2011 Peugeot 508 oil

216
i
Checks





























Checks
Unless other wise indicated, check these components in accordance with the Maintenance and Warranty Guide and according to your engine.
Other wise, have them checked by a PEUGEOT dealer or a qualified workshop.


Battery

The battery does not require any
maintenance.
However, check that the terminals
are clean and correctly tightened,
particularly in summer and winter.
When carrying out work on the battery, refer to the "Practical
information" section for details of the precautions to be taken
before disconnecting the battery and following its reconnection.

Refer to the Maintenance and
Warranty Guide for details of the
replacement inter vals for these
components.
Depending on the environment (e.g. dusty
atmosphere) and the use of the vehicle
(e.g. city driving), replace them twice as often
if necessary
(refer to the "Engines" section).
A clogged passenger compar tment filter may
have an adverse effect on the per formance
of the air conditioning system and generate
undesirable odours.

Air filter and passenger compartment filter

Replace the oil filter each time the
engine oil is changed.

Refer to the Maintenance and
Warranty Guide for details of
the replacement inter val for this
component.


Oil filter






The presence of this label, in particular with
the Stop & Star t system, indicates the use of
a specific 12 V lead-acid battery with special
technology and specification, for which the
involvement of a PEUGEOT dealer or a
qualified workshop is required when replacing
or disconnecting the battery.
Failure to obser ve this recommendation may
shor ten the life of the battery.










Particle emission filter (Diesel)

Display of this warning lamp or a specific
message, together with the ser vice warning lamp,
indicates the star t of saturation of the par ticle
filter or low level in the Diesel additive reser voir.
As soon as the traffic conditions permit,
regenerate the filter by driving at a
speed of at least 40 mph (60 km/h) until
the ser vice warning lamp goes off.
If the ser vice warning lamp stays on,
this indicates a low additive level. Have
the additive reser voir topped up and
the par ticle emission filter ser viced
by a PEUGEOT dealer or a qualified
workshop.
Following prolonged operation of the
vehicle at very low speed or at idle,
you may, in exceptional circumstances,
notice the emission of water vapour at
the exhaust on acceleration. This does
not affect the behaviour of the vehicle or
the environment.

9
217
!
Checks






Manual gearbox

The gearbox does not require any
maintenance (no oil change).
Refer to the Maintenance and Warranty
Guide for the details of the level
checking interval for this component.







6-speed electronic gearbox
system
The gearbox does not require any
maintenance (no oil change).
Refer to the Maintenance and
Warranty Guide for details of the
checking interval for this component.







Automatic gearbox

The gearbox does not require any
maintenance (no oil change).

Refer to the Maintenance and
Warranty Guide for details of the
level checking inter val for this
component. Brake wear depends on the style
of driving, par ticularly in the case
of vehicles used in town, over shor t
distances. It may be necessary to
have the condition of the brakes checked, even
between vehicle services.
Unless there is a leak in the system, a drop in
the brake fluid level indicates that the brake
pads are worn.
















Brake pads

For information on checking brake
disc wear, contact a PEUGEOT
dealer or a qualified workshop.


Brake disc wear

Manual parking brake

If a loss of effectiveness of this
system is noticed, the parking brake
must be checked, even between
two ser vices.
Checking this system must be done by a
PEUGEOT dealer or a qualified workshop.






















Electric parking brake

This system does not require any
routine servicing. However, in the
event of a problem, have the system
checked by a PEUGEOT dealer or a
qualified workshop.
For more information, see "Driving - Electric
parking brake - § Operating faults".
















Only use products recommended by
PEUGEOT or products of equivalent
quality and specification.
In order to optimise the operation
of units as impor tant as the braking
system, PEUGEOT selects and offers
very specific products.
To avoid damaging the electrical units,
the use of a high pressure washer
in the engine compar tment is strictly
prohibited
.

