2012 Citroen BERLINGO FIRST oil level

MONITORING and DISPLAY SCREENS
20 -


1.
Seat belt not fastened warning
lamp

2.
Passenger's airbag deactivated
warning lamp

3.
Front and lateral airbags warning
lamp

4.
Front foglamps warning lamp

5.
Anti-lock braking system (ABS)
warning lamp

6.
Rear foglamp warning lamp

7.
Diesel pre-heater warning lamp

8.
Left hand direction indicator
9.
Total distance recorder, service
indicator and engine oil level
indicator

10.
Right hand direction indicator

11 .
Emission control system warning
lamp

12.
Main beam headlamps warning
lamp

13.
Parking brake, low brake fl uid
level and electronic brake force
distribution fault warning lamp

14.
Dipped beam headlamps
warning lamp

15.
Battery charge warning lamp

16.
Engine oil pressure and
temperature warning lamp
17.
Water in Diesel fi lter warning
lamp

18.
Low coolant level warning lamp

19.
Coolant temperature indicator

20.
Total distance recorder button

21.
Central (STOP) warning lamp

22.
Speedometer *

23.
Rev counter

24.
Lighting dimmer button

25.
Fuel gauge

26.
Low fuel level warning lamp

27.
Speed limiter/cruise control
screen

INSTRUMENT PANEL: PETROL - DIESEL


*
Version indicating in miles or kilo-
metres according to country of sale.

21MONITORING and DISPLAY SCREENS
-
MONITORING OPERATION


A warning lamp on fi xed or fl ash-
ing, with the engine running, in-
dicates an fault in the operation
of the unit concerned. The illumi-
nation of certain warning lamps
may be accompanied by an audi-
ble signal and a message in the
screen. Do not ignore this warn-
ing: consult a
CITROËN dealer as
soon as possible.


If the central STOP warning lamp
comes on when you are driving,
stop your vehicle immediately,
where it is safe to do so.



Central (STOP)
warning lamp
Engine oil pressure
and temperature
warning lamp
Linked to the central (STOP) warning
lamp.

You must stop.

This warning lamp indicates one of
the following:


- low oil pressure indicated by the
message "Oil pressure insuffi -
cient"
in the screen.

- low engine oil level. Top up the
level.

- oil temperature too high. To lower
the oil temperature, reduce your
speed.
Illumination of the warning lamp is
accompanied by an audible signal.
Consult a CITROËN dealer.


Low engine coolant
level warning lamp
Linked to the central (STOP) warn-
ing lamp.
This comes on for a few seconds
when the ignition is switched on.
Illumination of this warning lamp is
accompanied by an audible signal
and the message "Top up engine
fl uid level"
in the screen.

You must stop as soon as it is safe
to do so.

Wait for the engine to cool before
topping up the level.
The cooling system is pressurised.



Parking brake, low
brake fluid level and
Electronic Brake Force
Distribution system
fault warning lamp
Linked to the central (STOP) warning
lamp.
This comes on each time the ignition
is switched on.
Illumination of this warning lamp is
accompanied by an audible signal
and a message in the screen indicat-
ing the cause of the warning:


- "Handbrake on",
if the parking
brake is applied or not fully re-
leased.

- "Brake fl uid level low"
if there is
an excessive drop in brake fl uid
level (if the warning lamp remains
on even when the parking brake
is released).

- "Braking fault"
is displayed to-
gether with the ABS warning
lamp, indicating a fault with the
Electronic Brake Force Distribu-
tion system. You must stop as
soon as it is safe to do so.


Consult a CITROËN dealer. If a check is required, to prevent any
risk of burns
unscrew the cap by
two turns to allow the pressure to drop.
When the pressure has dropped, re-
move the cap and top up the level.
Consult a CITROËN dealer.
Linked to the warning lamps for:


- ''engine oil pressure and temper-
ature'',

- "low coolant level'',

- "parking brake'',

- ''low brake fl uid level'',

- ''electronic brake force distribution
system fault''.
Linked with the "coolant temperature"
gauge.

You must stop if the lamp fl ashes
with the engine running.

