2012 AUDI A8 buttons

122 Homelink®
Programming transmitters
Applies to vehicles: with Horne link
You con program the buttons in the Home­
Link universal remote control located in the
v e hicle headliner.
F ig. 1 31 Co ntrol un it in the h ead liner
Fi g. 1 32 L eft front area of the bum per
Programming a button
.. Make sure your veh icle is wi thin operating
ra nge of the remo te con trolled ga rage d oor
opener.
.. Set t he parking bra ke
~ A in General infor ­
mation on pa ge 121 .
.. Switc h the ignition on. Do not start the en­
gine!
.. The re a re two ways to program a button :
press the button that yo u would like to pro­
gram . The M MI will display instruct ions to
guide yo u th rough the programm ing . O r
.,. Se lect :
ICARI f u nct io n button > Car systems
cont rol bu tton > Vehicle settings > Garage
door opener > Program garage door open­
er .
.. Se lect t he b utton that yo u wo uld like to
program.
.. Follow the inst ructions in the MMI.
.. If the garage door openi ng must also be
synchronized wit h the Homel ink mod ule, refer to the owner
's manua l for the gar age
door opener .
Using the programmed button
.. Pres s th e pr og rammed butto n~ ,& in Gen­
eral informati on on page 1 21
to open t he
g ar age doo r. T he li ght @ will blink or tur n
on .
.. Press t he bu tton again to close the garage
door
q A in General information on
page 121.
Erasing the button programming
.. Sele ct: I CAR I func tion b utt on > Car systems
function key > Vehicle settings > Garage
door opener > Clear program settings
>
Yes .
Displaying the version/status/country
code
.. Select: I CAR I function b utton > Car systems
contro l button > Vehicle settings > Garage
door opener > Version information .
You can program both fi xed code and ro lling
code systems using these instr uctions.
Programming a button
The re quired di stance between the hand he ld
transmit ter and the Homel ink module in the
bumpe r depe nds on the system tha t you are
programmi ng . You may have to try several
t imes.
E ach of the buttons c an be re progra mmed in ­
dividua lly . The proced ure is the same as fo r in ­
itia l prog ramming .
~page 12 2, Programming
a button.
Erasing the button programming
I n di vidu al but tons ca n b e reprogr ammed. Fol­
l ow the same s teps used when fi rst prog ram ­
ming the butto n.
If y ou wo uld lik e to er ase all prog rammed but ­
t o ns at the same time, sele ct Era se bu tt on
p rogr ammi ng .

@ Tips
-To ensure your safety, erasing the pro­
grammed Homel ink buttons before sell­
i ng the veh icle is recommended.
- Depending on the model of the garage
door opener, you may need to release the
button on the remote and press it again
when programming .
Homelink® 123

180 Child Safety
Attachment locator markers for lower
anchorages
Circular locator buttons on the rear seatback
indicate the lower anchorage locations on the
rear seating positions¢
fig. 160 .
Lower anchorages
The lower anchorage attachment points are
located between the rear seatback and rear
seat cushion
¢ fig . 161.
Lower anchorages secure the child restraint in
the seat witho ut using the vehicle 's safety
belts. Anchorages provide a secure and easy­
to-use attachment and minimize the possibili ­
ty of improper chi ld restraint installation.
All chi ld restraints manufact ured after Sep­
tember 1, 2002, must have lower anchorage
attachments for the
LATCH system.
Remember that the lower anchorage points
are only intended for installation and attach­
ment of child restraints specifically certified
for use with
LATCH l ower anchorages. Child
restraints that are not equipped with the low­
er anchorage attachments can still be instal­ led in compliance with the c hild restra int
manufacturer's instructions on using vehicle
safety belts.
,&. WARNING
Improper use of LATCH lower anchorages
can cause serious personal injury in an ac­
cident .
- Always carefully follow the child re­
straints manufacturer's instructions for
proper installation of the child restraint
and proper use of the lower anchorages
or safety belts in your vehicle .
- Never secure or attach any luggage or
other items to the
LATCH lower ancho­
rages.
-Always read and heed the important in­
formation about child restraints in this
chapter and WARNINGS
¢page 166,
Child Safety.
Guidance fixtures for lower anchorages
Special guidance fixtures increase the conven­
ience of the lower anchorages and are availa­
ble from your authorized Audi dealer.
Fig. 1 62 Outer rear seats: inst all ing th e guidanc e fix­
tures
Fig . 163 Close-up: fitting th e g uida nce fixture over t he
lower anchorage bracket
T he lower anchorage attachment points are
located on the rear seats between the seat­
back and the seat cush ion. Special guidance
fixtures increase the convenience of the lower anchorages and help protect the seat material
from possible damage when installing ch ild
restraints.
Installing the guidance fixtures
.,. Push down on the seat cushion so that the
lower anchorages are visible.
.,. Hold the guidance fixture with the part
number facing downward and push it in the
direction of the arrow onto the anchorage
¢fig . 163 .
.,. Make su re that each of the two guidance fix­
tures per seat snaps into place .
Removing the guidance fixtures
.,. Remove the chi ld restraint according the
child restraint manufacturer's instructions. ..,.

