2011 NISSAN ALTIMA COUPE flat tire

[x] Cancel search: flat tire

Page 317 of 446

NISSAN ALTIMA COUPE 2011 D32 / 4.G Owners Manual 2. Place the ignition switch in the OFF orLOCK position, and wait approximately 10
seconds.
3. Repeat steps 1 and 2.
4. Restart the engine while holding the device (which may have caused the interfere

Page 329 of 446

NISSAN ALTIMA COUPE 2011 D32 / 4.G Owners Manual CAUTION
During the first 1,200 miles (2,000 km) ,
follow these recommendations to obtain
maximum engine performance and en-
sure the future reliability and economy of
your new vehicle. Failure to foll

Page 335 of 446

NISSAN ALTIMA COUPE 2011 D32 / 4.G Owners Manual FREEING A FROZEN DOOR LOCK
To prevent a door lock from freezing, apply de-
icer through the key hole. If the lock becomes
frozen, heat the key before inserting it into the key
hole or use the remote k

Page 338 of 446

NISSAN ALTIMA COUPE 2011 D32 / 4.G Owners Manual 6 In case of emergency
Emergency engine shut off.........................6-2
Flat tire ...........................................6-2
Tire Pressure Monitoring System (TPMS) ..........6-2
Changing a fl

Page 339 of 446

NISSAN ALTIMA COUPE 2011 D32 / 4.G Owners Manual To shut off the engine in an emergency situation
while driving perform the following procedure:
– Rapidly push the push-button ignition switch 3consecutive times, or
– Push and hold the push-butto

Page 340 of 446

NISSAN ALTIMA COUPE 2011 D32 / 4.G Owners Manual ●Replacing tires with those not originally
specified by NISSAN could affect the
proper operation of the TPMS.
● Do not inject any tire liquid or aerosol
tire sealant into the tires, as this may
ca

Page 345 of 446

NISSAN ALTIMA COUPE 2011 D32 / 4.G Owners Manual 4. Lower the vehicle slowly until the tiretouches the ground. Then, with the wheel
nut wrench, tighten the wheel nuts securely
in the sequence illustrated (
A,B,C,D,
E) . Lower the vehicle comple

Page 397 of 446

NISSAN ALTIMA COUPE 2011 D32 / 4.G Owners Manual 2. With the first pin in position2, align the
second pin with its hinge slot
1and push
down on the cover to completely engage it.
A snap sound will be heard. 3. Close the cover. If you have a flat t
Page:   < prev 1-8 9-16 17-24 25-32 next >