Page 56 of 248
2
!
i
COMFORT
54
REAR SEATS
Bench seat the left-hand part (2/3) or
right-hand part (1/3) of which can be
folded to adapt the load space in the
boot.
Never drive with the head re-
straints removed; they must be in
place and correctly adjusted.
As the head restraints are not in-
terchangeable, take care to put
them back in their original position
when refi tting.
Rear head restraints
These have a high position (comfort)
and a low position (rear visibility).
The command for activation of
heating of the seat(s) remains
memorised for two minutes after
the ignition has been switched off.
7. Heated seats switch
With the engine running, the front seats
can be heated separately.
)
Use the adjustment dial, placed on
the side of each front seat, to switch
on and select the level of heating re-
quired:
0
:
Off.
1
:
Low.
2
:
Medium.
3
:
High.
They can also be removed; to remove them:
)
pull the head restraint upwards to
the stop,
)
then, press the lug.
6. Armrests (except 3 door)
These can be folded down and are re-
movable.
)
To remove an armrest, press the but-
ton located between the armrest and
the side of the seat and pull it off.
Page 58 of 248
2
!
i
COMFORT
56
Folding the seat (SW)
This operation can be carried out at the
rear seats or through the opening rear
screen.
To avoid damaging a seat when folding it:
)
move the corresponding front seat
forward if necessary,
)
place the head restraints in the low
position, Check that no object could hinder
the movement of the bench seat,
either above or below.
Repositioning the seat (SW)
The seat cushion lowers in order
to be covered by the seat back;
this quickly gives you a fl at boot
fl oor.
)
pull the control 1
forward to release
the seat back 2
which folds easily
onto the seat cushion 3
.
)
When repositioning the rear seat,
straighten the seat back 2
and lock it.
)
Check that the red indicator, located
at control 1
, is no longer visible.
Page 65 of 248
2COMFORT
63
BOOT FITTINGS (SALOON)
1.
Rear parcel shelf
(see details on following page)
2.
Hooks
(see details on following page)
Page 66 of 248
2
i
COMFORT
64
Hooks
Rear parcel shelf (Saloon)
To remove the shelf:
)
unhook the two cords,
)
raise the shelf slightly, then remove it. The hooks can be used to secure shop-
ping bags.
When changing a wheel
The hooks facilitate access to the
spare wheel by holding up the
boot carpet by its cord.
You have two storage options:
- either upright behind the front seats,
- or upright behind the rear seats.
Page 67 of 248
2COMFORT
65
BOOT FITTINGS (SW)
1.
Rear parcel shelf
(see details on following page)
2.
12 V accessories socket
(see details on following page)
3.
Hooks
(see details on previous page)
4.
Retaining straps
5.
Stowing rings
6.
High load retaining net
(see details on following page)
7.
Storage box
8.
Storage net
9.
Storage box
(refer to the section "Practical infor-
mation - § Changing a wheel")
Page 68 of 248
2
i
COMFORT
66
Rear parcel shelf (SW)
This consists of three sections which
can be folded back on each other.
To store it, fold it on itself and place it
vertically at the back of the boot.
To fold it from the boot:
)
take hold of the rear parcel shelf by
its strap A
,
)
fold it concertina-style to the rear
seats.
To unfold it from the boot:
)
take hold of the rear parel shelf by
its strap A
,
)
unfold it to the boot pillars.
To gain access from the rear seats:
)
raise the front section of the rear
parcel shelf using the handle B
.
12 V accessory socket (SW)
)
In order to connect a 12 V accesso-
ry (max power: 120 Watts), remove
the cap and connect the appropriate
adaptor.
)
Turn the key to the ignition on position.
Maximum loads
7.5 kg, rear parcel shelf unfolded
with high load retaining net at row 2.
Page 69 of 248
2
i
COMFORT
67
High load retaining net (SW)
Hooked onto the upper fi xings and onto
the ISOFIX rings or the lugs, this per-
mits use of the entire loading volume up
to the roof:
- behind the rear seats (row 2),
- behind the front seats (row 1) when
the rear seats are folded.
To use it in row 1:
)
open the covers of the upper fi xings 1
,
)
unroll the high load retaining net,
)
position one of the ends of the net's
metal bar in the corresponding
upper fi xing 1
, then do the same
with the other end,
)
slacken the straps fully,
)
fi x the snap hook of each of the straps
on the corresponding lug 3
, located
under the bench seat cushion,
)
fold the rear seats,
)
tighten the straps without raising the
bench seat,
)
check that the net is hooked and
tightened correctly. To use it in row 2:
)
fold or remove the load space cover,
)
open the covers of the upper fi xings 2
,
)
unroll the high load retaining net,
)
position one of the ends of the net's
metal bar in the corresponding upper
fi xing 2
, then do the same with the
other end,
)
attach the hook of each of the net's
straps in the corresponding ISOFIX
ring 4
,
)
tighten the straps,
)check that the net is hooked and
tightened correctly.
When positioning the net, check
that the strap loops are visible from
the boot; this will make slackening
or tightening easier.
Page 70 of 248
3
i
ACCESS
68
REMOTE CONTROL KEY
System which permits central unlocking
or locking of the vehicle using the lock
or remotely. It also locates and starts
the vehicle, as well as providing protec-
tion against theft.
Unfolding the key
)
First press button A
to unfold the
key.
Unlocking the vehicle
Unlocking is confi rmed by rapid fl ashing
of the direction indicators for approxi-
mately two seconds.
According to version, the door mirrors
unfold at the same time.
Locking the vehicle
)
Press the open padlock to
unlock the vehicle.
Unlocking using the key
)
Turn the key to the left in the driver's
door lock to unlock the vehicle.
Normal locking using the key
)
Turn the key to the right in the driv-
er's door lock to lock the vehicle.
Locking is confi rmed by fi xed lighting of
the direction indicators for approximate-
ly two seconds.
According to version, the door mirrors
fold at the same time.
Unlocking using the remote control
)
Press the closed padlock
to lock the vehicle.
)
Press the closed padlock
for more than two seconds
to close the windows auto-
matically in addition to lock-
ing (with sequential electric
windows).
If one of the doors or the boot is
still open, the central locking does
not take place.
Normal locking using the remote
control
