2011 Peugeot iOn key

i
!
Access
34
1.Driver's electric window switch.2.Passenger's electric window switch.3.Rear right electric window switch.4. Rear left electric window switch.5.Deactivating the passenger and rear
electric window switches.








Electric windows


Operation

Deactivating the passenger and
rear electric window switches
)For the safety of your children, press switch 5to prevent operation of the passenger and rear electric windows irrespective of their position. When the button is pressed down, the switches aredeactivated.
When the button is raised, the switches are activated.
System which opens or closes a window manually or automatically. It is fitted with a deactivation system to prevent misuse of the rear controls.
The electric window switches remainoperational for approximately 30 seconds after the ignition is switched off.The windows can no longer be opened or closed after the driver's door is closed. With the i
gnition on: )
Press the switch gently to open or pull it gently to close. The window stops as soonas the switch is released.
-Automatic one-touch mode (driver's
side)) Press the switch fully to open. The
driver's window opens completely when
the switch is released. ) Pressing the switch again stops the
movement of the window.

Always remove the key from the ignition when leaving the vehicle, even for a short time.
In the event of contact during operationof the windows, you must reverse the movement of the window. To do this,press the switch concerned.
When the driver operates the passenger electric window switches, they mustensure that no one is preventing correct closing of the windows.
The driver must ensure that passengersuse the electric windows correctly.
Be aware of children when operating the windows.

2
!
Access
35





Doors


From outside
)After unlocking the vehicle using theremote control or the key, pull the door handle.
From inside
)
Pull the front or rear door control to open
the door.
If the doors are locked, opening the driver's door does not unlock the other doors.
- opening the driver's door unlocks the other doors,
- the front passenger or rear doors must
then be unlocked manually using the frontlocking control before they can be opened.
I
f a door or the boot is not closedcorrectly, this warning lamp comes
on in the instrument panel until the
door in question or the boot is closed.

Opening
Closin
g
Locking/unlocking from the
inside
) Press the button on the driver's door
towards the front to lock and towards therear to unlock the vehicle completely.
The buttons on the front and rear passenger doors only lock /unlock the door in question.

Access
36








Boot
Opening
)After unlocking the vehicle using theremote control or the key, press the handle Aand open the tailgate.
)
Pull the handle B
downwards to guide the
tailgate down,) release the handle and press the exterior surface of the tailgate gently to close it.


Closing

i
!
Driving
52










Starting - stopping the vehicle
- Position 1 : LOCKThe steering is locked.
- Position 2 : ACCThe ancillaries (radio, 12 V socket...) canbe used.
- Position 3 : ON
Ignition on.
- Position 4 : STA RT"Ready" lamp on. Motor ready to drive the vehicle.
Ignition switch
)
Inser t the key in the ignition switch.
)
Turn the key to position 4 (START).


Starting
Stopping
)Immobilise the vehicle.
)Place the drive selector in position P.P)Turn the key to position 1 (LOCK).)Remove the key from the ignition switch.)Hold it in this position for a few seconds until the"READY" lampcomes on accompanied by an
audible signal.
) Release the key.
The key returns automatically to position 3 (ON).
Key in ignition
If the key has been left in the ignition, an
audible signal is heard on opening the driver's door.

Do not attach any heavy objects to the key as this could weigh down on it whenin the ignition switch and cause a fault.

If you use the ancillaries for a prolongedperiod (with the key in the ACCposition), you risk discharging the ancillaries battery. Star ting your vehicle will then no longer be possible. Be aware .

4
!
Driving
55
To tow your vehicle, the drive selector must be in position N
, refer to "PracticalInformation".



