2012.5 Peugeot RCZ ABS
[x] Cancel search: ABSPage 29 of 336
1/
INSTRUMENTS and CONTROLS
Warning lamp
is on
Cause
Action / Observations
STOP
fi xed, alone
or associated
with another
warning lamp,
accompanied by
an audible signal
and a message
in the screen. Illumination of this warning
lamp is associated with a
serious braking system, power
steering, engine lubrication or
cooling system malfunction or a
punctured tyre. Stop as soon as it is safe to do so as there is a risk that the
engine will cut out while driving.
Park, switch off the ignition and contact a PEUGEOT
dealer or a qualifi ed workshop.
Maximum
coolant
temperature
fi xed with the
needle in the red
zone. The temperature of the cooling
system is too high. Stop as soon as it is safe to do so.
Wait until the engine has cooled down before topping up
the level, if necessary.
If the problem persists, contact a PEUGEOT dealer or a
qualifi ed workshop.
Braking
fi xed, associated
with the STOP
warning lamp. The braking system fl uid level is
too low. You must stop as soon as it is safe to do so.
Top up with brake fl uid recommended by PEUGEOT.
If the problem persists, have the system checked by a
PEUGEOT dealer or a qualifi ed workshop.
+
fi xed, associated
with the STOP
and ABS warning
lamp. The electronic brake force
distribution (EBFD) system has
a fault. You must stop as soon as it is safe to do so.
Have it checked by a PEUGEOT dealer or a qualifi ed
workshop.
Page 31 of 336
1/
INSTRUMENTS and CONTROLS
Anti-lock
Braking
System (ABS)
fi xed. The anti-lock braking system has
a fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact a PEUGEOT
dealer or a qualifi ed workshop without delay.
Dynamic
stability control
(ESC/ASR)
fl ashing. The ESC/ASR regulation is
active. The system optimises traction and improves the directional
stability of the vehicle.
fi xed. Unless it has been deactivated
(button pressed and its indicator
lamp on) the ESC/ASR system
has a fault. Have it checked by a PEUGEOT dealer or a qualifi ed
workshop.
Directional
headlamps
fl ashing. The directional headlamps
system has a fault. Have it checked by a PEUGEOT dealer or a qualifi ed
workshop.
Warning lamp
is on
Cause
Action / Observations
Seat belt not
fastened /
unfastened
fi xed, then
fl ashing in the
passenger's seat
belt and front
airbag warning
lamp display. The driver or front passenger has
not buckled or has unbuckled
their seat belt.
Pull on the belt in question and insert the tongue in the
buckle.
At least one rear passenger has
unbuckled their seat belt.
Page 41 of 336
1/
INSTRUMENTS and CONTROLS
DATA DISPLAYS
)
Press the button, located at the end of the wiper stalk
, to display
the various trip computer tabs in succession.
)
Press the up and down arrows on the navigator for the instrument
panel with large central screen to display the various trip computer
tabs in succession.
With the large central screen
Instrument panel with small central screen
Instrument panel with large central screen
With the small central screen
System that gives you information on the journey in progress (range,
fuel consumption…).
Page 60 of 336
58
OPERATING FAULT
LOCKING THE VEHICLE WITHOUT ACTIVATING
THE ALARM
)
Lock or deadlock the vehicle using the key in the driver's door lock.
When the ignition is switched on, fi xed illumination of the indicator lamp
in the button indicates a fault with the system.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
FAILURE OF THE REMOTE CONTROL
To deactivate the monitoring functions:
)
unlock the vehicle using the key in the driver's door lock,
)
open the door; the alarm is triggered,
)
switch on the ignition; the alarm stops; the indicator lamp in the
button goes off.
TRIGGERING OF THE ALARM
The monitoring functions remain active until the alarm has been
triggered eleven times in succession.
When the vehicle is unlocked using the remote control, rapid
fl ashing of the indicator lamp in the button informs you that the
alarm was triggered during your absence. When the ignition is
switched on, this fl ashing stops immediately.
This is indicated by sounding of the siren and fl ashing of the direction
indicators for thirty seconds.
2 minutes after closing the last door or the boot, the system is activated
automatically.
)
To avoid triggering the alarm when entering the vehicle, fi rst press
the remote control unlocking button.
AUTOMATIC ACTIVATION *
* Depending on country of sale.
Page 107 of 336
5/
SAFETY
BRAKING ASSISTA NCE SYSTEMS
Group of supplementary systems which help you to obtain optimum
braking in complete safety in emergency situations:
- anti-lock braking system (ABS),
- electronic brake force distribution (EBFD),
- emergency braking assistance (EBA).
