2012 Citroen C1 belt

.
.
Contents
Horn 48
Hazard warning lamps 48
Parking brake 48
Emergency braking assistance 49
ABS, EBFD, CSC systems 49
ASR and ESP systems 50
Seat belts 51
Airbags 54
Safety
Rev counter 19
Instrument panel 19
Warning lamps 20
Distance recorder 23
Indicators 23
Setting the time 25
Monitoring Familiarisation
Keys / Remote control 26
Doors 28
Electric windows 28
Rear windows 29
Boot 29
Fuel tank 30
Access
Ventilation 33
Heating 34
Air conditioning 35
Mirrors 37
Steering wheel adjustment 37
Front seats 38
Rear seats 39
Comfort Eco-driving
Interior fi ttings 40
Boot fi ttings 41
Fittings
Electronic gearbox 42
Driving
Lighting control stalk 44
LED daytime running lamps 45
Headlamp adjustment 46
Courtesy lamp 46
Windscreen wiper stalk 47
Visibility

.Familiarisation
15
Your vehicle has been approved in accordancewith the new ISOFIX regulation.
The rear seats are fitted with regulation ISOFIX
mountings.
These are three rings for each seat:
- two lower rings A , located between the
vehicle's seat back and cushion,- an upper ring B
, referred to as the TOP TETHER, located at the rear of the seat back at the bottom.
The ISOFIX child seats
are fitted with two
latches and/or a strap which are secured easily on these rings, indicated by labels or a mark on
the rear seat back panel.


Passenger's airbag deactivated
If the passenger's airbag is deactivated,
this warning lamp remains on until thepassenger's airbag is reactivated.

Front seat belt(s) not fastened /
unfastened warning lamp
1.
Inser t the key. 2.Select the "OFF"
position .3.Remove the key in the OFF position.
When the ignition is switched on, the
warning lamp flashes if the driver and/or front passenger has not fastened their seat belt.
The warning lamp flashes when the driver
and/or front passenger unfastens their seat belt
with the engine running.
Safety


Passenger's airbag
deactivation"ISOFIX" mountin
gs
556
2
52

P/S
Monitoring
22



Deactivating
the passenger's airbag
fixed. The passen
ger's airbag control
is set to the OFF
position.
The passen
ger's front airbag is deactivated.
In this case you can install a
"rear facing" child seat.
Set the control to the ON
position to activate the passenger's
front airbag. In this case, do not fit a child seat in the rear-facing position.



Battery charge

fixed. The battery charging circuit has
a fault (dirty or loose terminals, slack or cut alternator belt, ...). The warnin
g lamp should go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a qualified workshop.

Electric power steering
fixed. The electric power steering has a fault. Drive carefull
y at reduced speed.
Have it checked by a CITROËN dealer or qualified workshop.



Front seat beltnot fastened /
unfastened(depending on version)

flashing, then above
12 mph (20 km/h),
accompanied b
y an
audible signal.
The driver and/or front
passenger has not fastened or has unfastened their seat belt. Pull the strap then inser t the tongue in the buckle.



Emissioncontrolsystem fixed. The emission control system has a fault. This lamp should
go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a qualified workshop without delay.

Electronicgearbox
fixed. The electronic gearbox has a
fault. Contact a CITROËN dealer or a qualified workshop without
delay.
Warning lampis onCauseAction/Observations

38Comfort








Front seats

Push control A rear wards while adjusting the
angle of the seat back.
Raise the control and slide the seat forwards or backwards.
Position the seat belt along the door pillar.
Push control A
rearwards to fold the seat back and move the seat forwards.
To put the seat back in place, push the seat
back until the seat locks.
Reset the for wards-backwards adjustment of
the seat and the seat back angle.
No person or object must prevent the seat from returning to the required
position.
1. Forwards-backwardsadjustment

2. Seat back angle adjustment 3. Access to the rear seats (3-door)

3
39 Comfort











Rear seats
it on mounting B . Take care not to trap the seat belts, inpar ticular between the seat back and themounting B.Check that the backrest has engaged correctly.
The rear head restraints can be removed andhave two positions:


- high, position for use.

- low, storage position.
Th
e seat backrest is folded from the rear of the
vehicle, with the boot open:


- check that the seat belt is positioned
correctly on the side of the seat back toavoid damaging it,

- place the head restraints in the low position(see "rear head restraints"),

- while folding the seat backrest, pull thestrap(s) A
, located behind the seat back.
Rear head restraints *


To raise the head restraint, pull it upwards.
To lower it, press lug Athen the head restraint.
To remove it:


- tilt the seat back slightly,

- move the head restraint to the highposition,

- press lug A
pulling the head restraint
upwards at the same time.


