2011 Mercury Mariner ignition

[x] Cancel search: ignition

Page 236 of 362

Mercury Mariner 2011  Owners Manuals sideways out of control or roll over. Remember, your safety and the
safety of others should be your primary concern.
WARNING:Vehicles with a higher center of gravity such as
utility and four-wheel dri

Page 238 of 362

Mercury Mariner 2011  Owners Manuals Mud and water
If you must drive through high
water, drive slowly. Traction or
brake capability may be limited.
When driving through water,
determine the depth; avoid water
higher than the bottom of th

Page 243 of 362

Mercury Mariner 2011  Owners Manuals Using roadside assistance
Complete the roadside assistance identification card and place it in your
wallet for quick reference. In the United States, this card is found in the
Owner Guide portfolio in

Page 244 of 362

Mercury Mariner 2011  Owners Manuals This switch is located in the front
passenger’s footwell, behind a
flip-up cover, by the kick panel
access cover.
To reset the switch:
1. Turn the ignition to the off
position.
2. Check the fuel sys

Page 247 of 362

Mercury Mariner 2011  Owners Manuals Fuse/Relay
LocationFuse Amp
RatingProtected Circuits
15 10A Climate control
16 15A Not used (spare)
17 20A All lock motor feeds, Liftgate
release, Liftglass release
18 20A Heated seat
19 25A Rear wipe

Page 250 of 362

Mercury Mariner 2011  Owners Manuals Fuse/Relay
LocationFuse Amp
RatingProtected Circuits
14 15A* Trailer tow turn lamps
15 — Not used
16 40A** Cooling fan 1
17 40A** Cooling fan 2
18 20A** ABS solenoid
19 30A** Power seats
20 — A/C

Page 278 of 362

Mercury Mariner 2011  Owners Manuals •Spray MotorcraftEngine Shampoo and Degreaser (ZC-20) on all
parts that require cleaning and pressure rinse clean. In Canada, use
MotorcraftEngine Shampoo (CXC-66-A).
•Cover the highlighted area

Page 307 of 362

Mercury Mariner 2011  Owners Manuals Running out of fuel
Avoid running out of fuel because this situation may have an adverse
effect on powertrain components.
If you have run out of fuel:
•You may need to cycle the ignition from off to