2012 Alfa Romeo MiTo oil pressure

GETTING TO KNOW YOUR CAR15
1
ON CONSTANTLY:Low engine oil pressure(red)
FLASHING:Engine oil exhausted
(Diesel versions with DPF only - red)
When the ignition key is moved to MAR, the warning
light switches on, and should go out as soon as the engine is start-
ed.
1. Low engine oil pressure
The warning light turns on and stays on constantly (in ver-
sions/markets, where applicable) along with the message on the
display when the system detects that the engine oil pressure is low.
v
If the warning light vturns on when the vehi-
cle is travelling (on certain versions together with
the message on the display) stop the engine im-
mediately and contact Alfa Romeo Authorised Service.
2. Engine oil exhausted(Diesel versions with DPF only)
When the key is turned to the MAR position, the warning light
comes on, but it must switch off after a few seconds. The warn-
ing light will flash and a specific message will appear on the dis-
play (in versions/markets, where applicable). The warning light
may flash in the following ways, depending on the version:
– for 1 minute every two hours;
– for 3 minute cycles with the warning light off for intervals of 5
seconds until oil is changed.After the initial warning, each time the engine is started up, the
warning light will continue to flash for 60 seconds in the same
mode, until the oil is changed. A specific message will appear on
the display (for versions/markets, where applicable) in addition
to the warning light.
If the warning light flashes, this does not mean that the car is de-
fective, but simply informs the driver that it is now necessary to
change the oil as a result of regular vehicle use.
Note that engine oil is exhausted faster under the following cir-
cumstances:
– use of the vehicle prevalently for city driving, requiring more
frequent regeneration of DPF
– use of the vehicle for short drives, in which the engine does not
have time to reach its regular operating temperature
– repeated interruption of the regeneration process, signalled by
the DPF warning light coming on.
Exhausted engine oil should be replaced as soon
as possible after the warning light comes on, nev-
er more than 500 km after the warning light first
comes on. Failure to change the oil within the first 500
km may result in severe damage to the engine and will
result in forfeiture of the warranty. Remember that when
the warning light flashes, it does not mean that the level
of engine oil is low, so if the light flashes you must not top
up the engine oil.

24GETTING TO KNOW YOUR CAR
Display of selected driving mode
(“Alfa DNA” system)
(for versions/markets, where provided)
On versions equipped with a “Reconfigurable multifunctional Dis-
play” a message + symbol associated with the selected driving
mode - “DYNAMIC”, “NORMAL” or “ALL WEATHER” - is shown.
A warning message is shown on the display if one of these dri-
ving modes is not available.
On versions equipped with a “Multifunctional display” a letter (d
or a) associated with the selected driving mode is shown togeth-
er with a dedicated message.
Engine oil level display
(for versions/markets, where provided)
When the ignition key is turned to MAR the display shows, for a few
seconds, the engine oil level. In the event of an insufficient engine
oil level, a warning message appears on the display.
IMPORTANT To determine the correct engine oil quantity, always check
using the marks on the dipstick (see paragraph "Checking levels" in
"5" section).
IMPORTANT For a correct engine oil level indication, perform the check
with the car parked on a level surface.
IMPORTANT To perform the engine oil reading correctly, after turning
the key to MAR wait for about 2 seconds before starting the engine.
IMPORTANT The engine oil level may increase after a long stop.
T.P.M.S. system failure (amber)
(for versions/markets, where provided)
This warning light (or symbol in the display) comes on (on some
versions together with a message in the display) when a fault is
detected in the T.P.M.S tyre inflation pressure monitoring system:
if this occurs, contact your nearest Alfa Romeo Authorised Service
as soon as possible.
Should one or more wheels be fitted without sensors, the display
will show a warning message until initial conditions are restored.
Check tyre inflation pressure
(for versions/markets, where provided)
If this warning light (or symbol in the display) comes on (on some
versions together with a message in the display) this indicates that
the tyre pressure is below the optimum value recommended to
guarantee long tyre life and low fuel consumption. It may also in-
dicate a slow loss of pressure.
Should two or more tyres be discovered to be in the above men-
tioned condition, the display will show the indications corresponding
to each tyre in sequence. Under these circumstances you should
restore the correct pressure values (see chapter 6).

41
41
41
43
41
41
41
41
43
43
4315
20
15
7.5
30
7.5
30
15
5
10
5F08
F09
F10
F13
F15
F19
F20
F21
F31
F36
F37
IN AN EMERGENCY193
4
CONSUMERS FUSE AMPERE FIGURE
Heated windscreen
Headlight washer pump
Two-tone horn
Headlight alignment adjustment system
Additional heater (PTC 1)
“Dynamic Suspension” control system
Air conditioning compressor
Heated rear windscreen, demisting system
Fuel pump on tank
INT/A key exhaust relay coils
on engine fuse box
Radio, Blue&Me
TMcontrol unit, Climate control unit,
Alarm control unit, Volume sensing system control unit,
EOBD external diagnostic socket,
Tyre pressure detection control unit
Instrument panel, Brake light switch,
Gas discharge headlights management system

CARE AND MAINTENANCE207
5
PERIODIC CHECKS
Every 1,000 km or before long journeys, check and top up the fol-
lowing if necessary:
❍engine coolant level, brake fluid and windscreen washer fluid
❍tyre pressure and condition;
❍operation of lights (headlights, direction indicators, hazard
lights, etc.);
❍operation of the windscreen wiper/washer system, position
and wear of windscreen/rearscreen wiper blades;
Every 3,000 km check the following and top-up, if necessary: en-
gine oil level.
We recommend the use of PETRONAS LUBRICANTS products, de-
signed and produced specifically for Alfa Romeo cars (see “Con-
sumables” table in chapter 6).
DEMANDING USE OF THE CAR
If you use the vehicle mainly under one of the following conditions:
❍trailer or caravan towing;
❍dusty roads;
❍repeated short distances (less than 7-8 km) and with exter-
nal temperatures below zero;
❍frequently idling the engine, travelling long distances at low
speeds or long term inactivity;
❍in cities;
perform the following inspections more frequently than shown on
the Scheduled Servicing Plan:
❍check front disc brake pad condition and wear;
❍check cleanliness of bonnet and boot locks, and cleanliness and
lubrication of linkages;
❍visually inspect the condition of: engine, gearbox, transmission,
pipes and hoses (exhaust – fuel supply - brakes) rubber ele-
ments (gaiters – hoses - bushes etc.);

CARE AND MAINTENANCE225
5
INTERIORS
Periodically check for water puddles under the mats that could cause
the panels to rust.
CLEANING SEATS AND FABRIC PARTS
Remove dust with a soft brush or a vacuum cleaner. It is advis-
able to use a moist brush on velvet upholstery. Rub the seats with
a sponge moistened with a solution of water and neutral detergent.
LEATHER SEATS (for versions/markets, where provided)
Remove the dry dirt with a buckskin or slightly damp cloth, with-
out exercising too much pressure.
Remove liquid or oil stains using a dry absorbent cloth, without rub-
bing. Then clean with a soft cloth or buckskin cloth dampened with
water and neutral soap.
If the stain persists, use specific products and observe the instruc-
tions carefully.
IMPORTANT Never use alcohol. Make sure that the cleaning prod-
ucts used contain no alcohol or alcohol derivatives, even in small
quantities.
INTERIOR PLASTIC PARTS
Clean interior plastic parts with a moist cloth and a solution of
water and mild soap. To clean oily or persistent stains, use specif-
ic products free from solvents and designed to maintain the origi-
nal colour of the components.
IMPORTANT Never use spirit or petrol to clean the glass of the in-
strument panel or other plastic parts.