Consult a CITROËN dealer.

MONITORING and DISPLAY SCREENS
24 -

Service indicator

This is a visual reminder of when the
next service is due. This service is to
be carried out according to the manu-
facturer's servicing schedule. 5 seconds after the ignition is
switched on, the total distance re-
corder resumes normal operation
and the screen shows the total or trip
distances.

The distance remaining before the
next service is less than 1 000 km
(600 miles).

Example:
900 km (560 miles) remain
before the next service is due.
When switching on the ignition and
for 5 seconds, the screen shows:
5 seconds after the ignition is
switched on, the total distance re-
corder resumes normal operation
and the symbol remains on.
This indicates that a service should
be carried out shortly. The screen
shows the total or trip distances.
The service is overdue.
Each time the ignition is switched on
and for 5 seconds, the symbol and
the excess distance fl ash.

Example:
the service is overdue
by 300 km (186 miles). The service
should be carried out very shortly.
When the ignition is switched on and
for 5 seconds, the display shows:
5 seconds after the ignition is switched
on, the total distance recorder resumes
normal operation and the symbol re-
mains on. The screen shows the total
or trip distances.

Note:
the spanner comes on if the
two-year interval has been exceeded.


INSTRUMENT PANEL DISPLAY

After switching on the ignition, three
functions are shown in succession:


- service indicator,

- engine oil level indicator,

- total distance recorder/total and
trip distances.

Note
: the total and trip distances are
displayed for 30 seconds when the
ignition is switched off, on opening
the driver's door, as well as on lock-
ing and unlocking the vehicle.

Example:
4 800 km (2 980 miles) re-
main before the next service is due.
When the ignition comes on and for
5 seconds the display shows:
Operation
As soon as the ignition is switched on
and for 5 seconds, the spanner sym-
bolising ''service operation'' comes
on. The trip recorder display shows
the distance remaining (in round fi g-
ures) before the next service.

25MONITORING and DISPLAY SCREENS
-

Engine oil level indicator

When the ignition is switched on,
the engine oil level is indicated for
approximately 10 seconds, after the
service information.
Flashing of the six squares and the
display of "max" indicate that the oil
level is too high, which could damage
the engine.
If the excess oil is confi rmed by a
check using the dipstick, contact a
CITROËN dealer without delay. Your CITROËN dealer carries out
this operation after each service.
The reset procedure is as follows:


- Switch off the ignition.

- Press and hold button 1
.

- Switch on the ignition.
The display begins a 10 second
countdown.


- Keep button 1
pressed for 10 sec-
onds.
The display shows [=0]
and the span-
ner disappears.
Flashing of the six bars and the dis-
play of "min" indicate that the oil level
is too low, which could damage the
engine.
If the lack of oil is confi rmed by a
check using the dipstick, it is essential
that the level is topped up. Flashing of the six bars indicates a
malfunction of the oil level indicator.
There is a risk of damage to the engine.
Consult a CITROËN dealer.

The level read on the dipstick or on
the indicator will only be correct if
the vehicle is on level ground and
the engine has been off for more
than 30 minutes.




Resetting the service indicator

Oil level too high

Oil level too low
Oil level indicator fault

77 PRACTICAL INFORMATION
-
CHECKING LEVELS

Dipstick

Oil change
According to the information given in
the servicing booklet.
Viscosity selection
In all cases, the oil selected must
meet the manufacturer's require-
ments.

Note:
the coolant does not need to
be changed.

For vehicles equipped with a par-
ticle fi lter, the engine fan may op-
erate after the ignition has been
switched off, even when the engine
is cold.

There are two marks
on the dipstick:

A
= maximum
Never fi ll past this
mark.

B
= minimum
To maintain the reli-
ability of engines and
emission control sys-
tems, the use of ad-
ditives in engine oil is
prohibited.


Brake fluid level

The brake fl uid must be changed ac-
cording to the manufacturer's servic-
ing schedule.
Use fl uids recommended by the
manufacturer, which fulfi l DOT4
standards.


