2012.5 Peugeot RCZ Owner's Manual - RHD (UK, Australia)

2/
ACCESS

Pressing the central locking control unlocks the vehicle.
Opening a door from the inside, when stationary, also unlocks
the vehicle, but the vehicle will be locked again when the speed
exceeds 6 mph (10 km/h).


Activation / Deactivation

You can activate or deactivate this function.


)
With the ignition on, press the button for more than two seconds.
A confi rmation message appears in the screen.

In the event of a serious impact with deployment of an airbag, the
vehicle's doors unlock automatically to allow the occupants to leave the
vehicle.











EMERGENCY LOCKING

To lock or unlock the doors mechanically in the event of a central
locking system failure or fl at battery.


Locking the driver's door



)
Insert the key in the lock, then turn it to the right.



Unlocking the driver's door



)
Insert the key in the lock, then turn it to the left.



Locking the passenger door



)
Using the key, remove the black cap on the edge of the door.

)
Insert the key in the cavity without forcing, then without turning it,
move the the latch sideways towards the interior of the door.

)
Remove the key and refi t the cap.



Unlocking the passenger door



)
Pull the interior door opening control.




ANTI-INTRUSION SECURITY

This function permits automatic and simultaneous locking of the doors,
boot lid and fuel fi ller fl ap as soon as the vehicle speed exceeds 6 mph
(10 km/h).

Operation

If one of the doors is open, the automatic central locking does not take
place.
If the boot lid is open, the automatic central locking of the doors is
active.

64
BOOT

OPENING



)
Press this button for more than two seconds to unlock
the boot lid. The boot lid opens slightly.

)
Lift the boot lid.
This action also unlocks the doors and the fuel fi ller fl ap.




Using the manual control; vehicle unlocked



)
Press the opening control above the number plate.

)
Lift the boot lid.




CLOSING



)
Lower the boot lid using one of the interior grab handles.

)
If necessary, press the top of the boot lid to close it fully.
If the boot lid is not closed correctly:


- when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
When selective unlocking is activated, the boot can also be
opened by a second press on the open padlock on the remote
control.

Using the remote control

Emergency locking

If the central locking system fails (fl at battery), you are advised to
disconnect the battery.

- when the vehicle is moving
(speed above 6 mph (10 km/h)), this
warning lamp comes on, accompanied by an audible signal and a
message in the screen for a few seconds.

3/
EASE OF USE and COMFORT
FRONT SEATS
Seat with integral head restraint, consisting of a seat cushion and a seat
back which can be adjusted to adapt your position for ease of driving
and comfort.

MANUAL ADJUSTMENTS


Forwards-backwards adjustment
Driver's or passenger's seat height adjustment

Seat back angle adjustment



)
Raise the control bar and slide the seat forwards or backwards.


)
Pull the control lever upwards to raise or push it downwards to
lower, as many times as necessary, to obtain the position required.



)
Turn the knob to set the angle required.

66
FRONT SEATS
Seat with integral head restraint, consisting of a seat cushion and a
seat back which can be adjusted to adapt your position for ease of
driving and comfort.


ELECTRIC ADJUSTMENTS


Forwards-backwards adjustment
Seat cushion height adjustment



)
Push the control forwards or rearwards to slide the seat.


)
Tilt the rear part of the control upwards or downwards to obtain
the required height.

The electrical functions of the seat are deactivated approximately
one minute after the ignition is switched off.
To reactivate them, switch on the ignition.



Seat back angle adjustment



)
Tilt the control forwards or rearwards to adjust the angle of the
seat back.

3/
EASE OF USE and COMFORT

MANUAL LUMBAR ADJUSTMENT



)
Turn the knob manually to obtain the desired level of lumbar
support.












Heated seats control

With the engine running, the front seats can be heated separately.


)
Use the adjustment dial, placed on the side of each front seat, to
switch on and select the level of heating required:

0
:
Off.

1
:
Low.

2
:
Medium.

3
:
High.

68
STORING DRIVING POSITIONS
System which takes into account the electrical settings of the driver's
seat and the door mirrors. It enables you to store two positions using
the buttons on the side of the driver's seat.

STORING A POSITION


Using buttons M / 1 / 2



)
Switch on the ignition.

)
Adjust your seat and your door mirrors.

)
Press button M
, then press button 1
or 2
within four seconds.
An audible signal is heard indicating that the settings have
been stored.


RECALLING A STORED POSITION

Storing a new position cancels the previous position.



Using button 1 or 2



)
Press and hold button 1
or 2
until the audible signal is heard
indicating the end of the adjustment.
When the ignition is off, after a few consecutive position recalls,
the function will be deactivated until the engine is started, to
prevent discharging of the battery.

3/
EASE OF USE and COMFORT
STEERING WHEEL ADJUSTMENT



)
When stationary
, pull the control lever to release the adjustment
mechanism.

)
Adjust the height and reach to suit your driving position.

)
Push the control lever to lock the adjustment mechanism.
As a safety precaution, these operations should only be carried
out while the vehicle is stationary.

70
MIRRORS

DOOR MIRRORS

Each fi tted with an adjustable mirror glass permitting the lateral
rearward vision necessary for overtaking or parking. They can be
folded electrically.

Demisting - defrosting

The demisting-defrosting of the door mirrors is effected with
the engine running, by switching on the heated rear screen
(refer to the "Demisting-defrosting the rear screen" section).


Adjustment



)
Move control A
to the right or to the left to select the corresponding
mirror.

)
Move control B
in all four directions to adjust.

)
Return control A
to the central position.
The objects observed are, in reality, closer than they appear.
Take this into account in order to correctly judge the distance of
vehicles approaching from behind.