2011 Peugeot 308 SW BL Battery

1
191
PRACTICAL INFORMATION

Table of mini and midi-fuses above the battery

Table of maxi-fuses

Fuse N°



Rating


Functions



F1



-

Not used.


F2



5 A

Dual-function brake switch.


F3



5 A

Battery charge unit.


F4



25 A

ABS/ESP electrovalves.


F5



-

Not used.


F6



15 A

Gearbox (electronic gear control or automatic).


F7 *



80 A

Power steering electropump assembly.


F8 *



60 A

Fan assembly.


F9 *



70 A/30 A

Pre-heat unit (Diesel)/Valvetronic electric motor
(1.6 l THP 16V).


F10 *



40 A

ABS/ESP electropump assembly.


F11 *



100 A

Switching and protection unit.


F12 *



30 A

Electronic gear control gearbox electropump assembly.


Fuse N°



Rating


Functions



MF1 *




-

Not used.


MF2 *



30 A

Trailer fusebox.


MF3 *



50 A

Dashboard fusebox.


MF4 *



80 A

Built-in systems interface.


MF5 *



80 A

Built-in systems interface.


MF6 *



-

Not used.


MF7 *



30 A

Heated seats.


MF8 *



20 A

Headlamp wash.
*
The midi-fuses and maxi-fuses pro-
vide additional protection for the
electrical systems. All work on these
types of fuse must be carried out by a
PEUGEOT dealer.

1
i
192
PRACTICAL INFORMATION
BATTERY
Procedure for charging your battery
when it is fl at or for starting the engine
using another battery.

Access to the battery
Disconnecting/Reconnecting
the cables


)
Raise the locking plate 1
fully.

)
Position the open clip of the cable
on the positive terminal (+) of the
battery.

)
Press vertically on the clip 2
to
position it correctly against the
battery.

)
Lock the clip by lowering the plate 1
.


Starting using another battery

Do not force the plate as locking is
impossible if the clip is positioned
incorrectly.
Start the procedure again.

)
Connect the red cable to the positive
terminal (+) of the fl at battery A
,
then to the positive terminal (+) of
the slave battery B
.
The battery is located under the bonnet.
To gain access to it:


)
open the bonnet using the interior
release lever, then the exterior
safety catch,

)
secure the bonnet stay,

)
remove the plastic cover to gain
access to the two terminals,

)
unclip the fuse box to remove the
battery, if necessary.

1
!
i
193
PRACTICAL INFORMATION
Do not disconnect the terminals
while the engine is running.
Do not charge the batteries without
disconnecting the terminals fi rst.
Do not push the vehicle to start the
engine if it is fi tted with a 6-speed
electronic gear control gearbox.
The batteries contain harmful sub-
stances such as sulphuric acid and
lead. They must be disposed of in
accordance with regulations and
must not, in any circumstances, be
discarded with household waste.
Take used remote control batteries
and vehicle batteries to a special
collection point.
It is advisable to disconnect the
battery if the vehicle is to be left un-
used for more than one month.
Before disconnecting the battery
Wait 2 minutes after switching off
the ignition before disconnecting
the battery.
Close the windows and the doors
before disconnecting the battery.

Following reconnection of the
battery
Following reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to permit
initialisation of the electronic sys-
tems. However, if problems are en-
countered following this operation,
contact a PEUGEOT dealer.
Referring to the corresponding sec-
tion, you must yourself reinitialise:


- the remote control key,

- the panoramic sunroof blind,

- the GPS satellite navigation
system.




Charging the battery using a
battery charger


)
Disconnect the battery from the
vehicle.

)
Follow the instructions for use
provided by the manufacturer of the
charger.

)
Reconnect starting with the negative
terminal (-).

)
Check that the terminals and connectors
are clean. If they are covered with
sulphate (whitish or greenish deposit),
remove them and clean them.


)
Connect one end of the green
or black cable to the negative
terminal (-) of the slave battery B
.

)
Connect the other end of the green
or black cable to the earth point C

on the broken down vehicle.

