2012 Abarth 500 Antifreeze

130
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICATIONS
INDEX
YOUR CAR
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
WINDSCREEN/REAR WINDOW
WASHER FLUID fig. 1
To add fluid, remove the cap D, pressing
the special tab.
Pour a mixture of water and TUTELA
PROFESSIONAL SC 35, in the following
concentrations:
30% TUTELA PROFESSIONAL SC 35 and
70% water in summer.
50% TUTELA PROFESSIONAL SC 35 and
50% water in winter.
In case of temperatures below –20°C, use
undiluted TUTELA PROFESSIONAL SC
35 fluid.
Check level through the reservoir.
Close the cap Dpressing its central sec-
tion. ENGINE COOLANT fig. 1
The coolant level must be checked when
the engine is cold and must be between
the MIN and MAX lines on the vessel.
If the level is low, pour slowly a mixture
of 50% distilled water and 50%
PARAFLU
UPof the PETRONAS
LUBRICANTSGroup through the filler
neck Cuntil the level reaches MAX.
A 50-50 mixture of PARAFLU
UPand dis-
tilled water gives freeze protection to
–35°C.
When the vehicle is used under particu-
larly harsh climate conditions, we recom-
mend using a 60-40 mixture of
PARAFLU
UPand demineralised water.PARAFLU
UPantifreeze is used
in the engine cooling system.
Use fluid of the same type
contained in the cooling sys-
tem for top-ups. PARAFLU
UPmay not
be mixed with other types of fluids. If
this accidentally occurs, do not start
the engine and contact a Abarth Deal-
ership.
The engine cooling system is
pressurized. If required, re-
place the cap with an original spare
part so as not to compromise system
efficiency. Do not remove the cap
from the vessel when the engine is
hot: risk of burns.
WARNING
Do not travel with the wind-
screen washing reservoir
empty: the windscreen washer is fun-
damental to improve visibility.
Some commercial windscreen wash-
er additives are flammable. The en-
gine compartment contains hot parts
which could start a fire if they come
into contact.
WARNING

136
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICATIONS
INDEX
YOUR CAR
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
WINDSCREEN/
REAR WINDOW
WIPERS
BLADES
Periodically clean the rubber part using
special products; TUTELA PROFES-
SIONAL SC 35 is recommended.
Replace the blades if the rubber edge is de-
formed or worn. In all cases, it is advisable
to replace them approximately once a year.
A few simple precautions can reduce the
possibility of damage to the blades:
❒make sure that the rubber part is not
stuck to the windscreen at sub-zero
temperatures. Use an antifreeze prod-
uct to release it if required.
❒remove the snow from the window:
this will avoid overstressing the elec-
trical motor in addition to protecting
the blades;
❒do not operate the windscreen and the
rear screen wipers on dry glass.Replacing the windscreen
wiper blades fig. 5
Proceed as follows:
❒lift the arm Aof the wiper and position
the blade so that it forms an angle of
90° with the arm itself;
❒press the button Aand extract from
the arm Bthe brush C;
❒insert the new blade making sure it is
locked.
fig. 5F0S119Ab
Driving with worn wiper
blades is a serious hazard,
because visibility is reduced in bad
weather.
WARNING
Changing the rear
window blade fig. 6
Proceed as follows:
❒raise the cover Aand remove the arm
from the car, slackening the nut Bthat
fastens it to the pivot pin;
❒fit the new arm, positioning it correct-
ly, and fully tighten the nut;
❒lower the cover.
fig. 6F0S120Ab

156
WARNING
LIGHTS AND
MESSAGES
INDEX
YOUR CAR
SAFETY
DEVICES
CORRECT USE
OF THE
CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
Use Fluid and lubricant specifications Recommended Applicationsfor correct car operation fluids and lubricants
Lubricants and greases
for movement
transmission
Brake fluid
Protective agent
for radiators
Windscreen/
rear window
washer fluid
(*) IMPORTANT Don’t use fluids having different specifications for topping up or mixing.
(❑) When the vehicle is used under particularly harsh climate conditions, we recommend using a 60-40 mixture of PARAFLUUPand demineralised
water.
Mechanical gearbox
and differential
CV joints
on wheel side
CV joints
on differential side
Brake and clutch
hydraulic controls
Cooling circuits
proportions of use:
50% demineralised
water 50%
PARAFLU UP
(❑)
To be used diluted
or undiluted in
windscreen/rear
window washer/
wiper systems
TUTELA CAR
TECHNYX
Contractual Technical
Reference N° F010.B05
TUTELA ALL STARContractual Technical
Reference N° F702.G07
TUTELA STAR 325Contractual Technical
Reference N° F301.D03
TUTELA TOP 4Contractual Technical
Reference N° F001.A93
PARAFLUUP(*)Contractual Technical
Reference N° F101.M01
TUTELA
PROFESSIONAL SC35
Contractual Technical
Reference N° F201.D02
Synthetic lubricant, grade SAE 75W- 85 Exceeds the
API GL4 PLUS, FIAT 9.55550 specifications
Molybdenum bisulphide grease, resistant to high
temperatures. Consistency NL.GI. 1-2
Poly-urea synthetic-based grease suitable for
high temperatures. Consistency N.L.G.I.2.
Synthetic fluid FMVSS n° 116 DOT 4, ISO 4925
SAE J1704, CUNA NC 956- 01
Red protective with antifreeze action, based on
inhibited monoethylen glycol with organic formula
based on O.A.T.
That passes CUNA NO 956-16, ASTM D 3306
specifications
Mixture of alcohol, water and surfactants
CUNA NO 956-II