Page 335 of 562
Press the ACC button. The ACC
indicator in the instrument panel
goes off. Tap the brake pedal. Push the CANCEL button on the
steering wheel.If you cancel ACC by pressing the
ACC button, the previously set
cruising speed is erased f rom
memory. The distance you select is also
shown on the multi-inf ormation
display.
ACC is canceled whenever you do
any of these actions:When you push the CANCEL button
or tap the brake pedal to cancel ACC,
the set cruising speed stays in
memory. When you turn on ACC
again, the speed is shown on the
multi-inf ormation display. To return
to that speed, accelerate to over 25
mph (40 km/h), then press the RES/
ACCEL button. Canceling the A CC
A daptive Cruise Control (A CC)
Features
329
LONG
RANGE
MIDDLE
RANGE
SHORT
RANGECANCEL BUTTON U.S.
U.S.
U.S. Canada
Canada
Canada
11/07/20 18:42:40 31SJA670_334
ProCarManuals.com
Page 338 of 562
Message Message DescriptionDescription
Apply the brakes immediately.
Your vehicle is too close to the vehicle
ahead of it.
You will hear a continuous beep.
ACC needs to be checked.
Have your vehicle checked by a
dealer. ACC has automatically canceled
because its radar sensor in the f ront
grill is dirty.
You will hear a beep for about 1
second.
ACC has automatically canceled
because of bad weather or other
conditions.
You will hear a beep for about 1
second.
A daptive Cruise Control (A CC)
332
11/07/20 18:43:06 31SJA670_337
ProCarManuals.com
Page 388 of 562

Help assure your vehicle’s f uture
reliability and perf ormance by paying
extra attention to how you drive
during the f irst 600 miles (1,000 km).
During this period:
Avoid full-throttle starts and rapid
acceleration.
Avoidhardbrakingforthefirst
200 miles (300 km).Your vehicle is designed to operate
on premium unleaded gasoline with a
pump octane of 91 or higher. If this
octane grade is unavailable, regular
unleaded gasoline with a pump
octane of 87 or higher may be used
temporarily. The use of regular
unleaded gasoline can cause metallic
knocking noises in the engine and
will result in decreased engine
perf ormance. The long-term use of
regular-grade gasoline can lead to
engine damage. Do not change the oil until the
multi-inf ormation display indicates
it is needed.
Do not tow a trailer.
You should also f ollow these
recommendations with an
overhauled or exchanged engine, or
when the brakes are replaced.We recommend quality gasolines
containing detergent additives that
help prevent f uel system and engine
deposits. Break-in Period Fuel Recommendation
Break-in Period, Fuel Recommendation
382
Use of gasoline with these additives
may adversely af f ect perf ormance, and
cause the malf unction indicator lamp
on your instrument panel to come on. If
this happens, contact your dealer f or
service. Some gasoline today is blended
with oxygenates such as ethanol. Your
vehicle is designed to operate on
oxygenated gasoline containing up to
10% ethanol by volume. Do not use
gasoline containing methanol. If you
notice any undesirable operating
symptoms, try another service station
or switch to another brand of gasoline. We recommend quality gasoline
containing detergent additives that help
prevent f uel system and engine deposits.
In addition, in order to maintain good
perf ormance, f uel economy, and
emissions control, we strongly
recommend the use of gasoline that
does NOT contain harmf ul manganese-
based f uel additives such as MMT , if
such gasoline is available.
11/07/20 18:50:31 31SJA670_387
ProCarManuals.com
Page 391 of 562

Park the vehicle, and set the
parking brake. Pull the hood
release lever located under the
lower lef t corner of the dashboard.
The hood will pop up slightly. Your vehicle’s on board diagnostic
system will detect a loose or missing
f uel f ill cap as an evaporative system
leak. The f irst time a leak is detected
a ‘‘TIGHTEN FUEL CAP’’ message
appears on the multi-inf ormation
display. Turn the engine of f , and
conf irm the f uel f ill cap is installed. If
it is, loosen it, then retighten it until
it clicks at least once. The message
should go of f af ter several days of
normal driving once you tighten orreplace the f uel f ill cap. To scroll to
another message, press the INFO
button. The ‘‘TIGHTEN FUEL CAP’’
message will appear each time you
restart the engine until the system
turns the message of f .
If the system still detects a leak in
the vehicle’s evaporative emissions
system, the malf unction indicator
lamp (MIL) comes on. If the f uel f ill
cap was not already tightened, turn
the engine of f , and check or
retighten the f uel f ill cap until it
clicks at least once. The MIL should
go off after several days of normal
driving once the cap is tightened or
replaced. If the MIL does not go of f ,
have your vehicle inspected by a
dealer. For more inf ormation, see
page .1.
509
CONT INUED
Opening and Closing the Hood Tighten Fuel Cap Message
Service Station Procedures
Bef ore Driving
385
HOOD RELEASE LEVER
11/07/20 18:50:52 31SJA670_390
ProCarManuals.com
Page 397 of 562

