2011 VOLKSWAGEN CC rear latch

Unlocking and opening with the vehicle key
Press and hold the q button on the remote control vehicle key
⇒ fig. 33 A to unlatch and automatically open the luggage compart-
ment lid.
Unlocking and opening with the unlock switch in the driver door
Pull up the q switch on the driver door ⇒ fig. 33 B until the luggage
compartment lid opens automatically.
The switch in the driver door also works when the ignition is switched
off.
Unlocking and opening with the sensor-controlled luggage
compartment lid opener (Easy Open)
If your vehicle has Keyless Access, it may also be equipped with the
Easy Open feature. With Easy Open, the luggage compartment lid
can be opened with a motion sensor in the area below the rear
bumper ⇒ Sensor-controlled luggage compartment lid opener (Easy
Open).
Opening with the Volkswagen emblem
Unlock the vehicle or the luggage compartment lid, or open a door.
Using your thumb, press the top of the Volkswagen emblem
⇒ fig. 34 and move the top of the emblem down. The luggage com-
partment lid opens automatically.
WARNING
Improper or unsupervised unlocking or opening of the luggage
compartment lid can cause severe injuries. Never open the lug-
gage compartment lid when someone is in the way.
If a bicycle or luggage rack is installed on the luggage com-
partment lid, it may be hard to see that the luggage compart-
ment lid is unlatched. An unlatched luggage compartment lid
may open suddenly when the vehicle is moving.
At temperatures below +32 °F (0 °C), the luggage compartment
lid may not open automatically after you unlock it. It will be necessary
to lift it by hand.

d Check the condition of all safety belts regularly.
d Keep safety belts clean.
d Keep objects and liquids away from safety belt webbing, the safety
belt buckle tongue, and the safety belt buckle latch and opening.
d Do not pinch or damage the safety belt or buckle tongue (for in-
stance, when closing a door).
d Never modify, disassemble or try to repair safety belts and safety
belt anchorages.
d Always fasten your safety belt properly before driving and keep it
fastened whenever the vehicle is moving.
Twisted safety belt
If it is difficult to pull the safety belt out of the belt guide, the belt may
be twisted inside the side trim because the belt retracted too quickly
when it was taken off.
Hold the safety belt tongue, slowly and carefully pull safety belt all
the way out.
Untwist the safety belt and slowly return the belt by hand.
If you cannot untwist the safety belt, wear it anyway. Make sure that
the safety belt is twisted in a spot where it does not come in direct
contact with your body. Have the safety belt untwisted immediately by
an authorized Volkswagen dealer or authorized Volkswagen Service
Facility.
Lockable safety belt
The retractors for the rear seat safety belts and the front passenger
safety belt have a switchable locking feature for child restraints in
addition to the emergency locking feature. Whenever a child restraint
is installed with a safety belt, the safety belt must be locked so that
the safety belt webbing cannot unreel. The switchable locking feature
lets you lock the belt so that a child restraint can be properly installed
and, for example, so that it can't tip to the side when the vehicle goes
around a corner ⇒  Child safety and child restraints.
To see whether a safety belt is lockable, pull the safety belt all the
way out of the safety belt retractor. You should then hear a “clicking”
sound as the belt winds back into the retractor reel. Test the switcha-
ble locking feature by pulling on the belt. When the switchable locking

WARNING
Heavy loads will influence the way your vehicle handles and
increase stopping distances. Heavy loads that are not properly
stowed or secured can cause loss of control and serious injury.
Secure the load properly to keep it from shifting.
Always remember when transporting heavy objects that a
change in the center of gravity also changes the way your vehi-
cle handles:
– Always distribute the load as evenly as possible.
– Secure heavy objects properly as far forward in the lug-
gage compartment as possible.
– Always tie down heavy items securely with suitable straps
using the tie-downs in the luggage compartment.
Securely latch the rear seat backrest in the upright position.
Never exceed the Gross Axle Weight Rating or the Gross Ve-
hicle Weight Rating on the safety compliance sticker on the left
door jamb. Exceeding permissible weight can cause the vehicle
to skid and handle differently.
Always adapt your speed and driving to the heavier load and
the weight distribution in the vehicle. Take road, weather, traf-
fic, and visibility conditions into account as well.
Always accelerate gently and avoid sudden braking and driv-
ing maneuvers.
Always brake earlier than you would if you were not driving a
loaded vehicle.
Stowing luggage

