2012 ACURA RL display

Certain conditions may cause the
radar aim to be temporarily out of
proper range, such as the f ollowing
two examples:
If the radar sensor cover or the radar
sensor ever needs to be removed,
take your vehicle to a dealer. Do not allow anything to impact the
radarsensorortheradarsensor
cover. If either of these parts
receives a strong impact, switch the
system of f by pressing the CMBS
OFF button, and have your vehicle
checked by a dealer. If the f ront
grille ever needs to be repaired,
consult a dealer f irst.
Thetiresarenotcorrectly
maintained. Always make sure the
tire pressures are correct (see
page ), and that the tires are
thecorrectsizeandingood
condition (see Tires on page ). Your vehicle is tilted because of a
heavy load in the rear or from
modif ications to the suspension.
Do not overload your vehicle (see
Carrying Cargo on page ), and
do not make any modif ications to
the suspension (see Accessories
and Modif ications on page ).394
392
482
481
Collision Mitigation Braking System (CMBS )
420
TM TM
When the CMBS is on, the radar sensor
constantly scans f or vehicles directly
ahead of you. This means that driving
on a road with a f ew or no vehicles
could cause a CHECK CMBS RADAR
SENSOR message to appear on the
multi-inf ormation display. This is
normal and not a cause f or concern.
11/07/20 18:55:22 31SJA670_425
ProCarManuals.com

CONT INUED
If the system senses a likely collision
with a vehicle or object ahead of you,
it alerts you with a visual alert or a
combination of a visual alert and an
audible alert.The visual alert is an amber colored
BRAKE message that flashes on the
multi-inf ormation display, the audible
alert is a constant beeping sound. If
one or more of the alerts come on,
take the appropriate means to
prevent a collision (apply the brakes,
change lanes, etc.). Collision Alarm
Collision Mitigation Braking System (CMBS )
Driving
421
TM TM
11/07/20 18:55:27 31SJA670_426
ProCarManuals.com

µµ
Î
Î
e-pretensioner The radar sensor
detects a vehicle.Braking Audio & Visual
WARNING
Stage one
Stage threeDistance between vehiclesCMBS
Stage two
Retracts the driver’s
seat belt gently a few
times, providing a
physical warning.
Forcef ully tightens
driver and front
passenger seat belts. There is a risk of a
collision with the
vehicle ahead of you.
The risk of a collision
hasincreased,timeto
respond is reduced.
The CMBS
determines that a
collision is
unavoidable.Lightly
applied
Forcefully
applied ‘‘BRAKE’’ f lashes
on the multi-
information
display.
A beep sounds
and ‘‘BRAKE’’
f lashes on the
multi-information
display.
:
Depending on the circumstances, CMBS may not go through all of the alert stages bef ore initiating the last stage.
Collision Mitigation Braking System (CMBS )
422
YOUR
VEHICLE YOUR
VEHICLE
YOUR
VEHICLEVEHICLE
AHEADVEHICLE
AHEAD
VEHICLE
AHEAD
TM TM
11/07/20 18:55:36 31SJA670_427
ProCarManuals.com

Any of the conditions below can
cause the CMBS to shut of f . When
the system shuts off, the CMBS
indicator in the instrument panel
comes on, and a CHECK CMBS
SYSTEM message appears on the
multi-inf ormation display f or about 5
seconds.
An abnormal tire condition is
detected (wrong tire size, f lat tire,
etc.).
Extended off-road or mountainous
driving.
Driving your vehicle with the
parking brake applied.
Driving your vehicle in bad
weather(rain,fog,snow,etc.).
A dirty radar sensor cover on the
f ront grille. To switch the CMBS of f , press the
CMBS OFF button on the dashboard
f or about 1 second. When you do this,
a beeper sounds, a CMBS indicator
on the instrument panel comes on,
and a CMBS OFF message appears
on the multi-information display. To
switch the system back on, press the
button again f or about 1 second.When you turn the ignition switch to
the ON (II) position, the system will
be in the previously selected on or
off setting.
CONT INUED
Collision Mitigation Braking System (CMBS )
Automatic Shut Of f CMBS OFF Button
Driving
423
CMBS OFF BUTTON
TM TM
11/07/20 18:55:46 31SJA670_428
ProCarManuals.com

CONT INUED
The CMBS may not activate under
some conditions. Here are a f ew
examples:
The distance between your vehicle
and the vehicle ahead of you is too
short. When you turn the ignition switch
to the ON (II) position, the CMBS
indicator should come on f or a f ew
seconds, then go of f . If the
indicator comes on at any other
time and a CHECK CMBS
SYSTEM message appears on the
multi-inf ormation display, there is
a problem with the CMBS. You
can still drive your vehicle, but
CMBS will not be operating. Have
your vehicle checked by a dealer.
A vehicle cuts in f ront of you at a
slow speed, or it brakes suddenly. When you accelerate rapidly and
approach the vehicle ahead of you
at high speed.
Immediately af ter you begin
driving. Limitations
Collision Mitigation Braking System (CMBS )
Driving
425
YOUR VEHICLE
TM TM
11/07/20 18:56:02 31SJA670_430
ProCarManuals.com