T
o refit it:


- tilt the seat back slightly,

- engage the rods of the head restraint in the
openings.

*
Dependin
g on version.
To reach the low position, press lug A.


Folding the backrest of the
bench seat
Returning the backrest of the
bench seat to its initial position

7
51 Safety











Seat belts



3-door



5-door

The rear seats are equipped with two three-point inertia reel seat belts.
Yo u can store the seat belt buckles in the housing A.
Pull the strap, then inser t the buckle into thestalk.
Check that the seat belt is fastened correctly bypulling the strap.
To unfasten the seat belts, press the button on
th
e stalk.

Pretensioning front seat belts with force limiter

Safety in the event of front impactshas been improved by means of theintroduction of pretensioning seat beltswith force limiter for the front seats.Depending on the force of the impact, the pretensioning system instantly tightens the seat belts and pulls them against the body of the occupants.
The pretensioning seat belts are activewhen the ignition is on.
The force limiter reduces the pressure of the seat belt on the chest of the occupant, increasing their protection.


Fastening/Unfastening the seatbelts

52Safety
Front seat belts(s) not fastened /
unfastened warning lamp *
Not fastened
Unfastened
When the ignition is switched on, the
warning lamp flashes if the driver
and
/or front passenger has not fastened their seat belt.
Above a speed of about 12 mph (20 km/h) and for two minutes, the warning lamp flashes accompanied by an increasing audible signal.
After these two minutes, the warning lampcontinues to flash but without the audiblesignal, if the driver and/or front passenger hasnot fastened their seat belt.
The warnin
g lamp flashes when the
driver and/or the front passenger unfastens their seat belt with the engine running.
Above a speed of about 12 mph (20 km/h) and for two minutes, the warning lamp flashes accompanied by an increasing audible signal.
After these two minutes, the warning lampcontinues to flash but without the audiblesignal, if the driver and/or front passenger has
not fastened their seat belt.

*
Dependin
g on version.

7
53 Safety

*
According to model.
The driver must ensure that thepassengers use the seat belts correctly and that they are all properly restrainedbefore setting off. Wherever you are seated in the vehicle,always fasten your seat belt, even for shor t journeys. Do not invert the seat belt buckles as they will not fulfil their role fully. If the seats have armrests * , the lap par tof the seat belt must always pass under the armrest.The seat belts are fitted with an inertia reel permitting automatic adjustment of the length of the strap to your size. The seat belt is stored automatically when notin use.Before and after use, ensure that theseat belt is reeled in correctly.The lower part of the strap must be positioned as low as possible on the pelvis. The upper par t must be positioned in the hollow of the shoulder.
The inertia reels are fitted with an automaticlocking device which comes into operation in the event of a collision, on emergency braking or if the vehicle rolls over. You can release the device by pulling rapidly on the strap and releasing it.
In order to be effective, a seat belt: - must be tightened as close to the body as
possible, - must restrain one adult only, - must not bear any trace of cuts or fraying,- must be pulled in front of you with asmooth movement, checking that it doesnot twist, - must not be transformed or modified to avoid altering its performance.In accordance with current safety regulations, all repairs and checks must be carried out bya CITROËN dealer who can guarantee thatthe work is carried out correctly, or qualifiedworkshop. Have your seat belts checked regularly by a CITROËN dealer or a qualified workshop and particularly if the straps show signs of damage.Clean the seat belt straps with soapy water or a textile cleaning product, sold by CITROËN dealers.
After folding or moving a seat or rear bench seat, ensure that the seat belt is positioned and rolled up correctly.


Recommendations for children:



- use a suitable child seat if the passenger isless than 12 years old or shor ter than one metre fifty,

- do not use the strap-guide *
when a child seat is installed.

- never use the same seat belt to securemore than one person,

- never allow a child to travel on your lap.Depending on the nature and seriousnessof the impacts, the pre-tensioning device may be triggered before and independently of theair bags. Triggering of the pre-tensioners is accompanied by a slight emission of harmless smoke and a noise, due to the activation of the pyrotechnic cartridge incorporated in the system.
In all cases, the airbag warning lamp comes on.
Following an impact, have the seat beltssystem checked, and if necessary replaced, by a CITROËN dealer or a qualifiedworkshop.