Page 9 of 140
.Familiarisation
7
1. Bonnet release2.Headlamp adjustment 3.Passenger's airbag deactivation4.Adjustable side air vent
5.Lighting and direction indicator stalk
6. Driver's front airbag
Horn
7.Dashboard fusebox (under the instrument
panel trim, on the right and on the left)8. Rev counter 9.Passenger's door mirror control
10. Steering mounted controls for the electronic gearbox11.
Passenger's electric window control12 .
Gear lever
13.Cup holder
14. Steering wheel height adjustment
Instruments and controls
Page 13 of 140
.
OFF
Familiarisation
11
Lighting stalk
Front and rear lamps
Ring A
Lighting off.
Sidelamps.
Dipped / Main beam headlamps.
Rear foglamp
Ring B
Front foglamps and rear foglamp
Ring C
Wiper control stalk
Windscreen wipers
MIST
Single wipe.
OFF
Off. INT
Intermittent wipe. LO Normal wipe (moderate rain).
HIRapid wipe (heavy rain).
Rear wiper and rear screenwash
Ring C
Seeing clearly
44
47
Page 32 of 140
30Access
Fuel tank
)
Open the fuel filler flap. )
Inser t the key in the filler cap, turn it slightly
to the left and then return to the right.
The key returns to its initial position and the filler cap is then unlocked.
Low fuel level
When the low fuel level is reached,
the last bar
flashes, accompanied byan audible signal.
You have approximately 5 litres remaining.In cer tain driving conditions and depending on
the engine, the distance which can be travelled
with the fuel remaining may be less than30 miles (50 km).
When the frequency of the flashing increases, you have approximately 3 litres remaining. )Unscrew the cap with the key.
)Hang the filler cap on the bracket, located
on the inner face of the filler flap.
A label affixed on the inside of the flap reminds you which type of fuel to use.
When you fill the fuel tank, do not continue after
the 3rd cut-off of the pump. This could cause
malfunctions.
The capacity of the fuel tank isapproximately 35 litres. )After filling the fuel tank, screw the cap
back on fully to the right until it clicks
thenclose the flap.
The fuel tank must be filled with theengine switched off.
f
If you run out of fuel, the emissioncontrol system warning lamp may come on in the instrument panel. It will go off
automatically after the engine has been started a few times.
Page 36 of 140
34Comfort
Heating
1. Temperature adjustment
Turn the control from blue (cold) to red(hot) to adjust the temperature to suit your requirements.
2. Air fl ow adjustment
When the ignition is switched on, turn the control to obtain a flow of air which is sufficient
to ensure your comfort.
To maintain a certain level of comfort in thepassenger compar tment, avoid position 0whenever possible.
In position 0, a slight flow of air, due to themovement of the vehicle, can still be felt. Win
dscreen and side windows.
4. Rear screen demisting
With the engine running, press button 4
, the indicator lamp comes on.
The system demists the rear screen.
It is switched off by pressing control 4.
3. Air distribution adjustment
Footwells, diffusion grille and side
vents.
Di
ffusion grille and side vents.
Demisting and defrosting
To quickly demist or defrost the windscreen and side windows:
- set the air distribution to "Windscreen and side windows",
- place the temperature control 1
and the air
fl
ow control 2at maximum,
- close the side vents.
The air distribution can be adjusted byplacing the control in an intermediate
position.
Switch the system off as soon as you consider this necessary as a lower consumption of current reduces fuel consumption.
Windscreen, side windows and
f
ootwells.
Footwells.
Page 41 of 140
3
39 Comfort
Rear seats
it on mounting B . Take care not to trap the seat belts, inpar ticular between the seat back and themounting B.Check that the backrest has engaged correctly.
The rear head restraints can be removed andhave two positions:
- high, position for use.
- low, storage position.
Th
e seat backrest is folded from the rear of the
vehicle, with the boot open:
- check that the seat belt is positioned
correctly on the side of the seat back toavoid damaging it,
- place the head restraints in the low position(see "rear head restraints"),
- while folding the seat backrest, pull thestrap(s) A
, located behind the seat back.
Rear head restraints *
To raise the head restraint, pull it upwards.
To lower it, press lug Athen the head restraint.
To remove it:
- tilt the seat back slightly,
- move the head restraint to the highposition,
- press lug A
pulling the head restraint
upwards at the same time.
T
o refit it:
- tilt the seat back slightly,
- engage the rods of the head restraint in the
openings.
*
Dependin
g on version.
To reach the low position, press lug A.
Folding the backrest of the
bench seat
Returning the backrest of the
bench seat to its initial position
Page 43 of 140
4
41 Fittings
In order to obtain additional space,the spare wheel can be removed temporarily (boot tray available as anaccessory).
Boot fi ttings
1. Rear parcel shelf
To remove the shelf:
- unhook the shelf from its fixing A,
- pull upwards on each side to detach it from
its fixings,
- raise then tilt the shelf slightly to remove it. There are two shel
f storage options:
- either behind the rear seats,
- or flat in the boot. Located under the carpet and a plastic cover,
this contains the tools for wheel chan
ging and
towing.
2. Spare wheel / Additional
storage compartments
Page 46 of 140
OFF
44Visibility
Lighting control stalk
Lamps off
2
.Sidelamps
3. Dipped beam / Main beam
headlamps
Dipped beam / Main beam
headlam
ps
Dipped beam headlamps: pull the stalk.
Main beam headlamps:
push the stalk.
Lighting on audible warning
When the driver's door is opened with the
ignition off, a continuous audible signal is heard
if you have left your lighting on.
Headlamp flash
Pull the stalk fully towards you.
Selection is b
y rotation of ring A.
Front foglamps and rear
fo
glamp
)Turn the ring B forwards to turn it on. )Turn the ring B
rearwards to switch it off.
Vehicles fi tted with a rear
foglamp only (ring B)
In clear weather or in rain, both day andnight, the front foglamps and the rear foglamp are dazzling and their use is prohibited.
Do not forget to switch them off whenthey are no longer needed.
The rear foglamp only operates if the dipped beam / main beam headlampsare on.
Page 47 of 140
6
45 Visibility
LED daytime running lamps *
On starting the vehicle, the LED daytime running lamps come on automatically, if the lighting stalk is in the OFFposition.
If the sidelamps and headlamps are switched on manually or automatically, the LED lamps switch off.
Deactivation/activation
Vehicles fi tted with front
foglamps and a rear foglamp (ring C)
Turn the ring C
: )forwards a 1 st
time to switch on the front
foglamps, )forwards a 2nd time to switch on the rear foglamp, )rearwards a 1 sttime to switch off the rear foglamp, )rearwards a 2nd
time to switch of the frontfoglamps.
Direction indicators
Left:
stalk downwards. Right:
stalk upwards.
The front foglamps only operate if thesidelamps or dipped beam / main beamheadlamps are on. The rear foglamp only operates if the front foglamps are on.
In countries where exterior lighting by day is nota legal requirement, it is possible to deactivate
the function in the following way.
- Engine stopped, lighting off and parking brake applied, switch on the ignition (key in
the Running position (2nd notch)).
- Within a period of 5 seconds, turn the
lighting control stalk ring Afrom the OFF
position to the Sidelamps
position thenreturn to the OFF
position three times.
An audible signal con
firms the deactivation of
the daytime running lamps.
*
LED: li
ght-emitting diodes.
In countries where daytime running lamps are required by law, this "Daytimerunning lamps" function is alwaysactivated by default and must not dedeactivated.
To reactivate the daytime running lamps, repeat this procedure. An audible signal confirms the
reactivation of the daytime running lamps.
