Page 54 of 236
2
COMFORT
Front armrest
Heated seats adjustment
You can move the console housing cover
in order to use it as an armrest.
With the engine running
, tilt the button to
the position required.
The temperature of the seat is regulated
automatically.
There are two setting positions:
- "HI": High heating
- "LO": Low heating
When the button is in the intermediate
position, the heating is switched off.
The indicator lamps A
come on when
the system is activated.
Head restraint height adjustment
)
To raise it, pull upwards.
)
To lower it, push it downwards,
pressing the height adjustment but-
ton at the same time.
)
To remove it, raise it to the high
position, then remove it pressing
the height adjustment button at the
same time.
)
To r efi t it, engage the rods of the head
restraint in the apertures, pressing the
height adjustment button at the same
time. Never drive with the removed
head restraints in the vehicle as
they could be thrown around the
vehicle on sharp braking. They
must always be in place and ad-
justed correctly.
After installing the head restraint, check that the height adjustment
button has engaged correctly.
The adjustment is correct when
the top of the head restraint is
aligned with the top of the head
of the seated person.
Page 63 of 236
2
COMFORT
OOR MIRRORSDOOR MIRRORS
Electric folding/unfolding
- from inside, with the ignition switch
in the "ON" or "ACC" position
)
by pressing the control C
.
- from inside, with the ignition switch
in the "LOCK" position:
)
by pressing the control C, within
30 seconds.
- from outside using the remote con-
trol:
)
by pressing the "closed padlock
button briefl y 3 times to fold them,
)
by pressing the "open padlock" but-
ton briefl y 3 times to unfold them.
Adjustment
The mirrors can be adjusted when the
ignition switch is in the "ON" or "ACC"
position.
)
Move control A
to the right or to
the left to select the corresponding
mirror.
)
Direct control B
in all four directions
to adjust the mirror.
When adjustment is complete, return
control A
to the central position. If you switch the engine off then
re-start it with the mirrors folded,
they will unfold automatically
when the vehicle reaches 20 mph
(30 km/h).
If the mirrors have been folded
manually or electrically after
starting the engine, they are not
unfolded automatically.
In this case:
)
Press the control C
to unfold
them.
If you have folded the mirrors
using the control C
, you must
use this control to unfold them,
otherwise the mirrors will not be
lock in place correctly.
The folding and unfolding of the door
mirrors can be confi gured via the
colour screen "Equipment" menu or
deactivated by a PEUGEOT dealer
or a qualifi ed workshop.
The mirrors can also be folded manually.
Page 73 of 236
2
COMFORT
Stowing rings
There are four stowing rings in the boot
for securing luggage:
-
two rings are located on the boot fl oor,
- two rings are located on the rear side
pillars.
*
On 5-seat version only. Raise the boot fl oor to gain access to
this compartment.
Right-hand side enclosed storage
compartment
This storage compartment contains the
tools for changing a wheel.
Storage compartment in the fl oor *
12 V socket (120 W max)
This operates when the ignition switch
is in the "ON" or "ACC" position.
Lift the cover to gain access to the
socket.
Check that the electrical equip-
ment operates on 12 V and that
its maximum electrical power is
120 W.
The prolonged use of electrical
equipment without running the
engine may discharge the bat-
tery.
Page 76 of 236
3
ACCESS
The vehicle will relock automati-
cally after thirty seconds unless
a door or the tailgate is opened.
This function prevents inadver-
tent unlocking.
The duration which precedes
the automatic relocking of the
vehicle can be confi gured via
the colour screen "Equipment"
menu.
Folding the key
)
First press button A
to fold the key.
Electronic engine immobiliser
The key contains an electronic chip
which has a special code. When the
ignition is switched on, this code must
be recognised to permit starting.
This electronic engine immobiliser locks the engine management system a few
moments after the ignition is switched
off and prevents starting of the engine
by anyone who does not have the key.
Anti-theft protection
In the event of a malfunction and if
your vehicle does not start, contact a
PEUGEOT dealer as soon as possible.
Page 77 of 236
3
ACCESS
Starting the vehicle
)
Insert the key in the ignition switch.
)
Operate the starter by turning the
key to position 4 (START)
.
)
When the engine turns over, release
the key. The ignition switch is placed
in position 3 (ON)
automatically.
Switching the vehicle off
)
Park the vehicle.
