2011 MAZDA MODEL TRIBUTE garage door opener

The moon roof has a sliding shade that can be opened or closed when
the glass panel is shut. To close the shade, pull it toward the front of the
vehicle.
Accessory delay:
With accessory delay, the window switches, audio system, and moon roof
(if equipped) may be used for up to 10 minutes after the ignition switch
is turned off or until either front door is opened.
UNIVERSAL GARAGE DOOR OPENER (IF EQUIPPED)
Your vehicle may be equipped with a universal garage door opener which
can be used to replace the common hand-held transmitter.
Car2UHome Automation System (if equipped)
The Car2UHome Automation
System is a universal transmitter
located in the driver’s visor that
includes two primary features – a
garage door opener and a platform
for remote activation of devices
within the home. The Car2U
system’s garage door opener
function replaces the common
hand-held garage door opener with a three-button transmitter that is
integrated into the interior of your vehicle. After being programmed for
garage doors, the Car2Usystem transmitter can be programmed to
operate security devices and home lighting systems.
WARNING:Make sure that people and objects are clear of the
garage door or security device you are programming. Do not
program the Car2Usystem with the vehicle in the garage.
Do not use the Car2Usystem with any garage door opener that lacks
safety stop and reverse features as required by U.S. Federal Safety
Standards (this includes any garage door opener manufactured before
April 1, 1982).
Be sure to keep the original remote control transmitter for use in other
vehicles as well as for future Car2Usystem programming. It is also
recommended that upon the sale or lease termination of the vehicle, the
programmed Car2Usystem buttons should be erased for security
reasons. Refer toErasing the Car2UHome Automation System
buttonslater in this section.
Driver Controls
63
2011 Tribute(j14)
Owners Guide, 1st Printing
USA(fus)

Read the instructions completely before attempting to program the
Car2Usystem. Because of the steps involved, it may be helpful to have
another person assist you in programming the transmitter.
Additional Car2Usystem information can be found on-line at
www.learcar2U.com or by calling the toll-free Car2Usystem help line at
1-866-572-2728.
Types of garage door openers (rolling code and fixed code)
The Car2UHome Automation System may be programmed to operate
rolling code and fixed code garage door openers.
•Rolling code garage door openers were produced after 1996 and are
code protected. Rolling code means the coded signal is changed every
time your remote control garage door opener is used.
•Fixed code garage door openers were produced prior to 1996. Fixed
code uses the same coded signal every time. It is manually
programmed by setting DIP switches for a unique personal code.
If you do not know if your garage
door opener is a rolling code or
fixed code device, open your garage
door opener’s remote control battery
cover. If a panel of DIP switches is
present your garage door opener is
a fixed code device. If not, your
garage door opener is a rolling code
device.
Rolling code programming
Note:Programming the rolling code garage door opener involves
time-sensitive actions. Read the entire procedure prior to beginning so
you will know which actions are time-sensitive. If you do not follow the
time-sensitive actions, the device will time out and you will have to
repeat the procedure.
Note:Do not program the Car2Usystem with the vehicle in the garage.
Make sure that your key is on and engine off while programming the
transmitter.
12
34
5
6789
1
01
1
1
2
C
T
S
206-12 T
124
O
N
Driver Controls
64
2011 Tribute(j14)
Owners Guide, 1st Printing
USA(fus)

1. Firmly press the two outer
Car2Usystem buttons for
1–2 seconds, then release.
2. Go to the garage to locate the
garage door opener motor and
its “learn” button. You may need
a ladder to reach the unit and
you may need to remove the
unit’s cover or light lens to
locate the “learn” button. Press
the “learn” button, after which
you will have 10–30 seconds to
return to your vehicle and
complete the following steps. If
you cannot locate the “learn” button, refer to the Owner’s Manual of
your garage door opener or call the toll-free Car2Usystem help line
at 1-866-57Car2U (1-866-572-2728).
3. Return to your vehicle. Press
and hold the Car2Usystem
button you would like to use to
control the garage door. You
may need to hold the button
from 5–20 seconds, during
which time the selected button
indicator light will blink slowly.
Immediately (within 1 second) release the button once the garage
door moves. When the button is released, the indicator light will
begin to blink rapidly until programming is complete.
4. Press and release the button again. The garage door should move,
confirming that programming is successful. If your garage door does
not operate, repeat the previous steps in this section.
Driver Controls
65
2011 Tribute(j14)
Owners Guide, 1st Printing
USA(fus)

After successful programming, you will be able to operate your Car2U
system by pressing the button you programmed to activate the opener.
The indicator light above the selected button will turn on to confirm that
the Car2Usystem is responding to the button command.
To program another rolling code device such as an additional garage door
opener, a security device or home lighting, repeat Steps 1 through 4
substituting a different function button in Step 3 than what you used for
the garage door opener. For example, you could assign the left-most
button to the garage door, the center button to a security device, and
the right-most button to another garage door opener.
Note:The Car2Usystem allows for three devices to be programmed. If
you need to change or replace any of the three devices after it has been
initially programmed, it is necessary to erase the current settings using
theErasing the Car2UHome Automation System buttonsprocedure
and then programming all of the devices being used.
Fixed code programming
Note:Do not program the Car2Usystem with the vehicle in the garage.
Make sure that your key is on and engine off while programming the
transmitter.
1. To program units with fixed code DIP switches, you will need the
garage door hand-held transmitter, paper and a pen or pencil.
2. Open the battery cover and record the switch settings from left to
right for all 8 to 12 switches. Use the figure below:
When a switch is in the up, on, or + position, circle “L.”
When a switch is in the middle, neutral, or 0 position, circle “M.”
Driver Controls
66
2011 Tribute(j14)
Owners Guide, 1st Printing
USA(fus)

