11
Driver Information Center
The Driver Information Center (DIC) on the instrument cluster displays a variety of vehicle
system information and warning messages.
DIC Controls
A. MENU
Press to display the:
–Trip/Fuelmenu (digital speed-
ometer, trip odometers, eAssist
power flow display (if equipped),
fuel range, average fuel economy,
instantaneous fuel economy,
average vehicle speed, timer,
navigation).
–Vehicle Informationmenu (units,
tire pressure, remaining oil life).
B.
Rotate the switch to scroll through the
items of each menu.
C. SET/CLR
Press to set or clear the displayed
menu item or warning message. Some
urgent messages cannot be cleared
from the DIC display.
Vehicle Personalization
Some vehicle features can be customized
using the controls on the audio system.
1. Press theCONFIGbutton (A) to view
the Configuration Settings menu.
2. Continue to press theCONFIGbutton
to highlight the Vehicle Settings menu.
3. Turn theMENU/SELECTknob (B) to
highlight the desired menu item; press
the knob to select it.
4. Turn theMENU/SELECTknob to high-
light the desired selection; press the
knob to select it.
5. Press the BACKbutton (C) to exit
each menu.
See Instruments and Controls in your Owner Manual.
ABC
A
B
C
14
eAssist Overview(if equipped)
A compact electric assist system called eAssist has been integrated with the highly
efficient 2.4-liter four-cylinder engine and six-speed automatic transmission to provide an
electric “boost” to help conserve fuel. eAssist includes a small, but powerful, electric motor
rated at 15 kilowatts. It replaces the typical alternator found on most engines. eAssist also
uses a small, advanced 115-volt lithium-ion battery located in the trunk.
eAssist Features
Your LaCrosse with eAssist has several features that increase vehicle efficiency and
maximize fuel economy.
When braking or coasting, the electric motor acts like a generator to charge the high-
voltage battery. This “regenerative braking” process captures kinetic energy that would
otherwise be lost and stores it in the high-voltage battery. This electrical energy can then
be reused.
Note:The regenerative braking process requires unique transmission shifting as the vehicle
slows down.
When the vehicle comes to a stop, the engine may turn off automatically, saving fuel that
would otherwise be used while idling. This is called an Auto Stop. The vehicle is powered
by the high-voltage battery.
Note:The eAssist features of the vehicle are enabled after the engine reaches operating
temperature.
Auto Start/Stop
While driving, when the brake is applied and the vehicle comes to a complete stop, the
automatic engine start/stop system may turn off the engine, referred to as an Auto Stop.
In Auto Stop mode, the tachometer gauge (A) will read AUTO STOP. The audio system,
climate controls and other accessories will be powered by the high-voltage battery. The
engine will restart immediately when the brake pedal is released or the accelerator pedal
is applied.
After parking the vehicle and turning off the engine using the key orSTART/STOP
button✦, the tachometer gauge will read OFF.
Auto Start/Stop Conditions
There are several conditions that may cause the engine to remain running or restart when
the vehicle is stopped.
• The engine, transmission or high-voltage battery is not warmed up.
• The outside temperature is less than –4°F (–20°C).
• The shift lever is in any gear other than Drive (D).
• The high-voltage battery state of charge is low.
• The climate control system requires the engine to run based on the climate control or
defog setting. Using theeco Air Conditioningmode will result in more frequent
and longer Auto Stops than theComfort Air Conditioningmode.
• The Auto Stop time is greater than two minutes.
See Driving and Operating in your Owner Manual.
