Feature High\bights
1516
You\fvehicle is equipped with an AUX o\f auxilia\f y jack
that will allow you to play you\f po\f table audio playe\f
th\fough the vehicle’s audio system\b Lea\fn the system
when pa\fked and do not let it dist\fact you while d\fiving\b
NO\b\f:
Available at you\f Mazda deale\f is the Genuine Mazda Accesso\f y 3\b5 mm
audio cable which can be used to connect you\f po\f table audio playe\f into the
aux jack\b
1Locate the AUX jack inside the cente\f console\b
2Plug 3\b5 mm audio cable into the po\f table audio playe\f and into the
AUXjack\b Tu\fn po\f table audio playe\f on\b
3Tu\fn the vehicle audio system on\b
4Push the AUX button on the audio face OR the MODE button on the
stee\fing wheel cont\fols\b
5Use the po\f table audio playe\f cont\fols to play music\b
POR\bABL\f AUD iO PLAY\fR iN\b\fGRA\b iON US iNG \b h\f AUX JACK
iMPOR\bAN\b:Set the volume level on you\f po\f table audio playe\f to the highest
level befo\fe disto\f tion sta\f ts, then adjust the volume on the audio system\b
NO\b\f: Do not rely completely on the BSM system \fnd be sure to loo\b over
your shoulder before ch\fnging l\fnes:
• The BSM system can assist the d\five\f in confi\fming the safety of the su\f\foundings,
but is not a complete substitute\b
• The d\five\f is \fesponsible fo\f ensu\fing safe lane changes and othe\f maneuve\fs\b
• Always pay attention to the di\fection in which the vehicle is t\faveling and the
vehicle’s su\f\foundings\b
• The BSM system does not ope\fate when the vehicle speed is lowe\f than about
20mph (32 km/h)\b
\burning BSM System Of f
To manually tu\fn the BSM system of f, push the BSM OFF switch on the dash\b
The BSM OFF indicato\f will illuminate in the inst\fument cluste\f when the BSM
system is of f\b The BSM system will automatically tu\fn on the next time the
vehicle is sta\f ted\b
Your Vehicle
Detection Areas
BLiND SPO\b MON i\bOR iNG (BSM) S YS\b\fM
The Blind Spot Monitoring (BSM\f system is designed to \bssist the driver
by monitoring the blind spots to the re\br of the vehicle on both sides.
• Ifyou\f vehicle speed is 20 mph (32 km/h) o\f mo\fe, the BSM will wa\fn
you of vehicles in the detection a\fea by illuminating the BSM wa\fning
lights located on the lef t and \fight doo\f mi\f\fo\fs\b
• Ifyou ope\fate a tu\fn signal in the di\fection of an illuminated BSM
wa\fning light, the system will also wa\fn you with a beep and wa\fning
light flash\b
• BSM senso\fs a\fe located unde\f the lef t and \fight \fea\f bumpe\f a\feas\b
The BSM system may not ope\fate p\fope\fly if the \fea\f bumpe\f gets too
di\f ty, so keep the \fea\f bumpe\f a\fea clean\b
Please \fefe\f to you\f Owne\f’s Manual fo\f complete details\b
280343_11a_Mazda_CX-7_SSG_091710c.indd 16-179/17/10 2:31 PM
2122
Mu\bti-I\fformatio\f Disp\bay (MID)
Maintenance Monitor
• Remindsyouofyou\fnextse\fviceand/o\fti\fe
\fotationbysimplyente\fingamileageand
numbe\fofdaysinte\fval\b
• Displays a message in the MID fo\f 5 seconds
eachtimethevehicleissta\ftedwhen
se\fvicedueo\fti\fe\fotationisnea\f(unless
ENTERispushed,whichclea\fsthe
messagecompletely)\b
•
To set, \feset, o\f tu\fn off the MaintenanceMonito\f (Needs to be \feset afte\f maintenance
to notify you fo\f the next se\fvice):
NO\b\f:
• Fo\f the se\f vice due notification, the numbe\f of days and distance can be
set\b Fo\f ti\fe \fotation notification, only the distance can be set\b
• Fo\f se\f vice due, the message appea\fs fo\f whicheve\f one occu\fs fi\fst,
mileage o\f numbe\f of days\b
M iD CON\bROLS (on steering wheel):
Push
Push
Push Push
ENTER \fN\b\fR (UP/DOWN) switch: Push up o\f down to select o\f change an
item, numbe\f, o\f lette\f (with highlight), then push in to ente\f\b
L\fF\b/R iG h\b buttons: Push the lef t and \fight buttons to move the
a\f\fows above and below the digit to be changed fo\f the Maintenance Monito\f\b
BACK BACK button:
Push to undo and/o\f \fetu\fn to the p\fevious sc\feen\b
M iD Setting
The MID can be used to change ce\f tain p\fefe\fences to you\f liking\b
They include:
\bo Change a Preference: 1 Push the INFO button seve\fal times until SET TINGS is displayed\b
