2011 YAMAHA FX SHO fuses
[x] Cancel search: fusesPage 6 of 112
Table of contents
Transporting on a trailer ............... 59
First-time operation......................... 60
Engine break-in ............................ 60
Pre-operation checks ...................... 61
Pre-operation checklist .................... 61
Pre-operation check points .......... 63
Pre-launch checks ........................... 63
Post-launch checks ......................... 69
Operation ......................................... 71
Operating your watercraft ............. 71
Getting to know your watercraft ....... 71
Learning to operate
your watercraft ............................. 71
Riding position ................................. 72
Launching the watercraft ................. 72
Starting the engine on water ........... 72
Stopping the engine ........................ 73
Leaving the watercraft ..................... 73
Operating the watercraft .................. 73
Turning the watercraft ..................... 74
Stopping the watercraft ................... 75
Operating the watercraft
in reverse ..................................... 76
Boarding the watercraft ................... 76
Starting off ....................................... 79
Capsized watercraft ......................... 80
Beaching and docking
the watercraft ............................... 81
Operating in weeded areas ............. 82
After removing the watercraft
from the water .............................. 82
Care and storage ............................. 83
Post-operation care ...................... 83
Flushing the cooling water
passages ...................................... 83
Cleaning the watercraft ................... 84
Battery care ..................................... 84
Long-term storage ........................ 87
Cleaning .......................................... 87
Lubrication ....................................... 87Rustproofing .................................... 88
Maintenance .................................... 89
Maintenance ................................ 89
Tool kit ............................................. 89
Removing and installing the engine
cover ............................................ 89
Periodic maintenance chart ............. 91
Engine oil and oil filter ..................... 92
Specifications.................................. 93
Specifications ................................ 93
Trouble recovery ............................. 94
Troubleshooting ........................... 94
Troubleshooting chart ...................... 94
Emergency procedures ................ 97
Cleaning the jet intake and
impeller ........................................ 97
Jumping the battery ......................... 98
Replacing the fuses ......................... 98
Replacing the bilge pump fuse ...... 100
Towing the watercraft .................... 101
Submerged watercraft ................... 102
UF1W73E0.book Page 2 Monday, June 7, 2010 9:17 AM
Page 104 of 112
Trouble recovery
98
(2) Remove any weeds or debris from
around the jet intake, drive shaft, impel-
ler, jet pump housing, and jet thrust noz-
zle.
If debris is difficult to remove, consult a
Yamaha dealer.
EJU34641Jumping the battery
If the watercraft battery has run down, the en-
gine can be started using a 12-volt booster
battery and jumper cables.
EJU34663Connecting the jumper cables
WARNING
EWJ01250
To avoid battery explosion and serious
damage to the electrical system:
Do not reverse the polarity of the jumper
cables when connecting to the batteries.
Do not connect the negative (–) jumper
cable to the negative (–) terminal of the
watercraft battery.
Do not touch the positive (+) jumper ca-
ble to the negative (–) jumper cable.
(1) Connect the positive (+) jumper cable to
the positive (+) battery terminals of both
batteries.
(2) Connect one end of the negative (–)
jumper cable to the negative (–) battery
terminal of the booster battery.(3) Connect the other end of the negative (–)
jumper cable to an engine hanger.
(4) Start the engine, and then disconnect the
jumper cables by reversing the steps
above. (See page 28 for information on
starting the engine.)
EJU36994Replacing the fuses
If a fuse is blown, replace it with the proper
fuse.
To replace a fuse:
(1) Remove the seats. (See page 47 for seat
removal and installation procedures.)
1Negative (–) jumper cable
2Positive (+) jumper cable
3Booster battery
4Engine hanger
1Good fuse
2Blown fuse
12
3
4
2 1
UF1W73E0.book Page 98 Monday, June 7, 2010 9:17 AM
Page 105 of 112
Trouble recovery
99
(2) Remove the electrical box cover.
(3) Loosen the cap on the electrical box and
remove it.
(4) Replace the blown fuse with the spare
fuse of the correct amperage by using the
fuse puller on the reverse side of the cap.
WARNING! Do not use fuses of a dif-
ferent amperage than recommended.
Substitution with a fuse that has an
improper rating can cause extensiveelectrical system damage and possi-
ble fire.
[EWJ00802]
(5) Securely install the cap by tightening it
until it stops.
(6) Securely install the electrical box cover in
its original position.
1Electrical box cover
1
1Electrical box
2Spare fuse
3Fuse
4Cap
1Fuse puller
Fuse amperage:
Battery fuse:
30 A
Main relay drive fuse:
10 A
Electronic throttle valve fuse:
10 A
Security system fuse:
3 A
Main fuse:
20 A
1
43 2
UF1W73E0.book Page 99 Monday, June 7, 2010 9:17 AM
Page 106 of 112
Trouble recovery
100
(7) Securely install the seats in their original
positions.
