2012 ACURA RL belt

Make sure all windows, mirrors,
and outside lights are clean and
unobstructed. Remove f rost, snow,
or ice.
Check that the hood is f ully closed.
Check that any items you may be
carrying are stored properly or
f astened down securely.Check the seat adjustment (see
page ).
Check the steering wheel
adjustment (see page ).
Make sure the doors and the
trunk are securely closed and
locked.
Fasten your seat belt. Check that
your passengers have f astened
their seat belts (see page ). Youshoulddothefollowingchecks
and adjustments bef ore you drive
your vehicle.
When you start the engine, check
the gauges and indicators in the
instrument panel, and the
messages on the multi-inf ormation
display (see pages , and
). Check the adjustment of the
inside and outside mirrors (see
page ).
Visually check the tires. If a tire
looks low, use a gauge to check its
pressure. 1.
2.
3.
4.5.
6.
7.
8.
9.
10.17
7861 70 156
148 161
Preparing to Drive
400
11/07/20 18:52:53 31SJA670_405
ProCarManuals.com

Your vehicle is equipped with disc
brakes at all f our wheels. A power
assist helps reduce the ef f ort needed
on the brake pedal. The brake pedal
assist f unction increases the f orce
you apply to the brake pedal during
an emergency stop. When the brake
pedal assist is activated, the e-
pretensioners (if equipped) tighten
f ront seat belts (see page ). The
anti-lock brake system (ABS) helps
you retain steering control when
braking very hard (see page ).
Resting your f oot on the pedal keeps
the brakes applied lightly, builds up
heat, reduces their ef f ectiveness and
reduces brake pad lif e. In addition,
f uel economy can be reduced. It also
keeps your brake lights on all the
time, conf using drivers behind you.The hydraulic system that operates
the brakes has two separate circuits.
Each circuit works diagonally across
the vehicle (the lef t-f ront brake is
connected with the right-rear brake,
etc.). If one circuit should develop a
problem, you will still have braking
at two wheels. Constant application of the brakes
when going down a long hill builds
up heat and reduces their ef f ective-
ness. Use the engine to assist the
brakes by taking your f oot of f the
accelerator and downshif ting to a
lower gear.
Check the brakes after driving
through deep water. Apply the
brakes moderately to see if they f eel
normal. If not, apply them gently and
f requently until they do. Be extra
cautious in your driving.If the brake pads need replacing, you
will hear a distinctive, metallic
screeching sound when you apply
the brake pedal. If you do not have
the brake pads replaced, they will
screech all the time. It is normal f or
the brakes to occasionally squeal or
squeak when you apply them. 24
416Braking System Design
Brake Pad Wear Indicators
Braking System
Driving
415
11/07/20 18:54:50 31SJA670_420
ProCarManuals.com

µ
If equipped
The collision mitigation braking
system (CMBS ) can assist the
driver when there is a possibility of
colliding with the vehicle in f ront of
yours. It is designed to reduce the
speed of your vehicle bef ore an
unavoidable collision occurs and, if
possible, to alert you to a potential
collision while there is time f or the
driver to prevent it. Here is a brief
description of what the CMBS can
do:When your speed is above 10 mph
(15 km/h), the CMBS is monitoring
the vehicle ahead of you with radar.
When your vehicle is approaching
the vehicle ahead of yours too
quickly, the system may activate one
or more of the f ollowing: a visual
alert, an audible alert, apply the
brakes and e-pretensioners to
tighten the front seat belts first as
a warning, then to prepare for an
impending crash (see page ).
The CMBS consists of a radar
sensor in the f ront grille, a brake
actuator in the engine compartment,
an indicator on the instrument panel,
seat belt e-pretensioners on the f ront
seats,andanon/off buttononthe
dashboard. 24
Collision Mitigation Braking System (CMBS )
Overview
418
RADAR SENSOR
BRAKE
ACTUATORSEAT BELT
e-PRETENSIONERS
TM TM
TM TM
11/07/20 18:55:10 31SJA670_423
ProCarManuals.com

µµ
Î
Î
e-pretensioner The radar sensor
detects a vehicle.Braking Audio & Visual
WARNING
Stage one
Stage threeDistance between vehiclesCMBS
Stage two
Retracts the driver’s
seat belt gently a few
times, providing a
physical warning.
Forcef ully tightens
driver and front
passenger seat belts. There is a risk of a
collision with the
vehicle ahead of you.
The risk of a collision
hasincreased,timeto
respond is reduced.
The CMBS
determines that a
collision is
unavoidable.Lightly
applied
Forcefully
applied ‘‘BRAKE’’ f lashes
on the multi-
information
display.
A beep sounds
and ‘‘BRAKE’’
f lashes on the
multi-information
display.
:
Depending on the circumstances, CMBS may not go through all of the alert stages bef ore initiating the last stage.
Collision Mitigation Braking System (CMBS )
422
YOUR
VEHICLE YOUR
VEHICLE
YOUR
VEHICLEVEHICLE
AHEADVEHICLE
AHEAD
VEHICLE
AHEAD
TM TM
11/07/20 18:55:36 31SJA670_427
ProCarManuals.com

