2011 TOYOTA LAND CRUISER light

AIR CONDITIONING
255
Air flows to the upper body and feet
(Bilevel)
Depending on the rear air condition-
ing setting
 Air flows to the feet (Floor)
Air flows to the feet and the wind-
shield defogger operates (Floor/
windshield) If manual fan speed control is desired —
1Fan speed at low
2Fan speed at high
The fan speed can be set to your desired
speed by touching the appropriate fan
speed control button.
The higher the fan speed is, the more air is
delivered.
Pushing the “OFF” button turns the fan off.
To remove the exterior windshield frost
and interior windshield fog, use the high
speed setting.
The selected mode is highlighted.

AIR CONDITIONING
256
If manual switching of air intake is de-
sired —
Each time you push the air intake control
button, the mode changes in order from
the RECIRCULATED AIR mode to OUT-
SIDE AIR mode, then back to the RECIR-
CULATED AIR mode. Each indicator light
shows which mode is now selected.
1RECIRCULATED AIR mode — If
quick circulation of cooled air is de-
sired, select this mode.
2OUTSIDE AIR mode — The system
will take fresh outside air into the ve-
hicle.
For normal use, it is best to keep the air in-
take control button set to OUTSIDE AIR
mode. If recirculated air is used during
heating, the windows will fog up more easi-
ly.
In the following cases, the RECIRCU-
LATED AIR mode may change to the OUT-
SIDE AIR mode automatically to prevent
interior fog.
When the outside temperature be-
comes lower than 41
F (5
C).
When the air conditioning compressor
malfunctions.
When the air conditioning cooler refrig-
erant decreases. If manual onoff of the air conditioning
is desired —
Touch
“A/C” to turn the air conditioning on
and touch it again to turn the air condition-
ing off.
The air conditioning does not work if the
outside temperature is lowered down to
around 32
F (0
C).
If the system is used for ventilation, heat-
ing in dry weather or removing frost or ex-
terior fog on the windshield, turn the air
conditioning off once it is no longer re-
quired. This will improve fuel economy.
The air conditioning can be used for year −
round automatic temperature control in-
cluding cooling and dehumidifying opera-
tion.

AIR CONDITIONING
257
(b) Rear air conditioning controls
1“REAR OFF” button
2Temperature control
3Fan speed control
The temperature for the right−hand and
left−hand rear seats can be adjusted sepa-
rately. Touch “
” or “” to increase or
decrease the temperature.
The fan speed can be set to your desired
speed by touching the appropriate fan
speed control button.
The higher the fan speed is, the more air is
delivered.
Touch “REAR OFF” to turn the fan off.
To remove the exterior windshield frost
and interior windshield fog, use the high
speed setting.
The selected mode is highlighted. (c) Windshield
defogging and defrost-
ing
To remove interior fog on the wind-
shield —Push the windshield air flow button.

REAR VIEW MONITOR SYSTEM
264
The area displayed on the screen may
vary according to vehicle orientation or
road conditions.
The rear view monitor system cam-
era
The rear view monitor system camera is lo-
cated on the back door as shown in the il-
lustration.
The camera uses a special lens. The dis-
tance of the image that appears on the
screen differs from the actual distance.
When the camera is used under fluores-
cent lights, sodium lights or mercury lights
etc., the lights and the illuminated areas
may appear to flicker.
In the following cases, it may become diffi-
cult to see the images on the screen, even
when the system is functioning.
In the dark (for example, at night)
When the temperature near the lens is
high or low
When water droplets are adhering to
the camera, or when humidity is high
(for example, when it rains)
When foreign matter (for example,
snow or mud) is adhering to the camera
When the camera has scratches or dirt
on it
When the sun or the beam of head-
lights is shining directly into the camera
lens

REAR VIEW MONITOR SYSTEM
265
If a bright light (for example, sunlight re-
flected off the vehicle body) is picked up by
the camera, the smear effect
∗ peculiar to
the camera may occur.
∗: Smear effect — A phenomenon that oc-
curs when a bright light (for example, sun-
light reflected off the vehicle body) is
picked up by the camera; when trans-
mitted by the camera, the light source ap-
pears to have a vertical streak above and
below it.

SECTION 9
SETUP
267
SETUP
Setup
General settings 268 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
.
(Used for language selection and the on/off settings of
operation sounds and automatic screen change.)
 Clock settings 273 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . .
(Used for changing time zones and the on/off settings of
daylight saving time.)
 Voice settings 275 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . .
(Voice guidance can be set.)
 Navigation settings 278 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
(“Home” and “Preset Destinations” can be set and edited.)
 Detailed navigation settings 278 . . . . . . . . . . . . . . . . . . . . . . . . . . . .
(Average cruising speed, displayed screen contents,
and POI icon categories can be set.)
 Telephone settings 287 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
(Bluetooth  phones can be registered.)
 Audio settings 326
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . .
(Settings are available for portable audio devices and
Bluetooth  audio devices players.)
 Vehicle settings 333
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. .
(Vehicle information can be set.)

SETUP
273
1. Push the “SETUP” button.
2. Touch “General” on the “Setup”
screen.
Then touch
to display page 2 of the
“General Settings” screen.
3. Touch “Delete Personal Data”.
4. Touch “Delete”.
5. Touch “Yes”. Used for
changing time zones and the on/
off settings of daylight saving time.
1. Push the “SETUP” button.
2. Touch “Clock”.
3. Touch the items to be set.
4. Touch “Save”.
Clock settings

SETUP
274
SCREEN FOR CLOCK SETTINGS
On this screen, the following functions can
be performed.No.
Function
1Time zone can be changed. (See
“ Time zone” on page 274.)
2“On” or “Off” can be selected for
daylight savings time.
3“On” or “Off” can be selected for
automatic adjustment of the clock.
4
When “Auto Adjust Clock” is
turned “Off”, the clock can be
manually adjusted. (See “
 Manu-
al clock setting” on page 275.)
Time zone
A time zone can be selected and GMT can
be set.
1. Push the “SETUP” button.
2. Touch “Clock” on the “Setup”
screen.
3. Touch “Time Zone”.
4. Touch the desired time zone.
If you touch “Other”, adjust the zone
manually.
5. Touch “OK”.