2012 CHRYSLER 300 SRT lane assist

To Open And Close The Hood ............ 179
 Lights ............................. 180
▫ Headlight Switch .................... 180
▫ Automatic Headlights — If Equipped ...... 181
▫ Headlights On With Wipers (Available With
Automatic Headlights Only) ............ 182
▫ Headlight Time Delay ................. 182
▫ Smartbeam™ — If Equipped ............ 183
▫ Adaptive Bi-Xenon High Intensity Discharge
Headlights — If Equipped .............. 183
▫ Daytime Running Lights (DRL) .......... 184
▫ Lights-On Reminder .................. 184
▫ Fog Lights — If Equipped .............. 184
▫ Multifunction Lever .................. 185 ▫
Turn Signals ........................ 186
▫ Lane Change Assist ................... 186
▫ High/Low Beam Switch ............... 186
▫ Flash-To-Pass ....................... 186
▫ Front Map/Reading Lights ............. 187
▫ Courtesy Lights ..................... 188
▫ Ambient Light ...................... 188
▫ Interior Lights ...................... 189
 Windshield Wipers And Washers .......... 191
▫ Intermittent Wiper System .............. 192
▫ Wiper Operation ..................... 192
▫ Mist Feature ........................ 193
▫ Windshield Washers .................. 193
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 91

Turn Signals
Move the multifunction lever up or down and the arrows
on each side of the instrument cluster flash to show
proper operation of the front and rear turn signal lights.
NOTE:
•If either light remains on and does not flash, or there is
a very fast flash rate, check for a defective outside light
bulb. If an indicator fails to light when the lever is
moved, it would suggest that the indicator bulb is
defective.
•A “Turn Signal On” message will appear in the EVIC
(if equipped) and a continuous chime will sound if the
vehicle is driven more than 1 mile (1.6 km) with either
turn signal on.
Lane Change Assist
Tap the lever up or down once, without moving beyond
the detent, and the turn signal (right or left) will flash
three times then automatically turn off.
High/Low Beam Switch
Push the multifunction lever away from you to switch
the headlights to high beam. Pull the multifunction lever
toward you to switch the headlights back to low beam.
Flash-To-Pass
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will turn on the high beams headlights until the lever is
released.
186 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

High Beam/Low Beam Select (Dimmer) Switch . . 186
Hill Start Assist......................... 382
Holder, Coin ........................... 270
Holder, Cup ........................... 267
HomeLink® (Garage Door Opener)
Transmitter ............................ 245
Ignition Key ............................... 12
Illuminated Entry ........................ 20
Immobilizer (Sentry Key) ................... 15
Infant Restraint ........................ 71,72
Information Center, Vehicle ................. 292
Instrument Cluster ....................... 281
Instrument Panel and Controls .............. 279
Instrument Panel Lens Cleaning ............. 486
Integrated Power Module (Fuses) ............ 487
Interior Appearance Care .................. 485
Interior Fuses .......................... 487 Interior Lights
.......................... 189
Intermittent Wipers (Delay Wipers) ........... 192
Introduction ............................. 4
Jump Starting .......................... 440
Key-In Reminder ......................... 14
Key, Programming ........................ 17
Key, Replacement ........................ 16
Key, Sentry (Immobilizer) ................... 15
Keyless Enter-N-Go™ ................... 33,350
Keyless Entry System ...................... 21
Keyless Go ............................. 12
Keys ................................. 12
Kicker Sound System ..................... 328
Knee Bolster .......................... 56,57
Lane Change and Turn Signals .............. 186
Lane Change Assist ...................... 186
542 INDEX