2011 Peugeot M59 ECU

15 FAMILIARISATION
-
REAR FITTINGS



Stowing rings
For greater safety, always en-
sure that the loads transported
are secured fi rmly.



61



1.
Load space cover.

2.
High load retaining net.

3.
Stowing rings.

4.
Side door pockets.

5.
Compartments between the front
and rear seats.

6.
Seat back storage pockets.



62

FAMILIARISATION16 -
This operation must be carried out
with the engine switched off
.


)
Insert the key then turn it to the
left.

)
Remove the cap.
A label indicates which type of fuel to
use.
When you fi ll your tank, do not
continue after the third cut-off of the
pump. This could cause engine mal-
functions.

The capacity of the tank is approxi-
mately 55 litres for petrol engines
and 60 litres for Diesel engines.

When this lamp fi rst comes on, you
have enough fuel left to cover ap-
proximately 30 miles (50 km)
.

Note:
the right-hand sliding side door
cannot be opened while the fuel fi ller
cap is removed.

Outside the vehicle:
Lift the safety
catch, raise the bonnet and secure
the stay to keep the bonnet open.

Inside the vehicle:
Pull the release
lever on the left-hand side, under the
dashboard.

Low fuel level
warning lamp



53



53



FILLING WITH FUEL

SEATS34-
MULTIFUNCTION PASSENGER SEAT
To fold the seat fully:

Pull the control 2
upwards and tilt the
whole seat.
It is not necessary to remove the
head restraint.
This provides access to a box which
enables you to store objects so that
they cannot be seen from outside the
vehicle. If your vehicle is not fi tted with a load
blocking partition, it can accommo-
date long objects (up to 2.10 m).
These must be placed on the front
edge of the fl oor and secured using
the rear bar of the boot or using the
lashing rings. To fold the seat back:
Pull the control 1
upwards and tilt the
seat back.
This provides a fl at surface, recesses
for drinks and a strap for retaining
documents.

35SEATS-
To fold the rear bench seat:


- lower the head restraint,

- press control 1
to unlock the seat
back 2
,

- fold the seat back 2
onto the seat,

- place the seat in the "folded"
position. When repositioning:


- tilt the folded seat rearwards,

- lift the seat back,

- check that the seat is locked cor-
rectly.

Take care not to trap the seat belts.


REAR BENCH SEAT(5 SEAT VERSION)


HEAD RESTRAINT

This is of the "comma" type.
High position: press the two tabs at
the same time, lift the head restraint
and raise it.
Low position: push the two tabs at
the same time and press the top to
lower the head restraint.
To remove the head restraint: place
it in the high position, lift it then re-
move it.
Store it inside the vehicle, securing
it fi rmly.
To install the head restraint: engage
the rods of the head restraint in the
holes keeping it in line with the seat
back.

SEATS36-
REAR BENCH SEATS (7 SEAT VERSION)


The bench seats of row 2 and row 3
are independent and adjustable.


Row 2 bench seat


Placing the bench seat in the
table position


- Lower the head restraints fully.

- Operate the control to fold the
seat back onto the bench seat
cushion.


Returning the seat back to the
sitting position


-
Return the seat back to its original
position and check that it is secured
on the pillar of the vehicle.



Placing the bench seat in the fully
folded position


- Place the seat in the table position.

- Pull the handle, located behind
the bench seat, to release the
feet from their anchorage on the
fl oor.

- Tilt the bench seat forwards.


Returning the bench seat to its
original position
Before folding the bench
seat, ensure that:


- in row 3, no passenger's foot is
at one of the bench seat anchor-
ages on the fl oor,

- the seat belt is available for the
side passenger.


- Fold back the bench seat.

37SEATS-

Row 3 bench seat


Placing the seat back in the table
position


- Lower the head restraints fully.

- Operate the two controls simulta-
neously to fold the seat back onto
the bench seat cushion.



Returning the seat back to the sitting position


- Return the seat back to its original position
and check that it is secured on the pillars of
the vehicle.



Placing the bench seat in the fully
folded position


- Place the seat in the table position.

- Raise the handle, located behind
the bench seat, to release the feet
from their anchorage on the fl oor.

- Tilt the bench seat forwards.


Returning the bench seat to its
original position


- Before folding back the bench
seat, ensure that the seat belt is
available for the side passengers.

- Fold back the bench seat.


Access to row 3

From the vehicle's right-hand sliding
door, a passage next to the row 2
bench seat provides access to the
row 3 bench seat.


Good practice

Do not place hard or heavy
objects on the seat backs
forming a table, they could
become dangerous projectiles in the
event or sharp braking or impact.
Following the various operations:


- do not remove a head restraint
without storing it, fi x it to a sup-
port in the vehicle,

- do not block the passage to row 3,

- ensure that the passengers can
always access the seat belts and
fasten them easily,

- a passenger must never take his
seat without adjusting and fastening
his seat belt.

- a passenger seated in row 3 must
ensure that he does not obstruct
the row 2 bench seat anchoring
recesses.

39SEATS-
CHILD SEATS RECOMMENDED BY PEUGEOT

PEUGEOT offers a complete range of recommended child seats which are
secured using a three point seat belt
:


Group 0+: from birth to 13 kg






L1


"RÖMER Baby-Safe Plus"
Installed in the rearwards-facing position.


Groups 2 and 3: from 15 to 36 kg






L3


"RECARO Start''



L4

"KLIPPAN Optima"
From the age
of 6 years
(approximately
22 kg), the booster
is used on its own.




L5


"RÖMER KIDFIX"
Can be fi tted to the vehicle's ISOFIX mountings.
The child is restrained by the seat belt.

Passenger airbag OFF

SEATS
40-
INSTALLING CHILD SEATS SECURED USING THE SEAT BELT

In accordance with European regulations, this table indicates the options for the installation of child seats secured using the
seat belt and approved for universal use (a), according to weight of the child and the seat in the vehicle:



Weight of the child and indicative age




Seat



Below 13 kg


(groups 0 (b) and 0+)
Up to 1 year approx

From 9 to 18 kg


(group 1)
From 1 to 3 years
approx

From 15 to 25 kg


(group 2)
From 3 to 6 years
approx

From 22 to 36 kg


(group 3)
From 6 to 10 years
approx
Front passenger (c)

U



U



U



U






Row 2 Outer

U



U



U



U


Centre

U



U



U



U






Row 2 Right

U



U



U



U


Left

U



U



U



U


Row 3 Outer

U



U



U



U


Centre

U



U



U



U