2011 MERCEDES-BENZ CLS-CLASS language

Messages in the multifunction
display
........................................... 247
Switching on/off .............................. 87
Lamps, indicator and warning
ABS .......................................... 28, 252
Brakes ........................................... 252
Coolant .......................................... 257
Distance warning
lamp .............................. 131, 137, 256
Engine malfunction .................. 28, 257
ESP ®
........................................ 28, 255
Fog lamps ........................................ 89
Front passenger front air bag
off ...................................... 31, 41, 260
Fuel tank reserve ..................... 29, 256
High-beam headlamps ...............28, 90
Instrument cluster .........................251
Low-beam headlamps ................ 28, 87
Low tire pressure/TPMS
malfunction telltale ........................ 259
Seat belt telltale ................28, 48, 253
SRS .......................................... 36, 254
Turn signals ..................................... 28
Language, selecting ..........................120
LATCH-type child seat anchors (ISOFIX) see Children in the vehicle
License plate lamps
Messages in the multifunction
display ........................................... 248
Replacing bulbs ............................. 267
Light alloy wheels, cleaning .............220
Lighter see Cigarette lighter
Lighting ................................................ 86
Daytime running lamp mode ............88
Exterior ............................................ 87
Interior ............................................. 91
Limp-home mode .............................. 108
Load index (tires) ......................202, 206
Loading see Vehicle loading
Locator lighting ................................. 121
Lock button
Outside door handle (KEYLESS-
GO) .................................................. 69Locking the vehicle

KEYLESS-GO .................................... 67
Manually ........................................ 262
SmartKey ......................................... 66
Loss of
Key .................................................. 70
Service and Warranty Information
booklet .......................................... 288
Low-beam headlamps ......................... 87
Exterior lamp switch ........................ 87
Indicator lamp .................................. 28
Replacing bulbs ............................. 267
Switching on .................................... 87
Lubricants .......................................... 296
Luggage box ...................................... 227
Lumbar support ................................... 79 M
Maintenance ........................................ 20
Maintenance System Service indicator display

................215
Service indicator message ............. 214
Service term exceeded ..................215
Manual headlamp mode (Low-
beam headlamps) ................................ 87
Manual shift program .......................107
Maximum engine speed see Vehicle specification
Maximum loaded vehicle weight .....206
Maximum load rating (tires) .............206
Maximum permissible tire
inflation pressure .............................. 207
Mechanical key see Key, Mechanical
Media interface ................................. 158
Memory function ................................. 85
Menus see Control system menus
Minispare wheel
see Spare wheel
Mirrors .................................................. 84
Auto-dimming rear view mirrors ....... 84
Exterior rear view mirror parking
position ............................................ 85
Exterior rear view mirrors ................ 84
Interior rear view mirror ................... 84 Index
11 219_AKB; 4; 54, en-US
d2ureepe,
Version: 2.11.8.1 2009-05-11T16:21:02+02:00 - Seite 11
ProCarManuals.com

G
Warning!
No messages will be displayed if either the
instrument cluster or the multifunction
display is inoperative.
As a result, you will not be able to see
information about your driving conditions,
such as
R speed
R outside temperature
R warning/indicator lamps
R malfunction/warning messages
R failure of any systems
Driving characteristics may be impaired.
If you must continue to drive, do so with added
caution. Contact an authorized Mercedes-
Benz Center as soon as possible. :
Reset button
For information on changing the instrument
cluster settings, e.g. the language, see
(Y page 119). Activating the instrument cluster
The instrument cluster is activated when you
R open a front door
R switch on the ignition
R press reset button :
R switch on the exterior lamps Adjusting the instrument cluster
illumination
X To brighten illumination: Turn reset
button : clockwise until the desired level
of illumination is reached.
X To dim illumination: Turn reset
button : counterclockwise until the
desired level of illumination is reached.
i The instrument cluster illumination is
dimmed or brightened automatically to suit
ambient light conditions.
The instrument cluster illumination will also
be adjusted automatically when you switch
on the vehicle’s exterior lamps. Coolant temperature indicator
G
Warning!
Driving when your engine is overheated can
cause some fluids which may have leaked into
the engine compartment to catch fire. You
could be seriously burned.
Steam from an overheated engine can cause
serious burns which can occur just by opening
the engine hood. Stay away from the engine
if you see or hear steam coming from it.
Stop the vehicle in a safe location away from
other traffic. Turn off the engine, get out of the
vehicle and do not stand near the vehicle until
the engine has cooled down.
During severe operating conditions, e.g. stop-
and-go traffic, the coolant temperature may
rise close to 248‡ (120†).
! Excessive coolant temperature triggers a
warning in the multifunction display and the
red coolant temperature warning
lamp ? in the instrument cluster comes
on.
The engine should not be operated with a
coolant temperature above 248‡ (120†).
Doing so may cause serious engine damage
which is not covered by the Mercedes-Benz
Limited Warranty. Instrument cluster
109Controls in detail
219_AKB; 4; 54, en-US
d2ureepe, Version: 2.11.8.1 2009-05-11T16:21:02+02:00 - Seite 109 Z
ProCarManuals.com

