2011 TOYOTA CAMRY key

408 4-3. Do-it-yourself maintenance
■If the key battery is discharged
The following symptoms may occur.
●The smart key system and wireless remote control will not function prop-
erly.
● The operational range is reduced.
■ Use a CR1632 (vehicles with smar t key system), or CR2016 (vehicles
without smart key system) lithium battery
● Batteries can be purchased at your Toyota dealer, jewelers, or camera
stores.
● Replace only with the same or equivalent type recommended by your
Toyota dealer.
● Dispose of used batteries according to the local laws.
CAUTION
■Removed battery and other parts
Keep away from children. These parts are small and if swallowed by a child,
they can cause choking. Failure to do so could result in death or serious
injury.
Open the case cover using a
coin protected with tape etc.
and remove the depleted bat-
tery.
Insert a new battery with the
“+” terminal facing up.
STEP3

410
4-3. Do-it-yourself maintenance
Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have
blown. If this happens, check and replace the fuses as necessary.
Vehicles with smart key system: Turn the “ENGINE START
STOP” switch OFF.
Vehicles without smart key system: Turn the engine switch
OFF.
Open the fuse box cover.
Engine compartment
Push the tab in and lift the lid
off.
Under the driver’s side instrument panel Remove the lid.
After a system failure, see “Fuse layout and amperage rat-
ings” ( P. 412) for details about which fuse to check.STEP1
STEP2
STEP3

415
4-3. Do-it-yourself maintenance
4
Maintenance and care
25 EFI MAIN
30 AMultiport fuel injection system/
sequential multiport fuel injection
system, EFI NO.2, EFI NO.3, main
body ECU
26 AMP 25 A Audio system
27 DOOR NO.1 25 A Main body ECU
28 RADIO NO.1 15 A Audio system, navigation system
29 ECU-B NO.1 10 A Wireless remote control system,
front passenger occupant classifi-
cation system, main body ECU
30 DOME 10 AGauges and meters, trunk light,
engine switch light, door courtesy
lights, interior light, personal lights,
clock, smart key system
31 H-LP(LH) 15 A Left-hand headlight (high beam)
32 H-LP(RH) 15 A Right-hand headlight (high beam)
33 H-LP(LL) 15 A Left-hand headlight (low beam)
34 H-LP(RL) 15 A Right-hand headlight (low beam)
35 HORN 10 A Horns
36 EFI NO.1 10 ASmart key system, multiport fuel
injection system/sequential multi-
port fuel injection system, main
body ECU
37 MPX-B 10 A Gauges and meters
38 A/F 20 A No circuit
39 S-HORN 7.5 A Horns
40 EFI NO.2 15 AMultiport fuel injection system/
sequential multiport fuel injection
system
41 EFI NO.3 10 AMultiport fuel injection system/
sequential multiport fuel injection
system
FuseAmpereCircuit

418 4-3. Do-it-yourself maintenance
27 ECU-B NO.1 10 AWireless remote control system,
front passenger occupant classifi-
cation system, main body ECU
28 DOME 10 A Gauges and meters, vanity lights,
trunk light, engine switch light, door
courtesy lights, interior light, per-
sonal lights, clock, smart key sys-
tem
29 H-LP(LH) 15 A Left-hand headlight (high beam)
30 H-LP(RH) 15 A Right-hand headlight (high beam)
31 H-LP(LL) 15 A Left-hand headlight (low beam)
32 H-LP(RL) 15 A Right-hand headlight (low beam)
33 HORN 10 A Horns
34 EFI NO.1 10 A Smart key system, multiport fuel
injection system/sequential multi-
port fuel injection system, main
body ECU
35 MPX-B 10 A Gauges and meters
36 A/F 20 A Multiport fuel injection system/
sequential multiport fuel injection
system
37 S-HORN 7.5 A Horns
38 EFI NO.2 15 A Multiport fuel injection system/
sequential multiport fuel injection
system
39 EFI NO.3 10 A Multiport fuel injection system/
sequential multiport fuel injection
system
FuseAmpereCircuit

421
4-3. Do-it-yourself maintenance
4
Maintenance and care
22 WIP
25 A Windshield wipers and washer
23 H-LP LVL 7.5 A No circuit
24 INJ 15 A No circuit
25 IGN 10 AMultiport fuel injection system/
sequential multiport fuel injection
system, SRS airbag system, steer-
ing lock system, front passenger
occupant classification system,
smart key system, electronic throt-
tle control system
26 GAUGE NO.2 7.5 A Gauges and meters, multi-informa-
tion display, clock
27 ECU-ACC 7.5 A Clock, main body ECU, shift lock
control system, outside rear view
mirror, smart key system
28 CIG 20 A No circuit
29 PWR OUTLET 20 A Power outlet
30 RADIO NO.2 7.5 A Audio system, navigation system
31 MIR HTR 10 A Outside rear view mirror defoggers
32 POWER 30 A Power windows
33 P/SEAT 30 A Power seats
■ After a fuse is replaced
●If the lights do not turn on even after the fuse has been replaced, a bulb
may need replacing. ( P. 423)
● If the replaced fuse blows again, have the vehicle inspected by your
Toyota dealer.
■ If there is an overload in the circuits
The fuses are designed to blow, protecting the wiring harness from damage.
FuseAmpereCircuit

When trouble arises5
427
5-1. Essential informationEmergency flashers ......... 428
If your vehicle needs to be towed .................... 429
If you think something is wrong ......................... 432
Fuel pump shut off system ........................... 433
Event data recorder ......... 434 5-2. Steps to take in an
emergency
If a warning light turns on or a warning buzzer
sounds... ....................... 436
If a warning message is displayed........................ 448
If you have a flat tire......... 458
If the engine will not start ................................ 469
If the shift lever cannot be shifted from P............ 471
If you lose your keys ........ 472
If the electronic key does not operate
properly .......................... 473
If the battery is discharged ..................... 475
If your vehicle overheats ....................... 479
If the vehicle becomes stuck .............................. 482
If your vehicle has to be stopped in an
emergency ..................... 484

5
When trouble arises
431
5-1. Essential information
Towing with a wheel-lift type truck from the rear
Automatic transmission: Use a
towing dolly under the front
wheels.
Manual transmissions: We rec-
ommend to use a towing dolly
under the front wheels.
When not using a towing dolly,
turn the engine switch to the
“ACC” position and shift the shift
lever to N.
Using a flat bed truckIf you use chains or cables to tie
down your vehicle, the angles
shaded in black must be 45.
Do not overly tighten the tie
downs or the vehicle may be
damaged.
NOTICE
■ To prevent causing serious dama ge to the transmission
(automatic transmission)
Never tow this vehicle from the rear with the front wheels on the ground.
■ To prevent damaging the vehicle (manual transmission)
Do not tow the vehicle when the engine switch is in the “LOCK” position or
key removed.
The steering lock mechanism is not strong enough to hold the front wheel
straight.

5
When trouble arises
433
5-1. Essential information
Fuel pump shut off system
Follow the procedure below to restart the engine after the system is
activated.Vehicles with smart key systemTurn the “ENGINE START STOP” switch OFF.
Restart the engine.
Vehicles without smart key system Turn the engine switch to the “ACC” or “LOCK” position.
Restart the engine.
NOTICE
■Before starting the engine
Inspect the ground under the vehicle.
If you find that fuel has leaked on to the ground, the fuel system has been
damaged and is in need of repair. Do not restart the engine.
To minimize the risk of fuel leakage when the engine stalls or an air-
bag inflates upon collision, the fu el pump shut off system stops sup-
plying fuel to the engine.
STEP1
STEP2
STEP1
STEP2