Black plate (2,1)Chevrolet Tahoe Police and Special Service Packages - 2012
2-2 Keys, Doors, and Windows
Remote Keyless
Entry Transmitter
Programming‐SEO
AMF - Fleet Package of
6 Unprogrammed Remote
Units
Do not operate or program the
transmitters in the vicinity of other
vehicles that are in the keyless
entry program mode. This prevents
the programming of the transmitters
to the incorrect vehicle.
Up to eight transmitters may be
programmed to the RKE on Police
and Special Service Package
equipped vehicles. The first four
transmitters are given the position of
#1-#4 in the RKE. Any further
transmitters will also be assigned to
position #4.
Verify that the proper transmitters
are learned to the vehicle. Do not
learn a transmitter with a remote
start button to a vehicle that does
not have remote start. To access this DIC display, the
vehicle must be in P (Park). To
match a remote keyless entry
transmitter to the vehicle, do the
following:
1. Press the trip odometer reset
stem until RELEARN REMOTE
KEY displays.
2. Press and hold the trip reset stem for three seconds. The
message REMOTE KEY
LEARNING ACTIVE will display.
3. At the same time, press and hold
QandKon the first
transmitter for approximately
15 seconds. A beep will sound
indicating the transmitter is
matched to the vehicle.
4. Repeat Step 3 to match up to five more transmitters. A total of
eight transmitters can be
matched per vehicle.
5. To exit the programming mode, turn the ignition key to LOCK/
OFF .
Black plate (2,1)Chevrolet Tahoe Police and Special Service Packages - 2012
3-2 Seats and Restraints
Q: How can I identify the airbag“deployment zone” in my
vehicle?
A: See Airbag Deployment
Diagrams on page 3‑4 for more
information. The diagrams
provide the approximate
dimensions of the “deployment
zones” for your specialty vehicle.
Before doing any service work,
including the installation of any
equipment, consult the
appropriate service manual.
Q: Is it possible to shield equipment so it does not
interfere with airbag
deployment?
A: While shielding may protect
certain equipment from being
damaged or dislodged, it may
also negatively affect how an
airbag inflates. Therefore, we
cannot recommend the
placement of any equipment in
the deployment zone, even
when shielding. Q: Can the installation of push
bumpers on the front end of
the vehicle affect the
deployment of the airbag?
A: It is not likely that installing push
bumpers will affect sensing for
the airbag as long as the vehicle
structure itself is not modified.
GM is not aware of any adverse
defects from the many push
bumpers that have been
installed on current model GM
police vehicles with airbags.
Q: Is there anything I might add to the front or sides of the
vehicle that could keep the
airbags from working
properly?
A: Yes. If you add things that
change your vehicle's frame,
bumper system, height, front end
or side sheet metal, they may
keep the airbag system from
working properly. Also, the
airbag system may not work
properly if you relocate any of
the airbag sensors. If you have any questions about this, you
should contact Customer
Assistance before you modify
your vehicle. The phone
numbers and addresses for
Customer Assistance are in
Step Two of the Customer
Satisfaction Procedures in the
owner manual. See
“Customer
Satisfaction Procedure” in the
owner manual Index.
The service manual has information
about the location of the airbag
sensors, sensing and diagnostic
module, and airbag wiring. See
“Service Publications Ordering
Information” in the owner manual.
