13B-332
MR-372-J84-13B200$828.mif
V13
EDC16
Program No.: C1
Vdiag no.: 18, 1C, 20,
50, 58, 5CDIESEL INJECTION
Fault finding – Fault Finding Chart13B
ALP 9
CONTINUED 1
Recognition of parameters corresponding to the start of successful
regenerations.
Make adjustments to align the parameter groups.
Group 1 Regeneration start record no. 1 to 10
And
Group 2 Regeneration failure record no. 1 to 10
For each parameter in group 1, if there is no parameter in group 2 in the next
30 miles (50 km), note this down as a successful regeneration (R). If there is
one, this means a failure (e).
Note group 1 here:
PR816: ____ ET742 ___
PR817: ____ ET743 ___
PR818: ____ ET744 ___
PR819: ____ ET745 ___
PR820: ____ ET746 ___
PR821: ____ ET747 ___
PR822: ____ ET748 ___
PR823: ____ ET749 ___
PR824: ____ ET750 ___
PR825: ____ ET751 ___Note group 2 here
PR794: _________
PR795: _________
PR796: _________
PR797: _________
PR798: _________
PR799: _________
PR800: _________
PR801: _________
PR802: _________
PR803: _________Type of regeneration
PR816: R E
PR817: R E
PR818: R E
PR819: R E
PR820: R E
PR821: R E
PR822: R E
PR823: R E
PR824: R E
PR825: R E
A
YES
CD
B
13B-348
MR-372-J84-13B200$900.mif
V13
EDC16
Program No.: C1
Vdiag no.: 18, 1C, 20,
50, 58, 5CDIESEL INJECTION
Fault finding – Tests13B
TEST8 Manual clearing of the soot weight
Note: In certain cases, this procedure is to be carried out only after replacement of the particle filter or after an
After-sales regeneration of the particle filter.
– Start the engine.
– Raise the engine coolant temperature.
– Read the coolant temperature with PR064 Coolant temperature until a value greater than 65ºC is obtained.
– Accelerate the engine to 4000 rpm and maintain this speed for 5 minutes.
–After 5 minutes, release the accelerator and stop the engine.
– Switch on the ignition.
– Run command SC036 Reinitialise programming and select After particle filter replacement or After
particle filter regeneration (as appropriate).
– Switch off the ignition and wait for the diagnostic tool message (maximum time 8 minutes): Communication
lost with computer: EDC16C36, check the tool connection and computer power supply.
–Then switch on the ignition again, clear the present or stored faults from the computer memory (operation
to be carried out within 3 minutes of switching on the ignition).
EDC16_V50_TEST8/EDC16_V58_TEST8/EDC16_V5C_TEST8/EDC16_V18_TEST8/EDC16_V1C_TEST8/EDC16_V20_TEST8
