2011 LEXUS RX350 ignition

459
4-3. Do-it-yourself maintenance
4

Maintenance and care
CAUTION
The engine compartment contains many mechanisms and fluids that may move sud-
denly, become hot, or become electrically energized. To avoid death or serious injury,
observe the following precautions:
nWhen working on the engine compartment
lKeep hands, clothing and tools away from the moving fan and engine drive belt.
lBe careful not to touch the engine, radiator, exhaust manifold, etc. right after driv-
ing as they may be hot. Oil and other fluids may also be hot.
lDo not leave anything that may burn easily, such as paper or rags, in the engine
compartment.
lDo not smoke, cause sparks or expose an open flame to fuel or the battery. Fuel
and battery fumes are flammable.
lBe extremely cautious when working on the battery. It contains poisonous and
corrosive sulfuric acid.
nWhen working near the electric cooling fan or radiator grille
Be sure the “ENGINE START STOP” switch is off.
With the “ENGINE START STOP” switch in IGNITION ON mode, the electric
cooling fan may automatically start to run if the air conditioning is on and/or the
coolant temperature is high. (→P. 4 7 2 )
nSafety glasses
Wear safety glasses to prevent flying or falling material, fluid spray, etc. from getting
in the eyes.
NOTICE
nIf you remove the air cleaner filter
Driving with the air cleaner filter removed may cause excessive engine wear due to
dirt in the air. Also a backfire could cause a fire in the engine compartment.

480
4-3. Do-it-yourself maintenance
nHow to initialize the tire pressure warning system
Park the vehicle in safe place and turn the “ENGINE START
STOP” switch off.
While the vehicle is moving, initialization is not performed.
Adjust the tire inflation pressure to the specified cold tire inflation
pressure level. (→P. 6 0 2 )
Make sure to adjust the tire pressure to the specified cold tire inflation
pressure level. The tire pressure warning system will operate based on
this pressure level.
Turn the “ENGINE START STOP” switch to IGNITION ON
mode.
Press and hold the tire pressure
warning reset switch until the tire
pressure warning light flashes
slowly 3 times.
Wait for a few minutes in “ENGINE START STOP” switch to on,
and then turn the “ENGINE START STOP” switch off.
STEP1
STEP2
STEP3
STEP4
STEP5

5

When trouble arises
529
5-1. Essential information
If you use chains or cables to tie
down your vehicle, the angles
shaded in black must be 45°.
Do not overly tighten the tie downs
or the vehicle may be damaged.
nBefore emergency towing
Release the parking brake.
Shift the shift lever to N.
Turn the “ENGINE START STOP” switch to ACCESSORY (engine off )
or IGNITION ON (engine running) mode.
nLocation of the emergency towing eyelet
→P. 5 6 5
CAUTION
nCaution while towing
lUse extreme caution when towing the vehicle.
Avoid sudden starts or erratic driving maneuvers which place excessive stress on
the emergency towing eyelets and the cables or chains. Always be cautious of the
surroundings and other vehicles while towing.
lIf the engine is not running, the power assist for the brakes and steering will not
function, making steering and braking more difficult.
nInstalling towing eyelets to the vehicle
Make sure that towing eyelets are installed securely.
If not securely installed, towing eyelets may come loose during towing. This may
lead to accidents that cause serious injury or even death.
STEP1
STEP2
STEP3

5

When trouble arises
541
5-2. Steps to take in an emergency
nIf the tire pressure warning system is not functioning
The tire pressure warning system will be disabled in the following conditions:
(When the condition becomes normal, the system will work properly.)
lIf tires not equipped with tire pressure warning valves and transmitters are used
lIf the ID code on the tire pressure warning valves and transmitters is not regis-
tered in the tire pressure warning computer
lIf the tire pressure warning select switch is set to a different tire setting.
lIf the tire inflation pressure is 73 psi (500 kPa, 5.1 kgf/cm2 or bar) or higher
The tire pressure warning system may be disabled in the following conditions:
(When the condition becomes normal, the system will work properly.)
lIf electronic devices or facilities using similar radio wave frequencies are nearby
lIf a radio set at similar frequencies is in use in the vehicle
lIf a window tint that affects the radio wave signals is installed
lIf there is a lot of snow or ice on the vehicle, in particular around the wheels or
wheel housings
lIf non-genuine Lexus wheels are used (Even if you use Lexus wheels, the tire
pressure warning system may not work properly with some types of tires.)
lIf tire chains are used
lIf the full-size spare tire is in a location subject to poor radio wave signal recep-
tion.
lIf a large metallic object which can interfere with signal reception is put in the
luggage compartment (vehicles with full-size spare tire).
nIf the tire pressure warning light comes on after flashing frequently for 1 minute
If the tire pressure warning light comes on after flashing frequently for 1 minute
when the “ENGINE START STOP” switch is turned to IGNITION ON mode, have
it checked by your Lexus dealer.
nCustomization
The vehicle speed linked seat belt reminder buzzer can be disabled.
(Customizable features →P. 6 2 1 )