6. The indicator light will (begin to) blink rapidly until programming is
complete. If your garage door opener does not operate following
these steps, repeat Steps 2 through 6. Otherwise, call the toll-free
Car2Uhelp line at 1-866-57Car2U (1-866-572-2728).
After successful programming, you will be able to operate your Car2U
system by pressing the button you programmed to activate the opener.
The indicator light above the selected button will turn on to confirm that
the Car2Usystem is responding to the button command.
Erasing the Car2UHome Automation System buttons
Note:The system allows for three devices to be programmed. If you
need to change or replace any of the three devices after it has been
initially programmed, it will be necessary to erase the current settings
using the procedure below and then reprogramming all of the devices
being used.
To erase programming on the Car2Usystem (individual buttons cannot
be erased), use the following procedure:
1. Firmly press the two outside
Car2Usystem buttons
simultaneously for
approximately 20 seconds until
the indicator lights begin to
blink rapidly. The indicator
lights are located directly above
the buttons.
2. Once the indicator lights begin
to blink, release your fingers
from the buttons. The codes for
all buttons are erased.
If you sell your vehicle equipped with the Car2Usystem, it is
recommended that you erase the programming for security reasons.
FCC and RSS-210 Industry Canada Compliance
The Car2Usystem complies with Part 15 of the FCC rules and with
RSS-210 of Industry Canada. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received including interference
that may cause undesired operation.
Changes and modifications to the Car2Usystem transmitter by other
than an authorized service facility could void authorization to use the
equipment.
Driver Controls
68
2011 Tribute(j14)
Owners Guide, 1st Printing
USA(fus)

Event data recording ....................7
Exhaust fumes ..........................190
F
Fail safe cooling ........................286
Flexible Fuel Vehicle (FFV) ....288
Floor mats ...................................69
Fluid capacities .........................309
Fog lamps ....................................41
Four-Wheel Drive vehicles
driving off road .......................210
preparing to drive your
vehicle .....................................201
Fuel ............................................288
calculating fuel economy .......295
cap ...........................................291
capacity ...................................309
choosing the right fuel ...........292
detergent in fuel .....................294
filler funnel .............................294
filling your vehicle
with fuel ..................288, 291, 296
filter, specifications ................288
fuel pump shut-off switch .....218
improving fuel economy ........295
octane rating ...........292–293, 311
quality ......................................293
running out of fuel .........238, 294
safety information relating to
automotive fuels .....................288
Fuel - flex fuel vehicle
(FFV) .........................288, 292–293
Fuses ..................................219–220
G
Garage door opener ....................63
Gas cap (see Fuel cap) ............291Gas mileage (see Fuel
economy) ...................................295
Gauges .........................................17
H
Hazard flashers .........................218
Headlamps ...................................40
aiming ........................................43
bulb specifications ....................46
daytime running lights .............42
flash to pass ..............................42
high beam .................................41
replacing bulbs .........................47
turning on and off ....................40
Heating
manual heating and air
conditioning system .................36
Hood ..........................................271
I
Ignition ...............................186, 311
Illuminated visor mirror .............53
Infant seats
(see Safety seats) .....................135
Inspection/maintenance (I/M)
testing ........................................300
Instrument panel
cleaning ...................................261
cluster ........................................12
lighting up panel and
interior .......................................42
location of components ............12
J
Jack ............................................226
positioning ...............................226
storage .....................................226
Index
317
2011 Tribute(j14)
Owners Guide, 1st Printing
USA(fus)

T
Tilt steering wheel ......................52
Tire Pressure Monitoring
System (TPMS)
Tires, Wheels and Loading ....167
Tires ...........................151–153, 226
alignment ................................160
care ..........................................156
changing ..................226, 229, 231
checking the pressure ............156
inflating ...................................154
label .........................................166
replacing ..................................157
rotating ....................................160
safety practices .......................159
sidewall information ...............162
snow tires and chains ............172
spare tire .........................227, 229
terminology .............................153
tire grades ...............................152
treadwear ........................152, 156
Towing .......................................180
recreational towing .................184
trailer towing ..........................180
wrecker ....................................242
Transmission
automatic operation ...............203
brake-shift interlock (BSI) ....202
fluid, checking and adding
(automatic) .............................301fluid, checking and adding
(manual) .........................301, 304
fluid, refill capacities ..............309
lubricant specifications ..........309
manual operation ....................206
Trunk ...........................................71
Turn signal ..................................44
U
Universal garage door opener ....63
V
Vehicle Identification Number
(VIN) ..........................................312
Vehicle loading ..........................172
Ventilating your vehicle ...........191
W
Warning lights (see Lights) .......12
Washer fluid ..............................274
Water, Driving through .............216
Windows
power .........................................56
rear wiper/washer .....................52
Windshield washer fluid and
wipers ..........................................51
checking and adding fluid .....274
liftgate reservoir .....................274
replacing wiper blades ...........275
Wrecker towing .........................242
Index
320
2011 Tribute(j14)
Owners Guide, 1st Printing
USA(fus)