)
Operate the starter, let the engine
run.

)
Wait until the engine returns to idle
and disconnect the cables.

1
!
i
194
PRACTICAL INFORMATION
A fl at battery prevents the engine
from starting (refer to the corre-
sponding paragraph). If the telephone is being used at
this time:


- it will be maintained for 10 minutes
with the hands-free kit of your
Peugeot Connect Sound,

- it will be maintained for 10 minutes
with the Peugeot Connect
Navigation or the Peugeot
Connect Media, then it will transfer
to your telephone depending on
the telephone model.

ENERGY ECONOMY MODE

System which manages the duration of
use of certain functions to conserve a
suffi cient level of charge in the battery.
After the engine has stopped, you can
still use functions such as the audio and
telematics system, windscreen wip-
ers, dipped beam headlamps, courtesy
lamps, etc. for a maximum combined
duration of thirty minutes.

Exiting economy mode

These functions are reactivated auto-
matically next time the vehicle is driven.


)
In order to resume the use of these
functions immediately, start the
engine and let it run:


- for less than ten minutes, to use
the equipment for approximately
fi ve minutes,

- for more than ten minutes, to
use the equipment for up to
approximately thirty minutes.



Switching to economy mode

Once the thirty minutes are over, a
message appears on the multi-function
screen indicating that the vehicle has
switched to economy mode and the ac-
tive functions are put on standby.
CHANGING A WIPER BLADE

Removing



)
Raise the corresponding wiper arm.

)
Unclip the wiper blade and remove it.



Fitting



)
Put the corresponding new wiper
blade in place and clip it.

)
Fold down the wiper arm carefully.



Before removing a front wiper
blade


)
Within one minute after switching off
the ignition, operate the wiper stalk
to position the wiper blades vertically
on the windscreen.



After fitting a front wiper blade



)
Switch on the ignition.

)
Operate the wiper stalk again to
park the wiper blades.

LOAD REDUCTION MODE
System which manages the use of certain
functions according to the level of charge
remaining in the battery.
When the vehicle is being driven, the load
reduction function temporarily deactivates
certain functions, such as the air condition-
ing, the heated rear screen...
The deactivated functions are reactivated
automatically as soon as conditions permit.

230

EMERGENCY CALLASSISTANCE CALL
OPERATION OF THE SYSTEM
In an emergency, press this button for more than 2 seconds. Flashing of the green diode and a voice message confi rm that the call has been made to the PEUGEOT Emergency team *
.
Pressing this button again immediately cancels the request. The greendiode switches off.
The green diode remains on (without fl ashing) when communication is established. It switches off at the end of communication.
This call is dealt with by the PEUGEOT Emergency team which receives locating information from the vehicle and can send a detailed alert to the appropriate emergency services. In countries in which the team is not operational, or when the locating service has been expressly refused,the call is dealt with directly by the emergency services (11 2) without thevehicle location.


If an impact is detected by the airbag ECU, and independently of any triggering of the airbags, an emergency call is made automatically.

*

This service is subject to conditions and availability. Consult a PEUGEOT dealer.


Press this button for more than 2 seconds to requestassistance if the vehicle breaks down. A voice message confi rms that the call has been made * .


Pressing this button again immediately cancels the request.
The cancellation is confi rmed by a voice message.



When the ignition is switched on, the greenindicator lamp comes on for 3 seconds indicating that the system is operating correctly.


If the orange indicator lamp fl ashes: there isa system malfunction.
If the orange indicator lamp is lit continuously:the backup battery must be replaced.
In both cases, consult a PEUGEOT dealer.

233
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1
RADIOMEDIANAVESCTRAFFICSETUPADDRBOOK

The Peugeot Connect Media is protected in such away that it will only operate in your vehicle. If it is to beinstalled in another vehicle, contact a PEUGEOT dealer for confi guration of the system.
Certain functions described in this handbook will become available during the course of the year.
Peugeot Connect Media
MULTIMEDIA AUDIO EQUIPMENT/BLUETOOTH TELEPHONE
gg


GPS EUROPE



For safety reasons, it is imperative that the driver carriesout operations which require prolonged attention while the vehicle is stationary.
When the engine is switched off and to prevent discharging of the battery, the Peugeot Connect Mediaswitches off following the activation of the EnergyEconomy mode.