5

When trouble arises
585
5-2. Steps to take in an emergency
nStarting the engine when the battery is discharged
The engine cannot be started by push-starting.
nTo prevent battery discharge
lTurn off the headlights and the audio system while the engine is off.
lTurn off any unnecessary electrical components when the vehicle is running at a
low speed for an extended period, such as in heavy traffic.
nWhen the battery is removed or discharged
The power back door must be initialized. (→P. 6 3 0 )
Connect a negative cable clamp to the negative (-) battery terminal
on the second vehicle
Connect the clamp at the other end of the negative cable to a solid,
stationary, unpainted metallic point away from the battery and any
moving parts, as shown in the illustration.
Start the engine of the second vehicle. Increase the engine
speed slightly and maintain that level for approximately 5 min-
utes to recharge the battery of your vehicle.
Open and close any of the doors with the “ENGINE START
STOP” switch off.
Maintain the engine speed of the second vehicle and start the
engine of your vehicle by turning the “ENGINE START STOP”
switch to IGNITION ON mode.
Once the vehicle’s engine has started, remove the jumper
cables in the exact reverse order from which they were con-
nected.
Once the engine starts, have the vehicle inspected at your Lexus
dealer as soon as possible.
STEP3
STEP4
STEP5
STEP6

599
6-1. Specifications
6

Vehicle specifications
Cooling system
Ignition system
Capacity
Without towing pack-
age9.1 qt. (8.6 L, 7.6 Imp. qt.)
With towing package10.0 qt. (9.5 L, 8.3 Imp. qt.)
Coolant type
Use either of the following.

655
Alphabetical index
Electric power steering ....................... 231
Electronic features control ................ 173
Electronic key
If the electronic key does not
operate properly ............................. 581
Emergency flasher switch .................524
Emergency, in case of
If the electronic key does not
operate properly ............................. 581
If the engine will not start ................577
If the shift lever cannot be
shifted from P ................................... 579
If the vehicle has a
discharged battery ........................ 584
If a warning buzzer sounds .......... 535
If a warning light turns on .............. 535
If a warning message is
displayed ............................................ 545
If you have a flat tire ........................ 564
If you lose your keys ....................... 580
If you think something is
wrong..................................................... 531
If your vehicle becomes stuck ....590
If your vehicle has to be stopped
in an emergency...............................591
If your vehicle needs to be
towed ................................................... 525
If your vehicle overheats................ 587
Engine
Accessory mode................................. 153
Compartment......................................463
Engine switch ........................................ 153
Hood ....................................................... 460
How to start the engine ................... 153
Identification number ...................... 595
If the engine will not start................ 577
Ignition switch ....................................... 153
Overheating ........................................ 587
Engine compartment cover ............. 464
Engine coolant
Capacity ................................................ 599
Checking ...............................................470
Preparing and checking
before winter ....................................254
Engine coolant temperature
gauge....................................................... 166
Engine immobilizer system..................101
Engine oil
Capacity .................................................597
Checking .............................................. 466
Preparing and checking
before winter ....................................254
Engine oil maintenance data............468
EPS .............................................................. 231
Event data recorder ............................533
E

657
Alphabetical index
I/M test ..................................................... 456
Identification
Engine..................................................... 595
Vehicle.................................................... 595
Ignition switch .......................................... 153
Illuminated entry system ................... 396
Indicator lights .........................................168
Initialization
Items to initialize ................................. 630
Inside rear view mirror.......................... 85
Interior lights
Interior lights ........................................ 396
Switch ...................................................... 397
Wattage .................................................605
Jack
Positioning a floor jack ..................... 461
Replacing the wheel ........................ 564
Jack handle ............................................. 564
Keyless entry................................................. 43
Keys
Electronic key ......................................... 26
Engine switch ........................................ 153
If the electronic key does not
operate properly ............................. 581
If you lose your keys ........................ 580
Ignition switch ....................................... 153
Key number ............................................. 26
Keyless entry ........................................... 43
Keys ............................................................. 26
Mechanical key ...................................... 27
Wireless remote control key .......... 43
I
J
K