2011 TOYOTA URBAN CRUISER oil change

174 2-1. Driving procedures
URBAN CRUISER_EE (OM52C21E)
NOTICE
If you get a flat tire while driving
A flat or damaged tire may cause the following situations. Hold the steering
wheel firmly and gradually press the brake pedal to slow down the vehicle.
It may be difficult to control your vehicle.
The vehicle will make abnormal sounds or vibrations.
The vehicle will lean abnormally.
Information on what to do in case of a flat tire. (P. 437, 452)
When encountering flooded roads
Do not drive on a road that has flooded after heavy rain etc. Doing so may
cause the following serious damage to the vehicle.
Engine stalling
Short in electrical components
Engine damage caused by water immersion
In the event that you drive on a flooded road and the vehicle is flooded, be
sure to have any authorized Toyota dealer or repairer, or another duly quali-
fied and equipped professional check the following.
Brake function
Changes in quantity and quality of oil and fluid used for the engine, trans-
mission, transfer (4WD models), differential (4WD models), etc.
Lubricant condition for the propeller shaft (4WD models), bearings and
suspension joints (where possible) and the function of all joints, bearings,
etc.

363 4-3. Do-it-yourself maintenance
4
Maintenance and care
URBAN CRUISER_EE (OM52C21E)
After changing the engine oil (diesel engine only)
The oil change system should be reset. Perform the following procedures:
Vehicles without smart entry & start system
Switch the display to trip meter A (P. 190) when the engine is run-
ning.
Turn the engine switch to the “LOCK” position.
While pressing the “MODE” button, set the engine switch to the
“ON” position (but do not start the engine because otherwise the
reset mode will be canceled). Continue to press and hold the button
until the multi-information display indicates that the reset is com-
plete.
Vehicles with smart entry & start system
Switch the display to trip meter A (P. 190) when the engine is run-
ning.
Turn the “ENGINE START STOP” switch OFF.
While pressing the “MODE” button, set the “ENGINE START
STOP” switch to the IGNITION ON mode (but do not start the
engine because otherwise the reset mode will be canceled). Con-
tinue to press and hold the button until the multi-information display
indicates that the reset is complete.
STEP1
STEP2
STEP3
STEP1
STEP2
STEP3

432 5-2. Steps to take in an emergency
URBAN CRUISER_EE (OM52C21E)
Warning lightWarning light/DetailsCorrection procedure
(Flashes)Engine oil change
reminder light
(diesel engine)
Check the engine oil, and
change if necessary. After
changing the engine oil, the
oil change system should
be reset. (P. 363) Indicates that the engine
oil is scheduled to be
changed.
Flashes approximately
14500 km (9000 miles)
after the engine oil is
changed. (The indicator
will not work properly
unless the oil mainte-
nance date has been
reset.)
Indicates that the engine
oil should be changed.
• Flashes while you are
driving.
• Vehicles without smart
entry & start system:
Flashes for about 12
seconds when the
engine switch turned to
the “ON” position.
• Vehicles with smart
entry & start system:
Flashes for about 12
seconds when the
“ENGINE START
STOP” switch turned to
the IGNITION ON
mode.

5
433 5-2. Steps to take in an emergency
When trouble arises
URBAN CRUISER_EE (OM52C21E)
*:Driver’s and front passenger’s seat belt reminders:
The driver’s and front passenger’s seat belts reminder sounds to alert the
driver and front passenger that his/her seat belt is not fastened. The buzzer
sounds for 30 seconds after the vehicle has reached a speed of at least 20
km/h (12 mph). Then, if the seat belt is still unfastened, the buzzer will sound
in a different tone for 90 more seconds.
Warning lightWarning light/DetailsCorrection procedure
(Comes on)Engine oil change
reminder light
(diesel engine)
Indicates that the engine
oil is should be changed.
Comes on approximately
15000 km (9300 miles)
after the engine oil
changed (and the oil main-
tenance date has been
reset).Check and change the
engine oil and oil filter by
any authorized Toyota
dealer or repairer, or
another duly qualified and
equipped professional.
(P. 363)

