2011 TOYOTA MATRIX ignition

2
OVERVIEW

Steering wheel audio controls
Telephone controls*
Voice command button*
Ignition switch
Cruise control*
VSC/TRAC OFF switch
Auxiliary storage
Power outside rearview mirror control
Headlight, turn signal and front fog light* controls
Wiper and washer controls
“AIR BAG ON” and “AIR BAG OFF” indicator
Steering wheel controls
414843M2.qxd:414843M2 11/18/10 9:44 AM Page 2

8
FEATURES/OPERATIONS

* The ignition switch must be “ON” and the brake pedal depressed to shift from Park.
Shift the shift lever to “S” position from “D” position.
+: Upshift (push and release)
-: Downshift (pull and release)
Downshifting increases power going uphill, or provides engine braking
downhill. For best fuel economy during normal driving conditions, always
drive with the shift lever in the “D” position.

3
2L

Park*
Reverse
Neutral
Drive
“S” mode
Park*
Reverse
Neutral
Drive
Third gear
Second gear
First gear



“S”“D”
Automatic door locks can be programmed to operate in three different
modes, or turned OFF.
- Doors lock when shifting from Park.
- Doors unlock when shifting into Park.
-Doors unlock when the driver’s door is opened within 10 seconds after setting the ignition switch to “ACC” or “LOCK” position.
Refer to the Owner’s Manual for more details.

414843M2.qxd:414843M2 11/18/10 9:44 AM Page 8

19
OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES


Designed for 12V car accessories.
The ignition switch must be in the “ACC” or “ON” position.

The ignition switch must be in the “ON” position.

Front Rear
414843M2.qxd:414843M2 11/18/10 9:44 AM Page 19

20
Moving the lever to “LOCK” will allow the door to be opened only from
the outside.
Rear door

System reset initialization
1. Push and hold “ SET” button until the indicator blinks
three times.
2. Wait a few minutes to allow initialization to complete.
Push up, or squeeze
lock release to lower

SAFETY AND EMERGENCY FEATURES

After adjusting tire pressures, or after tires have been rotated or
replaced, turn the ignition switch to “ON” and press and hold the
“ SET” button until indicator blinks three times. Let the vehicle sit for a
few minutes to allow initialization to complete.
Refer to the load label on the door jamb or the Owner’s Manualfor tire
inflation specifications.
If the tire pressure indicator flashes for more than 60 seconds and then
remains on, take the vehicle to your local Toyota dealer.
NOTE : The warning light may come on due to temperature changes or
changes in tire pressure from natural air leakage. If the system has not
been initialized recently, setting the tire pressures to factory
specifications should turn off the light.
414843M2.qxd:414843M2 11/18/10 9:44 AM Page 20