2011 Peugeot RCZ tow

3/
EASE OF USE AND COMFORT
In order for these systems to be fully effective, follow the operation
and maintenance guidelines below:


)
To obtain an even air distribution, take care not to obstruct
the exterior air intake grilles located at the base of the
windscreen, the nozzles, the vents and the air outlets, as well
as the air extractor located in the boot.

)
Do not cover the sunshine sensor, located on the dashboard;
this is used for regulation of the air conditioning system.

)
Operate the air conditioning system for at least 5 to 10 minutes,
once or twice a month to keep it in good working order.

)
Ensure that the passenger compartment fi lter is in good
condition and have the fi lter elements replaced regularly (refer
to the "Checks" section).
We recommend the use of a combined passenger
compartment fi lter. Thanks to its special active additive,
it contributes to the purifi cation of the air breathed by the
occupants and the cleanliness of the passenger compartment
(reduction of allergic symptoms, bad odours and greasy
deposits).

)
To ensure correct operation of the air conditioning system, you
are also advised to refer to the Warranty and Maintenance
Record for information on when it should be checked.

)
If the system does not produce cold air, switch it off and
contact a PEUGEOT dealer or a qualifi ed workshop.
When towing the maximum load on a steep gradient in high
temperatures, switching off the air conditioning increases the
available engine power and so improves towing performance.
The condensation created by the air conditioning results in a
discharge of water under the vehicle which is perfectly normal.

If after an extended stop in sunshine, the interior temperature is
very high, fi rst ventilate the cabin for a few moments.
Put the air fl ow control at a setting high enough to quickly change
the air in the cabin.
The air conditioning system does not contain chlorine and does
not present any danger to the ozone layer.









RECOMMENDATIONS FOR VENTILATION AND AIR CONDITIONING

3/
EASE OF USE AND COMFORT

4. Automatic visibility programme

The automatic comfort programme may not be suffi cient to
quickly demist or defrost the windscreen and side windows
(humidity, several passengers, ice, etc.).


)
In this case, select the automatic visibility programme.
The system automatically controls the air conditioning, the air fl ow and
the air intake and provides optimum distribution of the ventilation to the
windscreen and side windows.


)
To switch it off, press the "visibility"
button again or press the
"AUTO"
button, the indicator lamp on the button switches off and
the indicator lamp on the "AUTO"
button comes on.




MANUAL OPERATION

If you wish, you can make a different choice from that offered by the
system by changing a setting. The other functions will still be controlled
automatically.


)
Pressing the "AUTO"
button returns the system to completely
automatic operation.
For maximum cooling or heating of the passenger compartment,
it is possible to exceed the minimum value 14 or the maximum
value 28.


)
Turn control 2
or 3
to the left until "LO"
is displayed or to the
right until "HI"
is displayed.


5. Air conditioning On/Off



)
Press this button to switch off the air conditioning.
Switching the system off could result in discomfort (humidity,
condensation).


)
Press this button again to return to automatic operation of the air
conditioning. The indicator lamp on the "A/C"
button comes on.



6. Air distribution adjustment



)
Press one or more buttons to direct the air fl ow towards:


- the windscreen and side windows (demisting or defrosting),

- the windscreen, the side windows and the vents,

- the windscreen, the side windows, the vents and the footwells,

- the vents and the footwells,

- the vents,

- the footwells,

- the windscreen, the side windows and the footwells.




7. Air flow adjustment



)
Turn this control to the left to decrease the air fl ow or to
the right to increase the air fl ow.
The air fl ow indicator lamps, between the two fans, come on
progressively in relation to the value requested.

86











BOOT FITTINGS



1.
Stowing rings


2.
Storage net


3.
Storage box


(see details on following page)

3/
EASE OF USE AND COMFORT
The duration of lighting varies, depending on the context:


- when the ignition is off, approximately ten minutes,

- in energy economy mode, approximately thirty seconds,

- when the engine is running, no limit.







STORAGE BOX

This has areas for storing a box of spare bulbs, a fi rst aid kit, the
temporary puncture repair kit, a warning triangle, the removable ball of
the towbar system...






BOOT LAMPS

Your vehicle is fi tted with two boot lamps; one in the right-hand boot
side trim and a second in the centre under the rear shelf.
They come on automatically when the boot is opened and switch off
automatically when the boot is closed.
They cannot be deactivated manually.
A second warning triangle can be stored in the boot lid trim. For access to it:


)
raise the fl oor using the strap,

)
secure it in the vertical position behind the stops, located on the
sides of the boot.

96









WINDSCREEN AND HEADLAMP WASH



)
Pull the windscreen wiper stalk towards you. The windscreen wash
then the windscreen wipers operate for a fi xed period.
The headlamp washers only operate when the dipped beam
headlamps are on
.











