SEATS34-
MULTIFUNCTION PASSENGER SEAT
To fold the seat fully:
Pull the control 2
upwards and tilt the
whole seat.
It is not necessary to remove the
head restraint.
This provides access to a box which
enables you to store objects so that
they cannot be seen from outside the
vehicle. If your vehicle is not fi tted with a load
blocking partition, it can accommo-
date long objects (up to 2.10 m).
These must be placed on the front
edge of the fl oor and secured using
the rear bar of the boot or using the
lashing rings. To fold the seat back:
Pull the control 1
upwards and tilt the
seat back.
This provides a fl at surface, recesses
for drinks and a strap for retaining
documents.
ACCESS and STARTING48 -
*
According to country.
THE ALARM SYSTEM *
The alarm offers two types of protection:
- exterior protection:
the alarm
sounds if a door, the boot or the
bonnet is opened
;
- interior protection:
the alarm
sounds if there is a variation in
the volume inside the vehicle
(breaking of a window or move-
ment inside the vehicle)
.
Setting the alarm
Switch the ignition off and get out of
the vehicle.
Activate the alarm within fi ve minutes
following your exit from the vehicle,
by locking using the remote control
key (the red indicator lamp in the
switch 1
, which can be seen from the
outside, fl ashes once a second).
Warning
If, on setting the alarm, a door, the
boot or the bonnet are not closed
correctly, the siren sounds for a mo-
ment.
Close the vehicle correctly to set the
alarm.
If the interior protection alarm is trig-
gered ten times in succession, it is
disarmed automatically. It must be
set again in order for it to operate
correctly. When the alarm is triggered, the si-
ren sounds and the direction indica-
tors fl ash for thirty seconds.
After it has been triggered, the alarm
becomes operational again.
Note:
if you wish to lock your vehicle
without setting the alarm, lock it using
the key in the door lock.
Disarming the alarm
Unlock the vehicle using the remote
control key (the red indicator lam in
the switch 1
goes off).
Note:
if the warning light fl ashes, it is
a sign that the alarm has been trig-
gered in your absence.
To stop it, switch on the ignition.
Note:
when the alarm is set, but the
remote control no longer works:
)
unlock the doors using the key
and open the door; the alarm is
triggered;
)
switch the ignition on within ten
seconds; the alarm is disarmed.
To set the alarm with exterior
protection only.
If, while you are away from the vehicle,
you wish to leave a window partially
open or a pet inside the vehicle, you
need to select exterior protection only:
●
Switch off the ignition.
●
Press the button 2
until the lamp
1
comes on continuously.
●
Get out of the vehicle.
●
Press the locking button of the
remote control.
●
The doors lock.
●
The red lamp in the switch fl ashes
once a second.
Operating fault
When the ignition is switched on,
fi xed illumination of the red indica-
tor lamp, located in the centre of the
dashboard, indicates an anomaly
with the siren.
Contact a PEUGEOT dealer to have
the system checked.
Do not make any modifi ca-
tions to the alarm system,
this could cause malfunc-
tions.
89 PRACTICAL INFORMATION
-
Fuse
Rating
Functions
1
15A
Rear wiper.
4
20A
Multi-function scren - Instrument panel - Audio
system - Steering mounted controls.
5
-
Not used.
6
10A
Diagnostic socket.
7
-
Not used.
9
30A
Heated seats.
10
40A
Rear window and door mirrors demisting.
11
15A
Rear wiper (tailgate).
12
30A
Front electric windows.
14
10A
Engine fusebox - Steering mounted controls.
15
15A
Instrument panel - Multi-function screen - Audio
system.
16
30A
Locking/unlocking controls for doors, bonnet and
boot.
20
10A
Right-hand brake lamp.
21
15A
Left-hand brake lamp.
22
20A
Front courtesy lamp - Map reading lamp - Cigarette
lighter - Electric mirror.
