Cooling fan assembly
16 * 30Electric windows
17 *40
Air conditioning - Heating

80Practical information





Towing the vehicle

Install the towing bar. )
Put the gear lever into neutral (position Nfor the electronic gearbox).
)Take the removable towing eye stowed in
the spare wheel, under the boot carpet.
)Unclip the plastic cover. )Fully screw in the towing eye.

General
recommendations
Observe the legislation in force in your country.Ensure that the weight of the towing vehicle is higher than that of the towedvehicle.The driver must stay at the wheel of thetowed vehicle. Driving on motorways and fast roads is prohibited when towing.When towing a vehicle with all four wheels on the ground, always use an approved towing bar; rope and straps are prohibited. When towing a vehicle with the engine off, there is no longer any power assistance for braking or steering.In the following cases, you must always call on a professional recovery service:- vehicle broken down on a motor way
or fast road,- when it is not possible to put the gearbox into neutral, unlock thesteering, or release the parkingbrake,- towing with only two wheels on theground, - where there is no approved towingbar available...

Your vehicle can only be towed at the front.
Never use the radiator crossmember.
To w i ng with fours wheels on theroad must be carried out at very low speed over a very shor t distance (in accordance with the legislation in force).
In all other cases, your vehicle must betranspor ted on a trailer.

Failure to obser ve this instruction maylead to damage to cer tain components (braking, transmission, ...) andthe absence of braking assistance whenthe engine is started.
)
Unlock the steering by turning the key to
the first position and release the parkingbrake. ) Switch on the hazard warning lamps onboth vehicles.