218
Technical data


ENGINES AND GEARBOXES



Petrol engines


1.6 litre VTi

120 hp



1.6 litre THP

15 6 hp



Gearboxes

Electronic gear control
(6 -speed)
Manual
(6 -speed)
Automatic
(6 -speed)

Model codes

8D5FH8/P - 8E5FH8/P
8D5FS8/P - 8E5FS8/P
8D5FV8 - 8E5FV8
8D5FNA - 8E5FNA
8 D5 F VA - 8 E5 F VA
Cubic capacity (cc)
1 598
1 598
Bore x stroke (mm)
77 x 85.8
77 x 85.8
Max power: EU standard (kW)
85
88
11 0
115
Max power engine speed (rpm)
6 000
6 000
Max torque: EU standard (Nm)
160
240
Max torque engine speed (rpm)
4 250
1 400
Fuel
Unleaded
Unleaded
Catalytic conver ter
yes
yes

OIL CAPACITIES (in litres)



Engine (with filter replacement)
4.25
4.25

10
221
Technical data


ENGINES AND GEARBOXES



Diesel engine


1.6 litre HDi

110 h p



Gearbox
es

Manual
(5 -speed)
Electronic gear control
(6 -speed)

Model codes

8D9HL0 - 8E9HL0
8D9HR8/PS - 8E9HR8/PS

Outline

Saloon
SW
Saloon
SW
Cubic capacity (cc)
1 560
1 560
Bore x stroke (mm)
75 x 88.3
75 x 88,3
Max power: EU standard (kW)
82
82
Max power engine speed (rpm)
3 600
3 600
Max torque: EU standard (Nm)
240
270
Max torque engine speed (rpm)
1 750
1 750
Fuel

Diesel
Catalytic conver ter

yes
Particle emission filter

yes

OIL CAPACITIES (in litres)



Engine (with filter replacement)
3.25

222
Technical data


ENGINES AND GEARBOXES



Diesel engines


2.0 litre HDi
14 0 hp



2.0 litre HDi
163 hp



2.0 litre HDi




Gearboxes

Manual
(6 -speed)
Automatic
(6 -speed)
-

Model codes

8DRHR8 - 8ERHR8
8DRHF8 - 8ERHF8
8DRHHA - 8ERHHA
8DRHDA - 8ERHDA
-

Outline

Saloon
SW
Saloon
SW
Saloon
SW
Cubic capacity (cc)
1 997
1 997
-
Bore x stroke (mm)
85 x 88
85 x 88
-
Max power: EU standard (kW)
10 0
103
10 0
120
-
Max power engine speed (rpm)
4 000

3 750
-
Max torque: EU standard (Nm)
320
340
-
Max torque engine speed (rpm)
2 000
2 000
-
Fuel

Diesel
Catalytic conver ter

yes
Particle emission filter
yes
no

OIL CAPACITIES (in litres)






Engine (with filter replacement)
5.25
5
-

10
223
Technical data


ENGINES AND GEARBOXES



Diesel
engine


2.2 litre HDi
204 hp



Gearbox

Automatic
(6 -speed)

Model codes


8D4HLA - 8E4HLA

Outline

Saloon
SW
Cubic capacity (cc)

2 179
Bore x stroke (mm)

85 x 96
Max power: EU standard (kW)
15 0
Max power engine speed (rpm)
3 500
Max torque: EU standard (Nm)
450
Max torque engine speed (rpm)
2 000
Fuel

Diesel
Catalytic conver ter

yes
Particle emissions filter

yes

OIL
CAPACITIES (in litres)



Engine (with filter replacement)
5.25

231





JBL EQUIPMENT


The HiFi system is a 5.1 system developed jointly by PSA and JBL.

4 two-way speaker kits, separated by an active fi lter, are fi tted at front and
rear.
These are based on a fabric dome tweeter delivering stable and balanced
treble reproduction and a 50W RMS neodymium magnet inverted motor
medium-woofer possessing a very high output of bass frequencies.
The central line in the dashboard improves reproduction of the musical
scene, putting the listener in a situation that realistically reproduces the
original musical recording.
The bass unit located in the boot carries a 150 W triple-coil true
subwoofer in an optimised space, giving depth and impact to the bass
ranges.
This set of speakers is controlled by a 10-way 500 W RMS 2 ohm
amplifi er, using advanced surround sound and sound distribution
handling, so as to deliver optimum performance both for the driver and for
the passengers in the vehicle.

249
04
35
1
2
4
NAVIGATION - GUIDANCE


Press NAV
to display the
" Navigation - guidance
" menu.


MAP MANAGEMENT


SELECTING THE POINTS OF INTEREST DISPLAYED ON THE MAP


Select " Map management
" and confi rm.
Select from the various categories the
ones that you want to display on the
screen.

Select " Map details
" and confi rm.
Select " By default
" to have only " Oil stations, garages
" and
" Accident-prone area
" appear on the map (if installed in the
system).

Select " OK
" then confi rm and select
" OK
" again then confi rm to save the
modifi cations.