Parking the vehicle

To stop the motor, you must select position P.P
You must apply the parking brake to immobilise
the vehicle.
To remove the key from the ignition switch, thedrive selector must be in position P.P

i
i
i
Visibility
58
Daytime running lamps
Special daytime lighting so that the vehicle can
be seen more easily. The daytime running lamps come on automatically when star ting the motor, if no
other lighting is on.
They cannot be deactivated.
With the main lighting control ring in the AUTO
position,
the sidelamps and dipped beam headlamps come on
automatically, without any action by the driver, when a low level of ambient light is detected.
When the light returns to a sufficient level or the
wipers are switched off, the lighting is switched off automatically.
The sensor is located at the base of the windscreen.
Automatic illumination of headlamps
Automatic lighting off
When the lighting stalk is in the "dipped or mainbeam headlamps" position, if the ignition switch
is in the "LOCK" or "ACC" position or if thekey has been removed, the lighting switches
off automatically when the driver's door isopened .
The driver is is aler ted by an audible signal. The initial setting is position "0".









Headlamp
adjustment

To avoid causing a nuisance to other road
users, the height of the halogen headlampsshould be adjusted according to the load in the
vehicle. 0. Driver only or driver + 1 front passenger.
1 or 2.
4 people (including the driver).3.4 people (including the driver) + maximumauthorised load.4.
Driver + maximum authorised load.

Even though these lamps are located inthe same lamp unit as the front foglamp, the operate with a specific bulb.
Their use is covered by road vehiclelighting regulations.
In foggy weather or in snow, thesunshine sensor may detect sufficient light. The lighting will not come on automatically. Do not cover the sunshine sensor, theassociated functions will no longer becontrolled.

!
Child safety
68
The incorrect installation of a child seat in a vehicle compromises the child's protection inthe event of an accident.
When installing a child seat using the seat belt,check that the seat belt is tightened correctly on the child seat and that it secures the childseat firmly on the seat of your vehicle.
Remember to fasten the seat belts or the childseat harnesses keeping the slackin relationkto the child's body to a minimum, even for short journeys.
For optimum installation of the "forwards-facing" child seat, ensure that the back of the child seat is in contact with the back of thevehicle's seat and that the head restraint doesnot cause any discomfort.
If the head restraint has to be removed, ensurethat it is stored or attached securely to prevent it from being thrown around the vehicle in theevent of sharp braking. Children under the age of 10 must not travel in the "forwards-facing" position on the frontpassenger seat, unless the rear seats arealready occupied by other children, cannot beused or are absent.
Deactivate the passenger airbag
* when a"rearwards-facing" child seat is installed onthe front seat. Other wise, the child would risk being seriously injured or killed if the airbag
were to inflate.

Advice on child seats
Installing a booster seat
The chest par t of the seat belt must bepositioned on the child's shoulder without
touching the neck.Ensure that the lap part of the seat beltpasses correctly over the child's thighs.PEUGEOT recommends the use of abooster seat which has a back, fitted with aseat belt guide at shoulder level.
As a safety precaution, do not leave: - one or more children alone andunsuper vised in a vehicle, - a child or an animal in a vehicle whichis exposed to the sun, with the windows closed, - the keys within reach of children inside the vehicle. To prevent accidental opening of the doors, use the "Child lock". Take care not to open the rear windows bymore than one third.To protect young children from the rays of the sun, fit side blinds on the rear windows.


*
According to country and current local legislation.








Child lock

Mechanical system to prevent opening of the
rear doors using their interior controls.
The control is located on the edge of each rear door.


Child lock on
)Lower the control Ato position 1.


Child lock off
)Raise the control Ato position 2.

7
!
Safety
77

Deactivation
Only the front passenger's airbag can be deactivated:)with the ignition off, inser t the key in thefpassenger airbag deactivation switch A , )turn it to the "OFF"position, )remove the key.
This warning lamp comes on in the centreconsole when the ignition is on and until theairbag is reactivated.
To ensure the safety of your child, thepassenger airbag must be deactivatedwhen you install a "rear facing" childseat on the front passenger seat. Other wise, the child would risk beingseriously injured or killed if the airbag were deployed.


Reactivation

When you remove the child seat, turn switch A
to the "ON"position to reactivate the
airbag and so ensure the safety of your front
passenger in the event of an impact.
The associated warning lamp goes off.


Operating fault
If this warning lamp comes on in the
instrument panel, contact a PEUGEOT
dealer or a qualified workshop to have
t
he system checked. The airbags mayno longer be deployed in the event of a
serious impact.