500 6-1. Specifications
URBAN CRUISER_EE (OM52C21E)Recommended viscosity (SAE):
SAE 0W-20 is filled into your
Toyota vehicle at manufacturing,
and the best choice for good fuel
economy and good starting in
cold weather.
If SAE 0W-20 oil is not available,
SAE 5W-30 oil may be used.
However, it should be replaced
with SAE 0W-20 at the next oil
change.
If you use SAE 10W-30 or a
higher viscosity engine oil in
extremely low temperatures, the
engine may become difficult to
start, so SAE 5W-30 or lower vis-
cosity engine oil is recom-
mended.
Oil viscosity (0W-20 is explained here as an example):
• The 0W in 0W-20 indicates the characteristic of the oil which allows
cold startability. Oils with a lower value before the W allow for easier
starting of the engine in cold weather.
• The 20 in 0W-20 indicates the viscosity characteristic of the oil when
the oil is at high temperature. An oil with a higher viscosity (one with a
higher value) may be better suited if the vehicle is operated at high
speeds, or under extreme load conditions.
Temperature range anticipated before
next oil change.
Preferred

503 6-1. Specifications
6
Vehicle specifications
URBAN CRUISER_EE (OM52C21E)Recommended viscosity (SAE):
SAE 0W-30 is filled into your
Toyota vehicle at manufacturing,
and the best choice for good fuel
economy and good starting in
cold weather.
Oil viscosity (0W-30 is explained here as an example):
• The 0W in 0W-30 indicates the characteristic of the oil which allows
cold startability. Oils with a lower value before the W allow for easier
starting of the engine in cold weather.
• The 30 in 0W-30 indicates the viscosity characteristic of the oil when
the oil is at high temperature. An oil with a higher viscosity (one with a
higher value) may be better suited if the vehicle is operated at high
speeds, or under extreme load conditions.
Temperature range anticipated before
next oil change.
Preferred

526 Alphabetical index
URBAN CRUISER_EE (OM52C21E)
Traction control ....................... 217
TRC ........................................... 217
Trip information display .......... 196
Trip meter ................................. 190
Turn signal lights
Replacing light bulbs ............. 406
Switch ................................... 187
Wattage................................. 510
Vanity mirrors .......................... 329
Vehicle identification
number ................................... 495
Vehicle stability control .......... 217
VSC ........................................... 217
Warning buzzers
Brake system ........................ 427
Seat belt reminder................. 430
Warning lights
Active Torque Control
4WD system ....................... 428
Anti-lock brake system .......... 428
Brake system ........................ 427
Charging system ................... 428
Electric power steering.......... 428
Engine oil change
reminder light ...................... 430
Fuel filter ............................... 428
High engine coolant
temperature ........................ 428
Low engine oil level............... 430
Low engine oil pressure ........ 428
Low fuel level ........................ 430
Malfunction indicator lamp .... 428
Open door ............................. 430
Seat belt reminder light ......... 430
Slip indicator ......................... 428
Smart entry & start system.... 434
SRS airbags .......................... 428
VSC OFF indicator ................ 428Washer
Checking ............................... 373
Preparing and checking
before winter....................... 227
Switch ........................... 207, 209
Washing and waxing ............... 340
Weight....................................... 494
Wheels ...................................... 380
Window glasses ........................ 99
Window lock switch .................. 99
Windows
Power windows ....................... 99
Rear window defogger .......... 262
Washer ......................... 207, 209
Windshield wipers ................... 207
Wireless remote control key
Replacing the battery .... 387, 386
Wireless remote control key ... 56
WMA disc ................................. 277
V
W

530 What to do if...
URBAN CRUISER_EE (OM52C21E)
Warning lights
P. 4 2 7P. 429
P. 4 2 8P. 430
P. 4 2 8P. 430
P. 4 2 8P. 430
P. 4 2 9P. 431
P. 4 2 9P. 431
P. 4 2 9P. 431
P. 4 2 9P. 432
P. 4 2 9P. 434
Brake system warning
lightFuel filter warning light
Charging system warn-
ing lightOpen door warning light
Low engine oil pressure
warning light Low fuel level warning
light
High engine coolant
temperature
warning lightDriver’s seat belt
reminder light
Malfunction indicator
lamp
Rear passengers’ seat
belt reminder lightsSRS warning light
ABS warning lightLow engine oil level
warning light
Electric power steering
warning lightEngine oil change
reminder light
Smart entry & start system
warning lightActive Torque Control
4WD system warning
light Front passenger’s seat
belt reminder light