Screenwash/headlamp wash low


In the case of vehicles fi tted with headlamp washers, when
the minimum level of the reservoir is reached, this warning
lamp and/or the service warning lamp is displayed in the
instrument panel, accompanied by an audible signal and a
message in the screen.
Next time you stop, fi ll the screenwash / headlamp wash fl uid reservoir.
The warning lamp is displayed when the ignition is switched on, or
every time the stalk is operated, until the reservoir is fi lled.

5/
SAFETY











DIRECTION INDICATORS

If you forget to cancel the direction indicators for more than twenty
seconds, the volume of the audible signal will increase if the
speed is above 40 mph (60 km/h).

)
Left: lower the lighting stalk passing the point of resistance.

)
Right: raise the lighting stalk passing the point of resistance.









HAZARD WARNING LAMPS

A visual warning by means of the direction indicators to alert other road
users to a vehicle breakdown, towing or accident.


)
Press this button, the direction indicators fl ash.
They can operate with the ignition off.







AUTOMATIC OPERATION OF HAZARD
WARNING LAMPS
When braking in an emergency, depending on the deceleration, the
hazard warning lamps come on automatically.
They switch off automatically the fi rst time you accelerate.


)
You can also switch them off by pressing the button.
Deactivating the ESP/ASR systems also deactivates the automatic
operation of the hazard warning lamps; refer to the section "Trajectory
control systems - § Deactivation".

11 0





The driver must ensure that passengers use the seat belts
correctly and that they are all restrained securely before
setting off.
Wherever you are seated in the vehicle, always fasten your seat
belt, even for short journeys.
Do not interchange the seat belt buckles as they will not fulfi l their
role fully.
The seat belts are fi tted with an inertia reel permitting automatic
adjustment of the length of the strap to your size. The seat belt is
stowed automatically when not in use.
Before and after use, ensure that the seat belt is reeled in
correctly.
The lower part of the strap must be positioned as low as possible
on the pelvis.
The upper part must be positioned in the hollow of the shoulder.
The inertia reels are fi tted with an automatic locking device which
comes into operation in the event of a collision, emergency
braking or if the vehicle rolls over. You can release the device by
pulling fi rmly on the strap and releasing it so that it reels in slightly.
In order to be effective, a seat belt must:


- be tightened as close to the body as possible,

- be pulled in front of you with a smooth movement, checking
that it does not twist,

- be used to restrain only one person,

- not bear any trace of cuts or fraying,

- not be converted or modifi ed to avoid affecting its
performance. In accordance with current safety regulations, for all repairs on your
vehicle, go to a qualifi ed workshop with the skills and equipment
needed, which a PEUGEOT dealer is able to provide.
Have your seat belts checked regularly by a PEUGEOT dealer or a
qualifi ed workshop, particularly if the straps show signs of damage.
Clean the seat belt straps with soapy water or a textile cleaning
product, sold by PEUGEOT dealers.
After folding or moving a seat or rear bench seat, ensure that the
seat belt is positioned and reeled in correctly.


Recommendations for children

Use a suitable child seat if the passenger is less than 12 years old or
shorter than one and a half metres.
Never use the same seat belt to secure more than one person.
Never allow a child to travel on your lap.


In the event of an impact


Depending on the nature and seriousness of the impact
, the
pretensioning device may be deployed before and independently
of the airbags. Deployment of the pretensioners is accompanied
by a slight discharge of harmless smoke and a noise, due to the
activation of the pyrotechnic cartridge incorporated in the system.
In all cases, the airbag warning lamp comes on.
Following an impact, have the seat belts system checked, and if
necessary replaced, by a PEUGEOT dealer or a qualifi ed workshop.

5/
air
bagairbag
SAFETY

Reactivation

When you remove the child seat, turn the switch to the "ON"
position to
reactivate the airbag and so assure the safety of your front passenger in
the event of an impact.
With the ignition on, this warning lamp comes on in the seat
belt and passenger's front airbag warning lamps display for
approximately one minute, if the passenger's front airbag is
activated.
If even one of the two airbag warning lamps comes on
continuously, do not install a child seat on the front passenger
seat.
Have the system checked by a PEUGEOT dealer or a qualifi ed
workshop.



Operating fault

If this warning lamp comes on in the instrument panel,
accompanied by an audible warning and a message in the
screen, contact a PEUGEOT dealer or a qualifi ed workshop
to have the system checked. The airbags may no longer be
deployed in the event of a serious impact.
If this warning lamp fl ashes in the passenger's front airbag
warning lamps display, contact a PEUGEOT dealer or a
qualifi ed workshop. The passenger's front airbag may no
longer be deployed in the event of a serious impact.






LATERAL AIRBAGS

System which protects the driver and front passenger in the event of a
violent side impact in order to limit the risks of injury to the chest.
Each lateral airbag is fi tted in the front seat back frame, on the door
side.

Deployment

It is deployed unilaterally in the event of a violent impact applied to
all or part of the side impact zone B
, operating at right angles to the
longitudinal axis of the vehicle in a horizontal plane and from the
exterior of the vehicle towards the interior.
The lateral airbag comes between the front occupant of the vehicle and
the corresponding door trim panel.