If the fuse immediately blows again, the elec-
trical system may be defective. If this occurs,
have a Yamaha dealer service the watercraft.
EJU41820Replacing the bilge pump fuse
If the fuse is blown, replace it with the proper
fuse.
To replace the fuse:
(1) Remove the seats and engine cover.
(See page 47 for seat removal and instal-
lation procedures and page 89 for engine
cover removal and installation proce-
dures.)
(2) Remove the plastic ties that are securing
the corrugated tube and bilge pump fuse
leads.
TIP:
Be careful not to drop the plastic ties into the
engine compartment.
(3) Pull out the bilge pump fuse holder from
the rubber cover, and then remove the
fuse cover.
(4) Replace the blown fuse with the spare
fuse of the correct amperage.
WARNING! Do not use fuses of a dif-
ferent amperage than recommended.
Substitution with a fuse that has an
improper rating can cause extensive
electrical system damage and possi-
ble fire.
[EWJ00802]
TIP:
If the fuse is difficult to remove, use the fuse
puller on the reverse side of the electrical box
1Good fuse
2Blown fuse
2 1
1Bilge pump fuse lead
2Plastic tie
3Corrugated tube
213
UF1W73E0.book Page 100 Monday, June 7, 2010 9:17 AM
Page 109 of 112
Index
A
Adjustable tilt steering system.................. 30
Adjustable tilt steering system checks ..... 65
After removing the watercraft
from the water ....................................... 82
Analog speedometer/tachometer ............. 39
B
Battery care .............................................. 84
Battery checks.......................................... 64
Battery, jumping ....................................... 98
Beaching and docking the watercraft ....... 81
Beverage holder ....................................... 53
Bilge pump fuse, replacing ..................... 100
Bilge water check ..................................... 64
Bilge water, draining................................. 57
Bilge water, draining on land .................... 57
Bilge water, draining on water .................. 58
Boarding alone ......................................... 77
Boarding and starting off from a dock ...... 80
Boarding the watercraft ............................ 76
Boarding with passenger(s) ..................... 77
Bow eye ................................................... 49
Bow storage compartment ....................... 50
Builder’s plate............................................. 2
C
Capsized watercraft ................................. 80
Check engine warning.............................. 44
Cleaning ................................................... 87
Cleaning the watercraft ............................ 84
Cleat ......................................................... 49
Cooling water pilot outlet check ............... 70
Cooling water pilot outlets ........................ 30
Craft Identification Number (CIN) ............... 1
Cruise assist............................................. 36
Cruising limitations ................................... 11
D
Digital speedometer ................................. 40
E
Emergency procedures ............................ 97
Engine break-in ........................................ 60
Engine compartment check...................... 63
Engine cover, removing and installing ..... 89
Engine idling speed check ....................... 70
Engine oil ................................................. 56
Engine oil and oil filter .............................. 92Engine oil level check............................... 64
Engine oil requirements ........................... 56
Engine overheat warning ......................... 43
Engine serial number ................................. 1
Engine shut-off cord (lanyard) check ....... 67
Engine shut-off switch .............................. 28
Engine stop switch ................................... 28
Engine unit check ..................................... 64
Enjoy your watercraft responsibly ............ 19
Equipment ................................................ 47
F
Fire extinguisher check ............................ 68
Fire extinguisher container ....................... 53
Fire extinguisher container checks ........... 68
Flushing the cooling water passages ....... 83
Fuel .......................................................... 54
Fuel level check ....................................... 63
Fuel level meter ........................................ 42
Fuel level warning .................................... 42
Fuel requirements .................................... 54
Fuel system checks .................................. 63
Fuses, replacing ....................................... 98
G
Getting to know your watercraft ............... 71
Glossary, watercraft ................................. 21
Glove compartment .................................. 51
H
Handgrip ................................................... 48
Hazard information ................................... 15
Hood check .............................................. 69
Hour meter/voltmeter ............................... 41
Hull and deck check ................................. 69
I
Identification numbers ................................ 1
Information display ................................... 40
J
Jet intake and impeller, cleaning .............. 97
Jet intake checks ...................................... 69
Jumper cables, connecting ...................... 98
L
Labels, important ........................................ 3
Labels, other .............................................. 8
Labels, warning .......................................... 4
Launching the watercraft .......................... 72
Learning to operate your watercraft ......... 71
UF1W73E0.book Page 1 Monday, June 7, 2010 9:17 AM