)
While pressing the key, turn it to-
wards you to position 1 (LOCK)
.
)
Remove the key from the ignition
switch.
Changing the battery
Battery reference: CR1616/3 volts.
)
Unclip the casing using a coin at the
notch.
)
Slide the fl at battery out of its housing.
)
Slide the new battery into its housing
observing the original direction.
)
Clip the casing.
Key in ignition
A buzzer sounds on opening the
driver's door, if the key has been
left in the ignition.
Page 78 of 236
3
ACCESS
Keys
Make a careful note of the number of each key. This number is coded on the label attached to the key.
If the keys are lost, a PEUGEOT dealer can supply you with new keys.
Do not throw the remote control batteries away, they contain metals which are harmful to the environment.
Take them to an approved collection point.
Remote control
The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a
possibility that it may unlock the vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of range and out of sight of your vehicle. You run the
risk of stopping it from working.
The remote control does not operate when the key is in the ignition, even when the ignition is switched off.
Locking the vehicle
Driving with the doors locked may make access to the passenger compartment by the emergency services more
diffi cult in an emergency.
As a safety precaution (with children on board), remove the key from the ignition when you leave the vehicle, even for a short time.
Anti-theft protection
Do not make any modifi cations to the electronic engine immobiliser system, this could cause malfunctions.
When purchasing a second-hand vehicle
Have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your possession are the only ones
which can start the vehicle.
Page 86 of 236
3
ACCESS
FUEL TANK Opening the cap may cause an inrush
of air. This vacuum, which is completely
normal, is caused by the sealing of the
fuel system.
To fi ll the tank safely:
)
the engine must be switched off,
)
pull the control A
located at the bot-
tom right of the driver’s seat to re-
lease the fuel fi ller fl ap,
)
open the fuel fi ller fl ap B
,
)
turn the fi ller cap C
to the left,
When you have fi lled the tank:
)
refi t the fi ller cap, inserting the
upper part fi rst,
)
screw in the fi ller cap to the right,
)
close the fl ap.
Ensure that the fuel fi ller fl ap is closed
correctly.
)
remove the fi ller cap C
,
)
fi ll the tank, but do not continue af-
ter the 3rd cut-off of the nozzle
;
this could cause malfunctions.
Low fuel level
Filling
A label, affi xed on the inside of the fl ap,
reminds you of the type of fuel to be
used according to your engine.
More than 5 litres of fuel must be add-
ed in order to be registered by the fuel
gauge. When the low fuel level is
reached, this indication ap-
pears on the instrument
panel screen. When it fi rst
comes on, approximately
10 litres of fuel remain.
The symbol fl ashes slowly
(approxi-
mately once per second).
When the symbol begins to fl ash
rapidly
(approximately twice per
second), there is not much fuel
remaining in your tank (approxi-
mately 5 litres).
You must fi ll the tank to avoid
running out of fuel.
This symbol indicates that the
fuel tank cap is located on the
left-hand side of the vehicle.
Location of the cap
1.
Opening.
2.
Closing.
Capacity of the tank: approximately
60 litres.
Page 87 of 236
3
ACCESS
Quality of the fuel used for
petrol engines
The petrol engines are perfectly compa-
tible with E10 or E24 type petrol biofuels
(containing 10 % or 24 % etha
nol), con-
forming to European standards EN 228
and EN 15376.
E85 type fuels (containing up to
85 % ethanol) are reserved exclusive-
ly for vehicles marketed for the use of
this type of fuel (BioFlex vehicles). The
quality of the ethanol must comply with
European standard EN 15293.
For Brazil only, special vehicles are
marketed to run on fuels containing up
to 100 % ethanol (E100 type).
Quality of the fuel used for
Diesel engines
The Diesel engines are perfectly com-
patible with biofuels which conform to
current and future European standards
(Diesel fuel which complies with stan-
dard EN 590 mixed with a biofuel which
complies with standard EN 14214)
available at the pumps (containing up
to 7 % Fatty Acid Methyl Ester).
The B30 biofuel can be used in cer-
tain Diesel engines; however, this use
is subject to strict application of the
special servicing conditions. Contact a
PEUGEOT dealer or a qualifi ed work-
shop.
The use of any other type of (bio)fuel
(vegetable or animal oils, pure or diluted,
domestic fuel...) is strictly prohibited
(risk of damage to the engine and fuel
system).