Resetting trip odometer
X Make sure you are viewing the standard
display ( Y page 112) in the multifunction
display.
X Press and hold the reset button in the
instrument cluster (Y page 108) until the
trip odometer is reset. Tachometer
The red marking on the tachometer
(Y page 28) denotes excessive engine speed.
! Avoid driving at excessive engine speeds,
as it may result in serious engine damage
that is not covered by the Mercedes-Benz
Limited Warranty.
To help protect the engine, the fuel supply is
interrupted if the engine is operated within
the red marking. Control system
Introduction
The control system is activated as soon as the
starter switch is in position 1.
The control system enables you to call up
information about your vehicle and to change
vehicle settings.
For example, you can use the control system
to find out when your vehicle is next due for
maintenance service, to set the language for
messages in the instrument cluster display,
and much more. G
Warning!
A driver’s attention to the road and traffic
conditions must always be his/her primary
focus when driving.
For your safety and the safety of others,
selecting features through the multifunction
steering wheel should only be done by the driver when traffic and road conditions permit
it to be done safely.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approximately
14 m) every second.
The control system relays information to the
multifunction display. Multifunction steering wheel
The displays in the multifunction display and
the settings in the control system are
controlled by using the buttons on the
multifunction steering wheel. :
Multifunction display
;
Press button
W
X
to select submenus in the
Settings menu
to set values
to operate the RACETIMER
7
to set the volume 7
AMG vehicles only. 110
Control systemControls in detail
219_AKB; 4; 54, en-US
d2ureepe,
Version: 2.11.8.1 2009-05-11T16:21:02+02:00 - Seite 110
ProCarManuals.com

Submenus in the Settings menu
X
Press button V or U repeatedly until
the Settings menu appears in the
multifunction display.
X Press button &.
The collection of the submenus appears in
the multifunction display. There are more
submenus than can be displayed
simultaneously. X
Press button X.
The selection marker moves to the next
submenu.
X Scroll down with button X, scroll up
with button W.
X With the selection marker on the desired
submenu, use button & to access the
individual functions within that submenu.
X Once within the submenu, use button
& to move to the next function or button
* to move to the previous function
within that submenu.
X Use button W or X to change the
settings of the respective function.
The following lists show what settings can be
changed within the various menus. Detailed
instructions on making individual settings can
be found on the following pages.
Instrument cluster submenu
R Selecting speedometer display mode
(Y page 120)
R Selecting language ( Y page 120) R
Selecting display (speed or outside
temperature) for status line ( Y page 120)
R Selecting display (speed or outside
temperature) for standard display
(Y page 120)
Lighting submenu
R Switching daytime running lamp mode on
or off (USA only) (Y page 121)
R Switching locator lighting on or off
(Y page 121)
R Setting ambient lighting ( Y page 122)
R Switching night security illumination
(Headlamps delayed shut-off feature) on or
off (Y page 122)
R Switching interior lighting delayed shut-off
on or off ( Y page 123)
Vehicle submenu
R Switching automatic central locking on or
off (Y page 123)
Convenience submenu
R Activating easy-entry/exit feature
(Y page 124)
Instrument cluster submenu Access the
Instr. Cluster submenu via
the Settings menu. Use the Instr.
Cluster submenu to change the instrument
cluster display settings.
The following functions are available:
R Selecting speedometer display mode
(Y page 120)
R Selecting language ( Y page 120)
R Selecting display (speed or outside
temperature) for status line ( Y page 120)
R Selecting display (speed or outside
temperature) for standard display
(Y page 120) Control system
119Controls in detail
219_AKB; 4; 54, en-US
d2ureepe, Version: 2.11.8.1 2009-05-11T16:21:02+02:00 - Seite 119 Z
ProCarManuals.com

Selecting speedometer display mode
X
Press button V or U repeatedly until
the Settings menu appears in the
multifunction display.
X Press button &.
X Move the selection marker with button
W or X to the Instr. Cluster
submenu.
X Press button & or * repeatedly until
the message Display Unit Speed-/
Odometer appears in the multifunction
display.
The selection marker is on the current
setting. X
Press button W or X to set
speedometer unit to Km or Miles.
Selecting language
X Press button V or U repeatedly until
the Settings menu appears in the
multifunction display.
X Press button &.
X Move the selection marker with button
W or X to the Instr. Cluster
submenu.
X Press button & or * repeatedly until
the message Language appears in the
multifunction display.
The selection marker is on the current
setting. X
Press button W or X to select the
language to be used for the multifunction
display messages.
Selecting display (speed or outside
temperature) for status line
X Press button V or U repeatedly until
the Settings menu appears in the
multifunction display.
X Press button &.
X Move the selection marker with button
W or X to the Instr. Cluster
submenu.
X Press button & or * repeatedly until
the message Status Line Display
appears in the multifunction display.
The selection marker is on the current
setting. X
Press button W or X to select the
status line to Speed or Outside Temp..
You will see the status line display when
you have called up a different display from
the standard display.
Selecting display (speed or outside
temperature) for standard display
X Press button V or U repeatedly until
the Settings menu appears in the
multifunction display.
X Press button &.
X Move the selection marker with button
W or X to the Instr. Cluster
submenu.
X Press button & or * repeatedly until
the message Basic Display appears in
the multifunction display.
The selection marker is on the current
setting. 120
Control systemControls in detail
219_AKB; 4; 54, en-US
d2ureepe,
Version: 2.11.8.1 2009-05-11T16:21:02+02:00 - Seite 120
ProCarManuals.com