2011 Peugeot 308 CC fold seats

3
!
i
64
COMFORT






Additional manual
adjustments
Additional electric
adjustments

Access to the rear seats


)
Pull the control A
upwards to fold
the seat back, the seat moves for-
ward automatically.
When putting the seat back in place,
press the control B
until the seat re-
turns to its initial position.
Access to the rear seats


)
Pull the control upwards to fold the seat
back, then move the seat forward.
When putting the seat back in place,
move it back holding it by the centre
of the seat back, the seat returns to
its initial position.
Check that no person or object is pre-
venting the seat slide from returning
to its initial position; the return to this
position is necessary for longitudinal
locking.
This function is deactivated while
driving.

3
!
!
66
COMFORT











STORING DRIVING POSITIONS

System which takes into account the
electrical settings of the driver's seat
and the door mirrors. It enables you to
store two positions using the buttons on
the side of the driver's seat.

Recalling a stored position

Storing a position

When the ignition is off, after a few
consecutive position recalls, the
function will be deactivated until
the engine is started, to prevent
discharging of the battery.


Using buttons M/1/2


)
Switch on the ignition.

)

Adjust your seat and your door mirrors.


)
Press button M
, then press button 1

or 2
within four seconds.
An audible signal is heard indicating
that the settings have been stored.
Storing a new position cancels the pre-
vious position.
















REAR SEATS

Fixed two-seat bench fi tted with roll-
over bars to guarantee your protection
should the vehicle roll over.
Do not place any article of cloth-
ing on the rear head restraints.
Contact a PEUGEOT dealer to see
the range of suitable covers. The rear head restraints are fi xed. They
incorporate the roll-over hoops (refer to
the section "Safety - § Roll-over hoops").
The bench rear seat may be fi tted with a
folding comfort armrest in the centre of
the seat back.
Using button 1 or 2


)
Press and hold button 1
or 2
until
the audible signal is heard indicat-
ing the end of the adjustment.

7
!
i
11 9
SAFETY












"ISOFIX" MOUNTINGS

Your vehicle is approved with regulation
ISOFIX mountings.
The diagram below indicates the seats
which are fi tted with these mountings:
These are two rings A
for each seat, lo-
cated between the seat back and seat
cushion of the vehicle's seat, indicated
by a label.
The incorrect installation of a child
seat in a vehicle compromises the
protection of the child in the event
of a collision. For installing ISOFIX child seats
in your vehicle, refer to the table
showing the locations for fi tting
ISOFIX child seats. These rings are located behind covers.
For access to them:


)
insert the ignition key in the cut-out
in the cover,

)
pull it forwards to unclip it and then
fold it down.

The ISOFIX child seats
are fi tted with
two latches which are secured easily on
these rings A
.
This ISOFIX mounting system provides
reliable, safe and fast fi tting of the child
seat in your vehicle.