●
01 First steps
CONTENTS


●
02 General operation


●
03 Navigation - Guidance


●
04 Traffi c information


●
05 Radio


●
06 Music media players


●
07 Making a telephone call


●
08 Confi guration


●
09 Voice commands and
steering mounted controls


●
10 Screen menu map


●
Frequently asked questions
p.
p.
p.
p.
p.
p.
p.
p.
p.
p.
p.
234
236
240
248
250
251
256
260
261
264
268

260
5
6
SETUPABCDEF5JKL4GHI68TUV7PQRS90*#
MEDIANAVESCTRAFFICADDRBOOKSETUP1
2
3
4
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIOMEDIANAVESCTRAFFICSETUPADDRBOOK
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIOMEDIANAVESCTRAFFICSETUPADDRBOOK
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIOMEDIANAVESCTRAFFICSETUPADDRBOOK
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIOMEDIANAVESCTRAFFICSETUPADDRBOOK
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIOMEDIANAVESCTRAFFICSETUPADDRBOOK
08CONFIGURATION
SETTING THE DATE AND TIME
Set the parameters using the ring and move on to the next using the4-direction navigator. Press OK to confi rm.
Select the "Date format" function andpress OK to confi rm. Select the format required using the ring and press OK to confi rm.
Select the "Set date & time" functionand press OK to confi rm.
Pressing the SETUP button for more than 2 seconds ppermits access to:


This setting operation must be carried out if the batteryy has been disconnected.


Press the SETUP button.

Select the "Time format" function and press OK to confi rm. Select the format required using the ring and press OK to confi rm.
SET DATE & TIME
Select the "Date & Time" function and press OK to confi rm.

DESCRIPTION OF THE UNIT

GPS COVERAGE

DEMO MODE


DATE & TIME
Principle of the GPS synchro (GMT):1. Confi rm the "Synchronise with GPS" selection, the time is then set to GMT universal time,the date is also updated.2. Using the 4-direction navigator, move the cursor to the time fi elds and press OK.3. You can then use the ring to set the time to the time zone of your choice. Take care when changing between summer/winter time, the time zone must be changed again manually.

This function provides access to the options in the SETUP menu.

269
QUESTION
ANSWER SOLUTION
The stored stations do not function (no sound,87.5 Mhz is displayed...)
An incorrect waveband is selected.
Press RADIO, select Radio Menu then "Waveband" to return to the waveband on which the stations arestored.

The quality of reception of the radio station listened to gradually deterioratesor the stored stations donot function (no sound,87.5 Mhz is displayed...).
The vehicle is too far from the transmitter used by the station listened to or there is no transmitter in the geographical area through which the vehicle is travelling.
Activate the "RDS" function by means of the short-cut menu to enable the system to check whether there is a more powerful transmitter in the geographical area.
The environment (hills, buildings, tunnels, basement car parks...) block reception, including in RDS mode.
This phenomenon is normal and does not indicate a failure of the audio equipment.
The aerial is absent or has been damaged (for example when goingthrough a car wash or into an underground car park).
Have the aerial checked by a PEUGEOT dealer.
Sound cut-outs of 1 to 2 seconds in radio mode. During this brief sound cut-out, the RDS searches for any frequencypermitting better reception of the station.
Deactivate the "RDS" function by means of the short-cut menu if the phenomenon is too frequent and always on the same route.

With the engine off, thesystem switches off after a few minutes of use.
When the engine is switched off, the system's operating time depends on the battery charge. The switch-off is normal: the system switches to economy mode and switches off to prevent discharging of the vehicle's battery.
Start the vehicle's engine to increase the battery charge.