Page 63 of 340
3
61
Comfort
Front seats
Manual adjustments
1.
Adjustments to the height and angle of
the head restraint
To raise it, pull upwards.
To lower it, hold the button in and press on
the head restraint (pushing to go past the
stiff point of the button).
2.
Adjustment of the backrest angle
Operate the control lever and adjust the
position of the backrest to the front or to the
rear.
3.
Adjustment of the seat height
Raise or lower the control lever the number
of times required to obtain the desired
position.
4.
Adjustment of the lumbar suppor t
This system allows the height and depth of
the lumbar suppor t to be adjusted separately.
)
For wards or backwards to increase or
decrease the lumbar suppor t.
)
Upwards or downwards to raise or lower
the lumbar contact zone.
5.
Forwards-backwards adjustment of the
seat position
Lift the control bar and slide the seat
for wards or backwards.
6. Adjusting the cushion
Pull the handle to adjust the length of the
cushion.
Page 79 of 340

3
77
!
i
Comfort
Warning triangle (stowing)
Before leaving your vehicle to set up
and install the triangle, put on your high
visibility vest.
The dimensions of the triangle (once folded) or
its storage box must be:
- A
: length = 438
mm,
- B
: height = 56
mm,
- C
: width = 38
mm.
To use the triangle, refer to the manufacturer's
instructions.
Saloon
)
Press the lug 1
and pull the assembly
towards you.
SW
)
Turn the knob 2
to remove the cover.
)
Hold the cover and the triangle so that they
do not fall.
The location for a folded triangle is in the inner
trim panel of the boot lid.
Placing the triangle in the road
)
Place the triangle at a distance behind
the vehicle, as shown in the table below,
according to the type of road and the level
of ambient light.
Distance from your vehicle (in metres)
Road
Motorway
Day
Night
50 m
80 m
150 m
These are the internationally recognised
values.
Use the triangle in line with local driving
regulations.
The triangle is available as an accessory,
contact a PEUGEOT dealer or a qualified
workshop.
Page 80 of 340
78
i
Comfort
High load retaining net (SW)
Hooked onto the special upper and lower
fixings, this allows the use of the entire loading
volume up to the roof:
- behind the front seats (row 1) when the rear
seats are folded.
- behind the rear seats (row 2).
Never reposition the rear seats if the
net's roller is attached to the backs of
the folded seats.
)
position the net's roller above the two rails
(located on the back of the folded rear
seats),
)
the two grooves A
must be placed above
the two rails B
. Slide the two rails B
in the
grooves A
and push the roller (lengthwise)
from right to left to secure it,
)
check that the net is hooked and tightened
correctly,
)
fold the rear seats,
)
unroll the high load retaining net without
stretching it,
)
position one of the ends of the net's metal
bar in the corresponding upper fixing 1
,
)
pull the net's metal bar to position the other
end in the other upper fixing 1
.
Row 1
Page 130 of 340