ANTI-LOCK BRAKING SYSTEM AND
ELECTRONIC BRAKE FORCE DISTRIBUTION
Linked systems which improve the stability and manoeuvrability of your
vehicle when braking, in particular on poor or slippery surfaces.
Activation
The anti-lock braking system comes into operation automatically when
there is a risk of wheel lock.
Normal operation of the ABS may make itself felt by slight vibration of
the brake pedal.
When braking in an emergency, press very fi rmly without releasing
the pressure.
Operating fault
If this warning lamp comes on, accompanied by an audible
signal and a message in the screen, it indicates a malfunction
of the anti-lock braking system which could result in loss of
control of the vehicle when braking. If this warning lamp comes on, together with the STOP
and
ABS
warning lamps, accompanied by an audible signal and
a message in the screen, it indicates a malfunction of the
electronic brake force distribution which could result in loss of control of
the vehicle when braking.
You must stop as soon as it is safe to do so.
In either case, contact a PEUGEOT dealer or a qualifi ed workshop.
When replacing wheels (tyres and rims), ensure that they conform
to the manufacturer's recommendations.
When braking in an emergency, press fi rmly without releasing the
pressure.
EMERGENCY BRAKING ASSISTANCE
System which, in an emergency, enables you to obtain the optimum
braking pressure more quickly, thus reducing the stopping distance.
Activation
It is triggered by the speed at which the brake pedal is pressed.
The effect of this is a reduction in the resistance of the pedal and an
increase in braking effi ciency.
Page 125 of 336
5/
SAFETY
ADVICE ON CHILD SEATS
Installing a booster seat
The chest part of the seat belt must be positioned on the child's
shoulder without touching the neck.
Ensure that the lap part of the seat belt passes correctly over the
child's thighs.
PEUGEOT recommends the use of a booster seat which has a back,
fi tted with a seat belt guide at shoulder level. The incorrect installation of a child seat in a vehicle compromises
the child's protection in the event of an accident.
When installing a child seat using the seat belt, ensure that the
seat belt is tightened correctly on the child seat and that it secures
the child seat fi rmly on the vehicle's seat.
Remember to fasten the seat belts or the child seat harnesses
keeping
the slack
in relation to the child's body to a minimum
,
even for short journeys.
For optimum installation of the "forward facing" child seat, ensure
that the back of the child seat is in contact with the back of the
vehicle's seat and that the head restraint does not cause any
discomfort.
Children under the age of 10 must not travel in the "forward
facing" position on the front passenger seat, unless the rear seats
are already occupied by other children, cannot be used or are
absent.
Deactivate the passenger airbag when a "rear facing" child seat
is installed on the front seat. Otherwise, the child would risk being
seriously injured or killed if the airbag were to infl ate. As a safety precaution, do not leave:
- one or more children alone and unsupervised in a vehicle,
- a child or an animal in a vehicle which is exposed to the sun,
with the windows closed,
- the keys within reach of children inside the vehicle.
Page 186 of 336
184
ENGINE COMPARTMENT FUSES
The fusebox is placed in the engine compartment near the battery (left-
hand side).
Access to the fuses
)
Unclip the cover.
)
Change the fuse (see corresponding paragraph).
)
When you have fi nished, close the cover carefully to assure the
sealing of the fusebox.
Fuse table
Fuse N°
Rating
Functions
F1
20 A
Engine control unit supply, injection
pump and EGR electrovalves (Diesel),
injectors (Diesel).
F2
15 A
Horn.
F3
10 A
Front wash-wipe.
F4
20 A
Daytime running lamps.
F5
15 A
Air fl ow sensor, coolant pump, oil pump,
thermostat, blow-by heater (petrol),
by-pass and EGR electrovalves (Diesel),
diesel heater (Diesel).
F6
10 A
Steering wheel angle sensor, ABS/ESC
control unit, ESC sensor.
F7
10 A
Power steering control unit, automatic
gearbox, engine coolant level detector,
dual function brake switch.
F8
25 A
Starter motor control.
F9
10 A
Diagnostic socket, directional
headlamps, particle emission fi lter pump
(Diesel).
F10
30 A
Engine control unit actuators (petrol:
ignition coils, electrovalves, injectors,
fuel pump (Diesel: electrovalves,
heaters).
F11
40 A
Air conditioning blower.
Page 188 of 336
186
Table of fuses over the battery
Fuse N°
Rating
Functions
F1
-
Not used.
F2
5 A
Dual function brake switch.
F3
5 A
Battery charge unit.
F4
25 A
ABS/ESC electrovalves.
F5
-
Not used.
F6
15 A
Automatic gearbox. All work on the other types of fuses (midi-fuses and maxi-fuses)
must only be done by a PEUGEOT dealer or a qualifi ed workshop.