2011 Mercury Mariner spare tire

[x] Cancel search: spare tire

Page 251 of 362

Mercury Mariner 2011  Owners Manuals Fuse/Relay
LocationFuse Amp
RatingProtected Circuits
31F — Liftgate latch relay
32 — Not used
33 — PCM diode
34 — Start diode
35 10A* Run/start, Reverse lamps, Rear
defrost relay
36 — Not us

Page 252 of 362

Mercury Mariner 2011  Owners Manuals Dissimilar spare tire/wheel information
WARNING:Failure to follow these guidelines could result in an
increased risk of loss of vehicle control, injury or death.
If you have a dissimilar spare tire/wh

Page 253 of 362

Mercury Mariner 2011  Owners Manuals 3.Full-size dissimilar spare without label on wheel
When driving with the full-size dissimilar spare tire/wheel,do not:
•Exceed 70 mph (113 km/h)
•Use more than one dissimilar spare tire/wheel at

Page 254 of 362

Mercury Mariner 2011  Owners Manuals Stopping and securing the vehicle
1. Park on a level surface, set the
parking brake and activate hazard
flashers.
2. Place gearshift lever in P (Park)
and turn engine off.
Removing the jack and tools

Page 255 of 362

Mercury Mariner 2011  Owners Manuals 3. Remove the lug wrench from the
jack in order to remove the spare
tire from under the vehicle.
Removing the spare tire or spare tire and tether (if equipped)
1. Insert the lug wrench through the
acc

Page 256 of 362

Mercury Mariner 2011  Owners Manuals 5. Use the lug wrench to remove the
lug nut from the spare tire tether.
6. If not replacing the spare or flat
tire to the underbody storage area,
raise winch up into the installed
position.
7. Use the

Page 259 of 362

Mercury Mariner 2011  Owners Manuals 3. Position the jack according to the
guides and turn the jack handle
clockwise until the tire is a
maximum of 1 inch (25 mm) off the
ground.
Be sure to place the jack away
from the rear edge of the r

Page 260 of 362

Mercury Mariner 2011  Owners Manuals 7. Remove the jack and fully tighten
the lug nuts in the order shown.
Refer toWheel lug nut torque
specificationslater in this chapter
for the proper lug nut torque
specification.
Stowing the jack and
Page:   < prev 1-8 9-16 17-24 25-32 next >