This section explains why it is
important to keep your vehicle well
maintained and how to f ollow basic
maintenance saf ety precautions.
This section also includes
instructions on how to read the
Maintenance Minder messages on
the multi-information display, and
instructions f or simple maintenance
tasks you may want to take care of
yourself .
If you have the skills and tools to
perf orm more complex maintenance
tasks on your vehicle, you may want
to purchase the service manual. See
page f or inf ormation on how to
obtain a copy, or see your dealer.U.S. Vehicles: ......................Maintenance Saf ety . 444
................. Maintenance Minder . 445
.............................. Fluid Locations . 455
...... Engine Compartment Covers . 456
........................ Adding Engine Oil . 458
Changing the Engine Oil and
........................................... Filter . 459
.............................. Engine Coolant . 461
.................... Windshield Washers . 463
.... Automatic Transmission Fluid . 464
.................................... Brake Fluid . 466
.................... Power Steering Fluid . 467
.................................... Timing Belt . 467
............................................. Lights . 468
.................. DustandPollenFilter .476
................ Cleaning the Seat Belts . 476
..................................... Floor Mats . 477
................................. Wiper Blades . 478
................................. Exterior Care . 480
........................................... Wheels . 480
............................................... Tires . 481
................... Checking the Battery . 490
............................. Vehicle Storage . 493
.................................. Interior Care . 494 543
Maintenance
Maintenance, replacement, or
repair of emissions control
devices and systems may be done
by any automotive repair
establishment or individual using
parts that are ‘‘certif ied’’ to EPA
standards.
Maint enance
443
TM
11/07/20 18:58:24 31SJA670_448
ProCarManuals.com

µµ
Maintenance Minder
454
TM
Maintenance Sub Items
Replace rear differential fluid
Driving in mountainous areas at very low vehicle
speeds or trailer towing results in higher level of
mechanical (shear) stress to fluid. This requires
differential fluid changes more frequently than
recommended by the Maintenance Minder. If you
regularly drive your vehicle under these conditions,
have the differential fluid changed at 7,500 miles
(12,000 km), then every 15,000 miles (24,000 km). Maintenance Sub Items
Rotate tires
Replace air cleaner element
If you drive in dusty conditions, replace every 15,000
miles (24,000 km).
Replace dust and pollen filter
If you drive primarily in urban areas that have high
concentrations of soot in the air from industry and
from diesel-powered vehicles, replace every 15,000
miles (24,000 km).
Inspect drive belt
Replace transmission and transfer fluid
Driving in mountainous areas at very low vehicle
speeds or trailer towing results in higher
transmission and transfer temperatures.
This requires transmission and transfer fluid changes
more frequently than recommended by the
Maintenance Minder. If you regularly drive your
vehicle under these conditions, have the transmission
and transfer fluid changed at 60,000 miles
(100,000 km), then every 30,000 miles (48,000 km).
Replace spark plugs
Replace timing belt and inspect water pump
If you drive regularly in very high temperatures (over
110°F, 43°C), or in very low temperatures (under
20°F, 29°C), replace every 60,000 mile (U.S.)/
100,000 km (Canada).
Inspect valve clearance
Replace engine coolant Symbol
1
2
3
4
5Symbol
6
Maintenance Minder
11/07/20 18:59:47 31SJA670_459
ProCarManuals.com

µµ The timing belt should be replaced
according to the Maintenance
Minder (see page ).
Replace the timing belt every 60,000
miles (100,000 km) if you regularly
drive your vehicle in any of the
f ollowing conditions:
If you f requently tow a trailer. In very high temperatures
(over 110°F, 43°C).
In very low temperatures
(under 20°F, 29°C). Pour the f luid slowly and caref ully so
you do not spill any. Clean up any
spill immediately; it could damage
components in the engine
compartment.
Always use Acura Power Steering
Fluid. You may use another power
steering f luid as an emergency
replacement, but have the power
steering system f lushed and ref illed
with Acura PSF as soon as possible.
A low power steering f luid level can
indicate a leak in the system. Check
the f luid level f requently, and have
the system inspected as soon as
possible. Af ter removing the right engine
compartment cover (see page ),
check the level on the side of the
reservoir when the engine is cold.
The f luid should be between the
UPPER LEVEL and LOWER LEVEL.
If not, add power steering f luid to the
UPPER LEVEL mark.454
457
Power Steering Fluid, Timing Belt
Timing Belt Power Steering Fluid
Maint enance
467
UPPER LEVEL
LOWER LEVELTM
T urning the steering wheel to f ull lef t
or right lock and holding it there can
damage the power steering pump.
11/07/20 19:01:30 31SJA670_472
ProCarManuals.com

This f ilter removes the dust and
pollenthatisbroughtinfromthe
outside through the climate control
system.
Have your dealer replace the filter
when this service is indicated by a
maintenance message on the multi-
inf ormation display. It should be
replaced every 15,000 miles (24,000
km) if you drive primarily in urban
areas that have high concentrations
of soot in the air, or if the f low f rom
theclimatecontrolsystembecomes
less than usual.If your seat belts get dirty, use a sof t
brush with a mixture of mild soap
and warm water to clean them. Do
not use bleach, dye, or cleaning
solvents. Let the belts air-dry bef ore
you use the vehicle.Dirt build-up around the openings of
the seat belt anchors can cause the
belts to retract slowly. Wipe the
openings with a clean cloth
dampened in mild soap and warm
water or isopropyl alcohol.
Dust and Pollen Filter, Cleaning the Seat Belts
Dust and Pollen Filter Cleaning the Seat Belts
476
OPENING
11/07/20 19:02:58 31SJA670_481
ProCarManuals.com