substance use d for u ndercoating cou ld
overheat an d cause a fire.
- Always read and heed all WARNINGS and
other information
¢ page 203.
Exhaust tail pipes
Road sa lt and other corros ive materials will
damage the mater ial in the exhaust tail p ipes
if they are not cleaned regu larly . Do not clean
the ta il p ipes with wheel cleaner, paint polish,
chrome polish or othe r abrasive cleaners .
C lean the tail p ipes with ca r ca re products
that are s uita ble for stain less stee l.
Your authorized Audi dealer can provide clean­ i ng p rod ucts that have been tested and ap­
p roved fo r your vehicle.
Care of interior
Infotainment components
The MMI/RSE* disp lay may be cleaned with a
soft cloth and commercially-ava ilable "LCD
cleaner" . The cloth should be coated light ly
when the clean ing solution when cleani ng the
d isplay.
The MMI/RSE* contro ls must be cleaned first
with a brush so that dirt does not enter the
un it o r enter between the buttons and the
h ousing. Then w iping the controls with a clot h
dampened wi th d ish dete rgent and water is
recommended.
(D Note
To preve nt sc ratches, only clean the dis­
p lay when it is d ry.
- To p reven t damage, ma ke s ure fluids do
not enter the cont rols.
Aluminum trim
Use only neutral-pH produc ts to remove spots
and depos its from alum in um s urfaces.
C hr ome ca re products and alkaline cleaners
will attack alum in um s urfaces and can dam­
age them over time.
Cleaning and protec tion 209
A WARNING
A lways read and heed all WARNINGS and
other information
¢page 203.
Fabrics and fabric coverings
Fabr ics and fabric cover ings (e.g. seats, door
trim pa ne ls, etc.) shou ld be cleaned at regular
i n tervals w it h a vac uum cleaner. This removes
s ur face di rt particles which cou ld become em­
bedded in the fabri c throug h use. Ste am
cleaners sho uld not be used, beca use the
steam tends to p ush the dirt deeper into the
fabric and lock it there .
Normal cleaning
Generally, we recommend using a soft sponge
o r a lint -free microfibe r clo th to the clean fab­
ric. Br ushes shou ld only be used for carpets
and floor mats, since other fabric surfaces
could be harmed by br ushes.
Norma l su rface s tains c an be cleaned using a
commerc ially availab le foam cleaner . Spread
the foam on the s urface of t he fabric with a
soft sponge and work it in gently. Do not satu­
rate the fabric. T hen pat the foam dry us ing
absorbe nt, dry cloths (e.g. m icrofiber cloth)
and vacuum it after it has dried completely.
Cleaning stains
Stains caused by beverages (e .g. coffee, fr uit
juice, etc.) can be treated with a mild deter­
gent solution. Apply the detergent sol ution
with a spo nge. In the case of stubborn stains,
a detergent paste can be applied directly to
the stain and worked into the fabric. After­
wards, use copious amounts of clean water to
remove the rem aining de terge nt. Apply the
w at er wit h a d am p clot h or sponge a nd pat
the fabric dry with an abso rbent, dry clot h.
Stains from choco late or makeup should have
de terge nt pa ste (e.g. o x-gall soa p) rubbed i n­
to them. Afterwa rds, remove the soap wi th
wa ter (damp sponge) .
Alcohol can be used to treat stains from grease, o il , lipstic k or a ballpoin t pen. M elted ..,_ •
•