Cooling system

Use the fl uid recommended by the
manufacturer.
When the engine is warm, the tem-
perature of the coolant is controlled
by the engine fan. As this fan can op-
erate with the ignition key removed
and because the cooling system is
pressurised, wait for at least one hour
after the engine has stopped before
carrying out any work.
Slacken the cap by two turns to re-
lease the pressure to prevent any
risk of scalding. When the pressure
has dropped, remove the cap and
top up the level.

Power steering reservoir



)
Open the reservoir, with the en-
gine at ambient temperature. The
level should always be above the
MIN. mark and close to the MAX.
mark.



Windscreen and headlamp
wash level
For best quality cleaning and for
your safety, we would advise that
you use products recommended by
CITROËN.
For optimum cleaning and to prevent
freezing, this fl uid must not be topped
up or replaced with water.


Used products

Avoid products such as used oil and
brake fl uid coming into prolonged
contact with the skin.
Do not dispose of used oil, brake fl uid or
coolant into drains or onto the ground.
Empty used oil into the containers pro-
vided for this purpose in the CITROËN
dealer network (France) or to an author-
ised waste disposal site.


Oil level

It is normal to top up the engine oil
between services. CITROËN rec-
ommends that you check the oil
level, and top up if necessary, every
3 000 miles (5 000 kilometres).
Check the level with the vehicle level,
engine cold, using the oil level gauge
on the instrument panel or the dip-
stick.

PRACTICAL INFORMATION
78 -
CHECKS
Oil filter

Change the fi lter regularly, in accord-
ance with the servicing schedule.
Only use products recom-
mended by CITROËN or
products of equivalent quality
and specifi cations.
To ensure best performance from
components as important as the
power steering and the braking sys-
tem, CITROËN selects and offers
quite specifi c products.
To prevent damage to the electrical
units, avoid washing the engine.
RUNNING OUT OF FUEL (DIESEL)

If you should run out of fuel, it is nec-
essary to re-prime the circuit:


- fi ll the fuel tank with at least fi ve litres
of diesel,

- squeeze and release the manual
re-priming pump, under the bonnet
under the protective cover, until fuel
appears in the transparent pipe,

- operate the starter until the engine
starts.
FUEL SUPPLY CUT-OFF(PETROL)

In a serious collision, a mechanism prevents
fuel from reaching the engine.
To re-establish the fuel supply, press
the switch on the corner of the front
right-hand suspension assembly, under
the bonnet.


Air filter and passenger
compartment filter
Have the fi lter elements replaced regu-
larly. If you drive in dusty conditions,
change them twice as often.



Brake pads

Brake pad wear depends on the style
of driving, in particular for vehicles
which are used in town, over short
distances.
It may be necessary to check the
thickness of the pads, even between
services.


Disc and drum wear status

For any information relating to check-
ing the disc and drum wear status,
contact a CITROËN dealer.


Manual gearbox

This does not require an oil change.
Check the level in accordance with the
manufacturer's servicing schedule.

To check the main levels and cer-
tain components, in accordance
with the manufacturer's servicing
schedule, refer to the pages of
the servicing booklet which corre-
spond to your vehicle's engine.



Handbrake

Where the handbrake travel is too
great or there is a reduction in the
performance of the system, the
handbrake should be adjusted, even
between services.
Have the system checked by a
CITROËN dealer.


Battery

At the start of winter, have your battery
checked by a CITROËN dealer.

VISUAL INDEX122 -

TECHNICAL DATA - MAINTENANCE

Levels ..............................72-75, 77


- dipstick,

- power steering fl uid,

- brake fl uid,

- coolant.
Petrol supply cut-off, Diesel fuel
priming ..................................... 78
Screenwash/headlamp wash,
fi lling reservoir .................... 55, 77
Bulbs, changing bulbs


- front .....................................82-85

- rear .....................................86-87 Dimensions ..........................98-101
Engine technical data ........102-103
Weights, loads ...................105-108
Identifi cation markings .............. 109
Opening the bonnet, stay ..... 16, 53
Under bonnet engine views ...72-75 Air/oil fi lters,
checks ...........................72-75, 78
Engine fuses ............................... 91
Battery .................................. 78, 92