Bef ore installing any accessory:
Make sure the accessory does not
obscure any lights, or interf ere
with proper vehicle operation or
perf ormance. Modif ying your vehicle, or installing
non-Acura accessories, may make
your vehicle unsaf e. Bef ore you
make any modif ications or add any
accessories,besuretoreadthe
f ollowing inf ormation.
Your dealer has Acura accessories
that allow you to personalize your
vehicle. These accessories have
been designed and approved f or your
vehicle, and are covered by warranty.Be sure electronic accessories do
not overload electrical circuits
(see page ) or interf ere with
the proper operation of your
vehicle.
Do not install accessories on the
side pillars or across the rear
windows. Accessories installed in
theseareasmayinterferewith
proper operation of the side
curtain airbags. When properly installed, cellular
phones, alarms, two-way radios, and
low-powered audio systems should
not interf ere with your vehicle’s
computer controlled systems, such
as your airbags, anti-lock brakes, and
tire pressure monitoring system. Although non-Acura accessories may
f it on your vehicle, they may not
meet f actory specif ications, and
could adversely af f ect your vehicle’s
handling, stability, and reliability.Bef ore installing any electronic
accessory, have the installer
contact your dealer for assistance.
If possible, have your dealer
inspect the f inal installation.512 A ccessories
A ccessories and Modif ications
Bef ore Driving
391
Improper accessories or
modifications can affect your
vehicle’s handling, stability, and
performance, and cause a
crash in which you can be hurt
or killed.
Follow all instructions in this
owner’s manual regarding
accessories and modifications.
11/07/20 18:51:49 31SJA670_396
ProCarManuals.com
Page 398 of 562

Raising your vehicle with a non-
Acura suspension kit can af f ect
the handling, stability, and
reliability. Lowering the vehicle with a non-
Acura suspension kit that
signif icantly reduces ground
clearance can allow the
undercarriage to hit speed bumps
or other raised objects, which
could cause the airbags to deploy. Removing parts f rom your vehicle,
or replacing components with non-
Acura components could seriously
af f ect your vehicle’s handling,
stability, and reliability.
Some examples are:Non-Acura wheels, because they
are a universal design, can cause
excessive stress on suspension
components and will not be
compatible with the tire pressure
monitoring system (TPMS).
Larger or smaller wheels and tires
can interf ere with the operation of
your vehicle’s anti-lock brakes and
other systems.
Modif ying your steering wheel or
any other part of your vehicle’s
safety features can make the
systems inef f ective.
If you plan to modif y your vehicle,
consult your dealer. Modif ying Your Vehicle
A ccessories and Modif ications
392
11/07/20 18:51:57 31SJA670_397
ProCarManuals.com
Page 405 of 562

This section gives you tips on
starting the engine under various
conditions, and how to operate the
automatic transmission. It also
includes important inf ormation on
parking your vehicle, the braking
system, the Super Handling-All
Wheel Drive (SH-AWD
)system,
the vehicle stability assist (VSA
)
system, the tire pressure monitoring
system (TPMS), the Collision
mitigation braking system
(CMBS ), and f acts you need if you
are planning to tow a trailer......................... Preparing to Drive . 400
....................... Starting the Engine . 401
Check Starting System
................................. Message . 402
.............. Automatic Transmission . 403
Driving with the Paddle
................................... Shif ters . 407
................ D-Paddle Shif t Mode . 407
.............. Sequential Shif t Mode . 409
Super Handling-All Wheel Drive
................. (SH-AWD
) System . 412
........................................... Parking . 414
............................. Braking System . 415
............... Anti-lock Brakes (ABS) . 416
Collision Mitigation Braking
.................. System (CMBS ) . 418
Tire Pressure Monitoring
........................ System (TPMS) . 429
Vehicle Stability Assist (VSA
),
aka Electronic Stability
........ Control (ESC), System . 435
........................... Towing a Trailer . 437
................... Towing Your Vehicle . 442
Driving
Driving
399
TM
TM
TMTM
TM TM
11/07/20 18:52:43 31SJA670_404
ProCarManuals.com
Page 407 of 562

Apply the parking brake.
In cold weather, turn of f all
electrical accessories to reduce
the drain on the battery.
Make sure the shif t lever is in
Park. Press on the brake pedal. Your vehicle’s starting system has an
auto control mode. When you turn
the ignition switch to the START
(III) position, this f eature keeps the
engine’s starter motor running until
the engine starts. Follow these
instructions to start the engine:Without touching the accelerator
pedal, turn the ignition switch to
the START (III) position, then
release the ignition switch. You do
not need to hold the ignition
switch in the START (III) position
to start the engine. Depending on
the outside temperature, the
starter motor runs f or about 6 to 9
seconds until the engine starts.
If you hold the ignition switch in
the START (III) position f or more
than 7 seconds, the starter motor,
depending on the outside
temperature, runs f or about 10 to
25 seconds until the engine starts.
If the engine does not start, wait at
least 10 seconds bef ore trying
again. 1.
2.
3.4.
Starting the Engine
Driving
401
T he immobilizer system protects your
vehicle f rom thef t. If an improperly
coded key (or other device) is used, the
engine’s f uel system is disabled. For
more inf ormation, see page .
The engine is harder to start in cold
weather. Also, the thinner air f ound at
altitudes above 8,000 f eet (2,400
meters) adds to this problem.150
11/07/20 18:53:01 31SJA670_406
ProCarManuals.com