2012 Citroen BERLINGO RHD check engine light

oil capacity gas tank size flat tire radio controls warning light refuelling

Page 32 of 208

Citroen BERLINGO RHD 2012 2.G Owners Manual 30
Instruments and controls

Warning lamp

is

indicates

Solution - action

Coolant
temperature
and level
on with needle
in the red
zone. an abnormal increase in
te

Page 40 of 208

Citroen BERLINGO RHD 2012 2.G Owners Manual 38
Instruments and controls

Trip recorder
zero reset button
After this operation, if you wish to
disconnect the battery, lock the
vehicle and wait for at least ﬁ ve
minutes, otherwise the

38
Instruments and controls

Trip recorder
zero reset button
After this operation, if you wish to
disconnect the battery, lock the
vehicle and wait for at least ﬁ ve
minutes, otherwise the zero re-set will
not be registered.

Zero re-set

Your CITROËN dealer or a qualiﬁ ed
workshop carries out this operation
after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:

- switch off the ignition,

- press and hold the trip recorder
reset button,

- switch on the ignition.
The display begins a countdown.
When the display shows "=0"
, release
the button; the spanner disappears.

Engine oil level indicator

When the ignition is switched on, the
engine oil level is indicated for a few
seconds, after the service information.
Oil level correct

Low oil level
Flashing of "OIL"
,
linked with the
service warning lamp,
accompanied by an
audible signal and a message in the
screen, indicates a low oil level which
could damage the engine.
If the low oil level is conﬁ rmed by a
check using the dipstick, it is essential
that the level is topped up.

Oil level gauge fault
Flashing of "OIL--"

indicates a
malfunction of the
engine oil level
indicator. Contact a CITROËN dealer
or a qualiﬁ ed workshop.
The level read will only be correct
if the vehicle is on level ground
and the engine has been off for
more than 30 minutes.
Dipstick

A
= maximum, never exceed
this level as a surplus of oil
may damage the engine.
Contact a CITROËN dealer
or a qualiﬁ ed workshop
without delay.

B
= minimum, top up the level
via the oil ﬁ ller cap, using the
grade of oil suited to your
engine.

With the lighting on,
press the button to vary
the brightness of the
instruments and controls.
When the lighting reaches
the minimum
(or maximum) setting,
release the button then press it again
to increase (or reduce) the brightness.
As soon as the lighting is of the
required brightness, release the button. With the ignition on, press
the button until the zeros
appear.

Lighting dimmer

Page 110 of 208

Citroen BERLINGO RHD 2012 2.G Owners Manual 108

Levels

Cooling system

Only use the ﬂ uid recommended by the
manufacturer.
Otherwise, you risk seriously damaging
your engine.
When the engine is warm, the
temperature o

108

Levels

Cooling system

Only use the ﬂ uid recommended by the
manufacturer.
Otherwise, you risk seriously damaging
your engine.
When the engine is warm, the
temperature of the coolant is controlled
by the engine fan. As this fan can
operate with the ignition key removed
and because the cooling system is
pressurised, wait for at least one hour
after the engine has stopped before
carrying out any work.
Slacken the cap by 1/4 of a turn to
release the pressure to prevent any
risk of scalding. When the pressure
has dropped, remove the cap and top
up the level with coolant.
If ﬂ uid has to be added frequently,
this indicates a fault which must be
checked by a CITROËN dealer as
soon as possible.

Power steering fluid level

The vehicle must be parked on level
ground with the engine cold. Unscrew
the cap integrated with the gauge and
check the level which must be between
the MIN and MAX marks. In order to regenerate the ﬁ lter, you
are advised to drive at a speed higher
than 40 mph (60 km/h) for at least ﬁ ve
minutes as soon as possible, when
trafﬁ c conditions permit (until the
message disappears and the service
warning lamp goes off).
During regeneration of the particle
emission ﬁ lter, the noise of a relay
operating may be heard under the
dashboard.
If the message is still displayed and
if the service warning lamp remains
on, consult a CITROËN dealer or a
qualiﬁ ed workshop.

Topping up
The level must be between the MIN
and MAX marks on the expansion
bottle. If more than 1 litre of ﬂ uid is
required to top up the level, have the
system checked by a CITROËN dealer
or a qualiﬁ ed workshop.

Screenwash and headlamp
wash level
For best quality cleaning and for your
safety, we would advise that you use
products of the CITROËN range.
For optimum cleaning and to avoid
freezing, this ﬂ uid must not be topped
up or replaced with plain water.
Capacity of the screenwash reservoir:
approximately 3 litres.
If your vehicle is ﬁ tted with headlamp
washers, the capacity of the reservoir
is 6 litres.

Diesel additive level
(Diesel with particle
emission filter)

Topping up
This additive must be topped up by
a CITROËN dealer or a qualiﬁ ed
workshop without delay.

Waste products

Avoid prolonged contact of used oil
with the skin.
Brake ﬂ uid is harmful to health and
very corrosive.
Do not dispose of used oil, brake ﬂ uid
or coolant into drains or into the ground
but into the containers dedicated to this
use at CITROËN dealer (France) or an
authorised waste disposal site. The minimum level of this additive
is indicated by lighting of the service
warning lamp, accompanied by an
audible signal and a message in the
screen.
When this occurs with the engine
running it is due to the start of
saturation of the particle emission ﬁ lter
(exceptionally prolonged urban type
driving conditions: low speed, long
trafﬁ c jams, ...).

Page 205 of 208

Citroen BERLINGO RHD 2012 2.G Owners Manual 143

Technical data - Maintenance

VISUAL SEARCH
10

TECHNICAL DATA - MAINTENANCE

Identiﬁ cation markings,
serial number,
paint code, tyres 138

Windscreen / headlamp wash,
lev

fuel filter warning light low oil pressure fuses trip computer lights