Your vehicle is equipped with a tire
pressure monitoring system (TPMS)
that turns on every time you start the
engine and monitors the pressure in
your tires while driving.
Each tire has its own pressure
sensor. If the air pressure of a tire
becomes signif icantly low, the
sensor in that tire immediately sends
a signal that causes the low tire
pressure/TPMS indicator in the
instrumental panel and the
appropriate tire position indicator on
thetirepressuremonitoronthe
multi-inf ormation display (see page
)tocomeon.Refer to page for tire inflation
guidelines.
If there is a problem with the TPMS,
this indicator begins to f lash. It stops
flashing after approximately 1
minute, then stays on. You will also
see a ‘‘CHECK TPMS SYSTEM’’
message on the multi-inf ormation
display (see page ). When the low tire pressure/TPMS
indicator is on, one or more of your
tires is signif icantly underinf lated.
The multi-inf ormation display also
shows a ‘‘CHECK TIRE PRESSURE’’
message (see page ). You should
stop and check your tires as soon as
possible, and inflate them to the
proper pressure as indicated on the
vehicle’s tire inf ormation placard.
Driving on a signif icantly under
inf lated tire causes the tire to
overheat and can lead to tire failure.
Underinf lation also reduces f uel
efficiency and tire tread life, and may
af f ect the vehicle’s handling and
stopping ability.
Becausetirepressurevariesby
temperature and other conditions,
the low tire pressure/TPMS
indicator may come on unexpectedly.For example, if you check and fill
your tires in a warm area, then drive
in extremely cold weather, the tire
pressure will be lower than
measured and could be underinf lated
and cause the low tire pressure/
TPMS indicator to come on. Or, if
youcheckandadjustyourtire
pressure in cooler conditions, and
drive into extremely hot conditions,
the tire may become overinf lated.
However, the low tire pressure/
TPMS indicator will not come on if
thetiresareoverinflated.
431431
481
433
CONT INUED
Low Tire Pressure/
TPMS Indicator
Tire Pressure Monitoring System (TPMS)
Driving
429
11/07/20 18:56:33 31SJA670_434
ProCarManuals.com

Although your tire pressure is
monitored, you must manually check
thetirepressuresmonthly.
Each tire, including the spare, should
be checked monthly when the
vehicle is cold, and set to the
recommended inf lation pressure as
specif ied on the vehicle placard and
intheowner’smanual(seepage
).
If the tire is f lat, or if the tire
pressure is too low to continue
driving, replace the tire with the
compact spare tire (see page ). If you think you can saf ely drive a
short distance to a service station,
proceed slowly to the station, then
inflate the tire to the recommended
pressure.If you have a f lat tire, the low tire
pressure/TPMS and tire monitor
indicators will come on. Replace the
indicated f lat tire with the compact
sparetire(seepage ).
After the flat tire is replaced with the
spare tire, the low tire pressure/
TPMS indicator stays on while
driving. Af ter several miles
(kilometers) driving, this indicator
begins to f lash, then stays on again.
You will also see a ‘‘CHECK TPMS
SYSTEM’’ message on the multi-
inf ormation display. This is normal;
the system cannot monitor the spare
tire pressure. Manually check the
sparetirepressuretobesureitis
correct.
This indicator and the warning
message on the multi-inf ormation
display will go of f , af ter several miles
(kilometers) driving, when the spare
tire is replaced with the specifiedregular tire equipped with the tire
pressure monitor sensor.
Never use a puncture-repairing agent
in a f lat tire. If used, you will have to
replace the tire pressure sensor.
Havetheflattirerepairedbyyour
dealer as soon as possible.
Each wheel is equipped with a tire
pressure sensor. You must use
TPMS specif ic wheels. It is
recommended that you always have
your tires serviced by your dealer or
a qualif ied technician. 482
496497 Changing a T ire with T PMS
Tire Pressure Monitoring System (TPMS)
430
11/07/20 18:56:41 31SJA670_435
ProCarManuals.com

If any of the tires have low pressure,
the multi-information display will
show a ‘‘CHECK TIRE PRESSURE’’
message. You will also see one or
more low pressure tire positions
blinking in the display (see page
). If there is a system error with the
TPMS, the multi-inf ormation display
showsa‘‘SYSTEMFUNCTION
ERROR’’ message (see page ),
and the tire pressure readings will
not be displayed. You will also see a
‘‘CHECK TPMS SYSTEM’’ message
on the multi-information display (see
page ). When all tire pressures are normal,
the multi-information display will
show ‘‘TIRE PRESSURE OK
SYSTEM FUNCTION NORMAL.’’
When any of the tires has low
pressure, the multi-inf ormation
display shows a ‘‘TIRE PRESSURE
ERROR SYSTEM FUNCTION
NORMAL’’ message (see page ).7643367 433
CONT INUED
Tire Pressure Monitor
Tire Pressure Monitoring System (TPMS)
Driving
431
VEHICLE ICON
11/07/20 18:56:48 31SJA670_436
ProCarManuals.com