2011 YAMAHA YFM700R low beam

Checking the shift pedal ........................... 8-40
Checking and lubricating the brake
pedal ...................................................... 8-40
Checking the wheel hub bearings ............ 8-40
Lubricating the swingarm pivots ............... 8-41
Lubricating the rear suspension relay arm
and connecting arm pivoting points ........ 8-41
Lubricating the upper and lower arm
pivots ...................................................... 8-42
Lubricating the steering shaft ................... 8-43
Battery ...................................................... 8-43
Replacing a fuse ...................................... 8-46
Replacing a headlight bulb ....................... 8-48
Adjusting a headlight beam ...................... 8-49
Tail/brake light .......................................... 8-50
Removing a wheel .................................... 8-50
Installing a wheel ...................................... 8-50
Troubleshooting ....................................... 8-51
Troubleshooting charts ............................. 8-52
CLEANING AND STORAGE .......................... 9-1
Cleaning ..................................................... 9-1
Storage ....................................................... 9-2SPECIFICATIONS .......................................10-1
CONSUMER INFORMATION.......................11-1
Identification numbers ...............................11-1
U1AS61E0.book Page 3 Thursday, February 11, 2010 2:17 PM

4-6
4
EBU18080Engine stop switch“/”
Set this switch to“” before starting the engine.
The engine stop switch controls the ignition and
stops the engine when it is running. Use this switch
to stop the engine in an emergency situation. The
engine will not start or run when this switch is set
to“”.EBU18101Start switch“”
Push this switch to crank the engine with the start-
er. See the starting instructions on page 6-1 prior
to starting the engine.EBU18152Light switch“//OFF”
Set this switch to“” to turn on the low beams
and the taillight. Set the switch to“” to turn on
the high beams and the taillight. Set the switch to
“OFF” to turn off all the lights.NOTICEECB00041Do not use the headlights with the engine
turned off for an extended period of time, oth-
erwise the battery may discharge to the point
that the starter motor will not operate properly.If this should happen, remove the battery and
recharge it. See page 8-43 for battery charging
information.
EBU18282Throttle lever Once the engine is running, pushing the throttle le-
ver will increase the engine speed.
Regulate the speed of the ATV by varying the
throttle position. Because the throttle is spring-
loaded, the ATV will decelerate, and the engine will
return to an idle any time the throttle lever is re-
leased.1. Throttle lever
1
U1AS61E0.book Page 6 Thursday, February 11, 2010 2:17 PM

8-50
8 To raise a headlight beam, turn the headlight beam
adjusting bolt in direction (a).
To lower a headlight beam, turn the adjusting bolt
in direction (b).
EBU26920Tail/brake light This model is equipped with an LED type of
tail/brake light.
If the tail/brake light does not come on, have a
Yamaha dealer check it.EBU25651Removing a wheel 1. Place the ATV on a level surface.2. Loosen the wheel nuts.
3. Elevate the ATV and place a suitable stand
under the frame.
4. Remove the nuts from the wheel.
5. Remove the wheel.
EBU27481Installing a wheel 1. Place the ATV on a level surface.
2. Install the wheel and the nuts.
1. Headlight beam adjusting bolt1
(a)(b)
1. Wheel nut
U1AS61E0.book Page 50 Thursday, February 11, 2010 2:17 PM