Brake earlier than you would if you were not driving a loaded vehi-
cle.
If applicable, observe information about driving with a trailer ⇒ 
Trailer towing.
If applicable, observe information about driving with a roof rack ⇒ 
Roof rack.
WARNING
Heavy loads can change the way your vehicle handles and in-
crease stopping distances. Heavy loads that are not properly
stowed or secured can shift suddenly, causing loss of control
and serious injury.
Secure the load properly to keep it from shifting.
Always remember when transporting heavy objects that they
change the vehicle's center of gravity and also the way it han-
dles.
– Always distribute the load as evenly as possible.
– Secure heavy objects as far forward in the luggage com-
partment as possible.
– Secure luggage in the luggage compartment using suitable
straps and the tie downs ⇒ Tie-downs. Also see ⇒  Luggage
compartment.
Always tie down heavy items securely with suitable straps.
Securely latch the rear seat backrest in the upright position.
Never exceed the Gross Axle Weight Rating or the Gross Ve-
hicle Weight Rating on the safety compliance sticker on the left
door jamb. Exceeding permissible weight can cause the vehicle
to skid and handle differently.
Always adapt speed and driving to the heavier load and the
weight distribution in the vehicle. Take road, weather, traffic,
and visibility conditions into account as well.
Always accelerate gently and avoid sudden braking and driv-
ing maneuvers.
Always brake earlier than you would if you were not driving a
loaded vehicle.

Pull the release button (1) forward while folding the rear seat
backrest forward.
The rear seat backrest is unlocked when the red mark on the but-
ton (2) is visible.
The rear seat backrest is released and can be folded forward.
If the rear backrest is folded down, no one, including children, may
ride on the rear seat.
Folding the rear seat backrest forward with the release lever in
the luggage compartment
Push the head restraint all the way down ⇒  Adjusting the seating
position.
Open the luggage compartment lid ⇒  Luggage compartment lid.
Pull the remote release lever for the left ⇒ fig. 101 (1) or right (2)
rear seat backrest in the direction of the arrow. The unlocked section
of the rear seat folds forward automatically.
Close the luggage compartment lid, if necessary ⇒  Luggage com-
partment lid.
The rear seat backrest is unlocked when the red mark on the but-
ton ⇒ fig. 100 (2) is visible.
If the rear backrest is folded down, no one, including children, may
ride on the rear seat.
Folding the rear seat backrest back into place
Fold the rear seat backrest back until it engages securely ⇒ .
The red mark on the release button (2) should no longer be visible.
The rear seat backrest must be securely latched into place in order
for the safety belts on the rear seats to provide optimal protection.

WARNING
Improper folding and improper latching of the rear seat
backrest can cause serious personal injury.
Always make sure there are no people or animals in the area
around the rear seat backrest when folding it forward.
Never fold the rear seat backrest forward or back while the
vehicle is moving.
When folding the rear seat backrest back up, make sure that
the safety belt does not get caught or damaged.
Keep hands, fingers, feet and other body parts out of the way
when folding the rear seat backrest forward or back.
Each rear seat backrest must be securely latched in the up-
right position so that the safety belts on the rear seats can pro-
vide protection. This is particularly the case for the middle seat
on the rear seat bench.
If a seat is used with an unsecured backrest, the passenger
will move forward together with the rear seat backrest during
sudden braking, driving maneuvers, or in a collision.
If the red marking on the button (2) is visible, this indicates
that the backrest is not latched into place. Always check to
make sure that the red marking is not visible whenever the rear
seat backrest is in the upright position.
No one, including children, may ride on the rear seats if the
rear seat backrest is folded down or not correctly latched.
NOTICE
Before folding the rear seat backrest forward, adjust the front
seats so that the rear seat's head restraint or backrest cushion
will not touch the front seats.

Opening the fuel filler cap
Pull the release switch  in the driver door upwards ⇒ fig. 161.
The fuel filler flap is on the right rear side of the vehicle.
Open the fuel filler flap.
Unscrew the fuel cap counterclockwise and remove. Use the slot or
the upper edge of the fuel filler flap to hold the cap while refueling
⇒ fig. 162.
Refueling
The correct fuel grade for your vehicle ⇒  Fuel is listed on a sticker on
the inside of the fuel filler flap ⇒ fig. 162 (arrow).
The fuel tank is full when the automatic filler nozzle pump switches
off the first time ⇒ .
Do not try to add fuel after the pump stops! Topping off the tank in
this way may fill the expansion space that the tank needs and cause
fuel to overflow, for example, if it gets warmer outside.
Closing the fuel filler cap
Screw the fuel cap clockwise onto the fuel filler neck until you hear
it click into place.
Close the fuel filler flap until you hear it latch shut. The fuel filler
flap must be flush with the vehicle body.
WARNING
Spilled fuel can cause fires, explosions, burns, and other se-
vere injuries.
Always stop refueling once the pump nozzle switches off so
that the tank does not overflow.
NOTICE
Remove fuel spills from all vehicle surfaces immediately to help
prevent damage to the paint, tires, and wheel housings.
Fuel spills may pollute the environment.