2 Select PREFERENCES f\fom the menu\b
3 Select the item you want to change f\fom the menu\b
Push DOWN,
then
Push
Select OFF to tu\fn
Maintenance
Monito\f of f\b
Push
Push
Change mileage o\f days using UP/DOWN/RIGHT/LEF T, then push
ENTER\b When finished, push the INFO button to exit\b
• Distance Unit - km o\f miles
• Tempe\fatu\fe Unit - C ˚ o\f F ˚
• Time Zone (with
navigation) – to set you\f
time zone fo\f the clock
• Auto Adjust Clock
(with navigation) – to set
you\f clock using GPS •
Sc\feen Adjustment (with
navigation)/Sc\feen Of f
• Ale\f t Volume – high o\f low
• Tu\fn Signal Volume –
high o\f low
• Language Selection
• Resto\fe Defaults
(with navigation)
280343_11a_Mazda_CX-7_SSG_091710c.indd 22-239/17/10 2:32 PM
2324
Navigatio\f System
\fnter Your home Address
1 Push ENTER f\fom the Cu\f\fent Position (map) sc\feen\b
2 Select “Navigation Setup\b”
3 Select “Edit Memo\f y Point\b”
4 Select “Home\b”
5 Select how you want to input you\f home add\fess - eithe\f by ente\fing
an add\fess, o\f f\fom a p\fevious destination, point of inte\fest, memo\fy
point, inte\fsection, o\f f\fom the map\b
6 Ente\f you\f home add\fess\b
7 Select “Set” to \fegiste\f you\f home\b
8 Select “Done” to \fetu\fn to the map\b
Change the Volume of the Guidance
• Tu\fn the audio system volume dial while voice guidance is
being given\b
Set a Destination
You can choose setting a destination using a st\feet add\fess, point of inte\fest,
eme\fgency, memo\f y point, home, p\feset destination, p\fevious destination,
f\feeway on/of f \famp, coo\fdinates, o\f select f\fom map\b
1 Push ENTER f\fom the Cu\f\fent Position (map) sc\feen\b
2 Select “Set Destination\b”
3 Select “Add\fess\b”
4 Ifthe state is not displayed, select “Sea\fch A\fea\b”
5 Select the co\f\fect state f\fom the list\b
6 Select “Input City Name”, then use the ENTER (UP/DOWN) switch
to input the city name, then select the co\f\fect city f\fom the list\b
7 Use the ENTER (UP/DOWN) switch to input the st\feet name,
then select the co\f\fect st\feet f\fom the list\b
8 Use the ENTER (UP/DOWN) switch to input the house numbe\f\b
9 Select “Done\b”
10 Select “Sta\f t” to set the destination and sta\f t guidance\b
NO\b\f:
• The 2008 SD ca\fd included with you\f navigation system contains the most
cu\f\fent data available\b
• No\f th Up/Head Up: No\f th Up - Geog\faphic no\f th is up\b
HeadUp - The di\fection you a\fe heading is up\b
1Push ENTER f\fom the Cu\f\fent Position (map) sc\feen\b
2Select “Navigation Setup\b”
3Select “Map Di\fection\b”
4Select “No\f th Up” o\f “Head Up\b”
• Select “P\fefe\f” o\f “Avoid” fo\f toll \foads, majo\f \foads, fe\f\fies, \fest\ficted \foads
andbo\fde\f c\fossing\b
• Fo\f safety \feasons, some navigation system functions cannot be pe\f fo\fmed
while d\fiving the vehicle\b
•
Refe\f to you\f Navigation Owne\f’s Manual fo\f detailed navigation system ope\fation\b
ENTER \fN\b\fR (UP/DOWN):
•Pushupo\fdowntoselecto\fchangean
item,numbe\f,o\flette\f(withhighlight),
thenpushintoente\f\b
•Whenthemapsc\follcu\fso\fisdisplayed,
pushtozoomin/outthemapsc\feenand
tosc\follthemapsc\feenupo\fdown\b
L\fF\b/R iG h\b buttons:
•Pushtomovethecu\fso\fstothe\fightandleftonce\ftainsc\feens(when
a\f\fowsa\feshowneithe\ftothelefto\f\fight)\b
•Whenthemapsc\follcu\fso\fisdisplayed,pushtosc\follth\foughthecu\f\fent
position(map)sc\feentothe\fightandleft\b
•Pushtoswitchthesc\feenf\fomthemapsc\feentothetu\fnlistsc\feen(with
\fouteguidance)tothecompasssc\feen\b
NAVI NAV
i button: •Pushto switch to navigation - to the cu\f\fent position (map) sc\feen at any time\b
•Pushto\fepeatthevoiceguidanceafte\fitisdone\b
BACK BACK button:
Pushtoundoand/o\f\fetu\fntothep\fevioussc\feen\b
INFO i
NFO button: Pushtoswitchtothemulti-info\fmationdisplay(MID)\b
Next Road Name
Map Scale
Compass
Distance to
destination
\fstimated
arrival time
Vehicle Marker
Distance to intersection
and turn direction
Current Road Name
Operation Guide icon
COMPAC\b NAV iGA\b iON C ON\bROLS (on steering wheel)
280343_11a_Mazda_CX-7_SSG_091710c.indd 24-259/17/10 2:32 PM