Page 182 of 340
180
Practical information
)
Place the jack 2
in contact with one of the
two front A
or rear B
locations provided on
the underbody, whichever is closest to the
wheel to be changed.
)
Raise the vehicle until there is sufficient
space between the wheel and the ground
to admit the spare (not punctured) wheel
easily.
)
Remove the bolts and store them in a clean
place.
)
Remove the wheel.
)
Extend the jack 2
until its base plate is in
contact with the ground. Ensure that the
centreline of the jack base plate is directly
below the location A
or B
used.
Page 185 of 340
8
183
i
Practical information
Changing a bulb
Front lamps
Model with xenon and directional
headlamps
1.
Daytime running lamps/sidelamps
(light emitting diodes - LEDs).
2.
Directional dipped/main beam
headlamps (D1S-35W).
3.
Direction indicators (PY21-21W).
4.
Foglamps (directional according to
version) (H8).
Model with halogen headlamps
1.
Dipped and main beam headlamps
(H7-55W).
2.
Sidelamps (W5-5W).
3.
Main beam headlamps (H7-55W).
4.
Daytime running lamps (SP13-13W).
5.
Foglamps (directional according to
version) (H8).
6.
Direction indicators (PY21-21W).
For H7 type bulbs with lugs... take care to
obser ve their correct installation so as to
ensure the best lighting per formance.
In some weather conditions (e.g. low
temperature or humidity), the presence
of misting on the internal sur face of the
glass of the headlamps and rear lamps
is normal; it disappears after the lamps
have been on for a few minutes.
Page 195 of 340
8
193
Practical information
Dashboard fuses
The fusebox is placed in the lower dashboard
(left-hand side).
Access to the fuses
)
Open the hinged panel, then apply light
force to bypass the stops.
Fuse
N°
Rating
(A)
Functions
F6 A or B
15
Audio system.
F8
3
Alarm.
F13
10
Front cigar lighter.
F14
10
Front 12 V socket.
F16
3
Rear courtesy lamp, rear map reading lamps.
F17
3
Rear courtesy lamp, courtesy mirror.
F28 A or B
15
Audio system.
F30
20
Rear wiper.
F32
10
Audio amplifier.
Page 196 of 340
194
Practical information
Fuse
N°
Rating
(A)
Functions
F3
15
Driver's electric window panel, 12 V socket for rear seats.
F4
15
12 V socket in boot.
F5
30
One-touch rear window.
F6
30
One-touch front window.
F11
20
Trailer unit.
F12
20
Audio amplifier.
F15
20
Panoramic sunroof blind (SW).
F16
5
Driver's electric window switch panel.
Fuses behind the glove box
Page 197 of 340
8
195
Practical information
Engine compartment fuses
Access to the fuses
)
Unclip the cover.
)
Change the fuse (see corresponding
paragraph).
)
When you have finished, close the cover
carefully to ensure correct sealing of the
fusebox.
Fuse
N°
Rating
(A)
Functions
F20
15
Front /rear screenwash pump.
F21
20
Headlamp wash pump.
F22
15
Horn.
F23
15
Right-hand main beam headlamp.
F24
15
Left-hand main beam headlamp.
F27
5
Left hand lamp mask.
F28
5
Right hand lamp mask. The fusebox is placed in the engine
compar tment near the battery.
Page 202 of 340
200
Practical information
Changing a wiper blade
Before removing a front
wiper blade
)
Within one minute after switching off
the ignition, operate the wiper stalk to
position the wiper blades vertically on the
windscreen.
Removing
)
Raise the corresponding wiper arm.
)
Unclip the wiper blade and remove it.
Fitting
)
Put the corresponding new wiper blade in
place and clip it.
)
Fold down the wiper arm carefully.
After fitting a front wiper
blade
)
Switch on the ignition.
)
Operate the wiper stalk again to park the
wiper blades.
Page 203 of 340
8
201
i
!
Practical information
Towing the vehicle
Procedure for having your vehicle towed or for towing another vehicle using a removable towing eye.
Towing your vehicle
Towing another vehicle
Access to the tools
The towing eye is installed in the boot under
the floor.
To gain access to it:
)
open the boot,
)
position the floor ver tically,
)
remove the towing eye.
)
On the front bumper, unclip the cover by
pressing at the bottom.
)
Screw the towing eye in fully.
)
Install the towing bar.
)
Switch on the hazard warning lamps on the
towed vehicle.
)
On the rear bumper, unclip the cover by
pressing at the bottom.
)
Screw the towing eye in fully.
)
Install the towing bar.
)
Switch on the hazard warning lamps on the
towed vehicle.
When towing with all four wheels on the
ground, always use a towing bar.
When towing with only two wheels on
the ground, always use professional
lifting equipment.
When towing with the engine off, there
is no longer any braking or steering
assistance.
)
Place the gear lever in neutral
(position N
on the electronic gear
control gearbox or automatic
gearbox).
Failure to obser ve this special
condition could result in damage
to cer tain braking components and
the absence of braking assistance
the next time the engine is started.
Page 204 of 340
202
i
Practical information
Towing a trailer, a caravan, etc.
We recommend the use of genuine
PEUGEOT towbars and their harnesses
that have been tested and approved
from the design stage of your vehicle,
and that the fitting of the towbar is
entrusted to a PEUGEOT dealer or a
qualified workshop.
If the trailer is not fitted by a PEUGEOT
dealer, it is imperative that it is fitted
using the vehicle's electrical pre-
equipment, in accordance with the
manufacturer's instructions.
Towbar suitable for the attachment of a
trailer or caravan with additional lighting and
signalling.
Your vehicle is primarily designed for
transpor ting people and luggage, but it may
also be used for towing a trailer.
Driving with a trailer places greater demands
on the towing vehicle and the driver must take
particular care.
Blanking cover
When towing, you must remove the blanking
cover in the front bumper if your vehicle has
one.
Contact a PEUGEOT dealer or a qualified
workshop for this.
