2011 Lexus IS200d oil level

TABLE OF CONTENTSIndex
IS250/220d/200d_EE
6
5-2. Steps to take in an
emergency
If a warning light turns on
or a warning buzzer
sounds... .......................... 467
If a warning message is
displayed .......................... 473
If you have a flat tire
(vehicles with a spare tire) 485
If you have a flat tire
(vehicles with an
emergency tire
puncture repair kit)........... 497
If the engine will not start .. 512
If the shift lever cannot
be shifted from P .............. 514
If you lose your keys .......... 515
If the electronic key does
not operate properly ......... 516
If the vehicle battery is
discharged ........................ 521
If your vehicle overheats .... 525
If you run out of fuel and
the engine stalls ................ 528
If the vehicle becomes stuck .....
529
If your vehicle has to be
stopped in an emergency.. 5316-1. Specifications
Maintenance data
(fuel, oil level, etc.) .......... 534
Fuel information................. 553
6-2. Customization
Customizable features ........ 556
Abbreviation list ......................... 562
Alphabetical index ...................... 563
What to do if... ........................... 574
6Vehicle specifications
Index

239
2-5. Driving information
2
When driving
IS250/220d/200d_EE
Winter driving tips
Carry out the necessary preparations and inspections before driving
the vehicle in winter. Always drive the vehicle in a manner appropriate
to the prevailing weather conditions.
Pre-winter preparations
Use fluids that are appropriate to the prevailing outside
temperatures.
• Engine oil
• Engine coolant
• Washer fluid
Have a service technician inspect the level and specific
gravity of battery electrolyte.
Have the vehicle fitted with four snow tires or purchase a
set of tire chains for the rear tires.
Ensure that all tires are the specified size and the same brand, and
that chains match the size of the tires.
Before driving the vehicle
Perform the following according to the driving conditions.
Do not try to forcibly open a window or move a wiper that
is frozen. Pour warm water over the frozen area to melt the
ice. Wipe away the water immediately to prevent it from
freezing.
To ensure proper operation of the climate control system
fan, remove any snow that has accumulated on the air inlet
vents in front of the windshield.
Remove any ice that has accumulated on the vehicle chas-
sis.

398
IS250/220d/200d_EE
4-3. Do-it-yourself maintenance
Do-it-yourself service precautions
If you perform maintenance yourself, be sure to follow the correct pro-
cedures as given in these sections.
ItemsParts and tools
Battery condition (P. 415)
•Warm water
• Baking soda
• Grease
• Conventional wrench
(for terminal clamp bolts)
Engine coolant level (P. 413)
• “Toyota Super Long Life Cool-
ant” or similar high-quality eth-
ylene glycol-based non-silicate,
non-amine, non-nitrite and non-
borate coolant with long-life
hybrid organic acid technology.
“Toyota Super Long Life Cool-
ant” is pre-mixed with 50%
coolant and 50% deionized
water.
• Funnel (used only for adding
coolant)
Engine oil levelP. 409)
• “Toyota Genuine Motor Oil” or
equivalent
• Rag or paper towel, funnel
(used only for adding oil)
Fuses (P. 438)• Fuse with same amperage rating
as original
Radiator, condenser and inter-
cooler

405
4-3. Do-it-yourself maintenance
4
Maintenance and care
IS250/220d/200d_EE
Engine compartment
IS250
*: For right-hand drive vehicles:
They are located on the opposite side of the engine compartment.
Battery (P. 415)
Engine oil level dipstick
(P. 409)
Engine oil filler cap
(P. 410)
Fuse boxes (P. 438)
Washer fluid tank(P. 420)Electric cooling fans
Condenser (P. 415)
Radiator (P. 415)
Engine coolant reservoir
(P. 413)
*
*

406
4-3. Do-it-yourself maintenance
IS250/220d/200d_EE
IS220d and IS200d
*: For right-hand drive vehicles:
They are located on the opposite side of the engine compartment.
Battery (P. 415)
Engine oil level dipstick
(P. 409)
Engine oil filler cap
(P. 410)
Fuse boxes (P. 438)
Washer fluid tank(P. 420)Electric cooling fans
Condenser (P. 415)
Intercooler (P. 415)
Radiator (P. 415)
Engine coolant reservoir
(P. 413)
*
*

409
4-3. Do-it-yourself maintenance
4
Maintenance and care
IS250/220d/200d_EE
Engine oil
With the engine at operating temperature and turned off, check the
oil level on the dipstick.
Checking the engine oil
Park the vehicle on level ground. After warming up the
engine and turning it off, wait more than five minutes for
the oil to drain back into the bottom of the engine.
Hold a rag under the end and
pull the dipstick out.
Wipe the dipstick clean.
Reinsert the dipstick fully.
Holding a rag under the end, pull the dipstick out and check
the oil level.
Wipe the dipstick and reinsert it fully.
Low
Full
STEP1
STEP2
STEP3
STEP4
STEP5
STEP6

410
4-3. Do-it-yourself maintenance
IS250/220d/200d_EEAdding engine oil
If the oil level is below or near
the low level mark, add engine
oil of the same type as already
in the engine.
Make sure to check the oil type and prepare the items needed
before adding oil.
Remove the oil filler cap by turning it counterclockwise.
Add engine oil slowly, checking the dipstick.
Install the oil filler cap by turning it clockwise.
Engine oil
selectionP. 5 3 9
Oil quantity
(Low
 Full)1.5 L (1.6 qt., 1.3 Imp. qt.)
ItemsClean funnel
STEP1
STEP2
STEP3

411
4-3. Do-it-yourself maintenance
4
Maintenance and care
IS250/220d/200d_EE
Engine oil consumption
The amount of engine oil consumed depends on the oil viscosity, the
quality of the oil and the way the vehicle is driven.
More oil is consumed under driving conditions such as high speeds and
frequent acceleration and deceleration.
A new engine consumes more oil.
When judging the amount of oil consumption, keep in mind that the oil
may have become diluted, making it difficult to judge the true level
accurately.
Oil consumption: Max. 1.0 L per 1,000 km (1.1 qt./600 miles, 0.9 Imp.
qt./600 miles)
If your vehicle consumes more than 1.0 L (1.1 qt., 0.9 Imp. qt.) every
1000 km (600 miles), contact any authorized Lexus dealer or repairer, or
another duly qualified and equipped professional.
After changing the engine oil (IS220d and IS200d)
The oil change system should be reset. Perform the following procedures:
Switch the display to the odometer (P. 171) when the engine is
running.
Turn the “ENGINE START STOP” switch OFF.
While pressing the trip meter reset button, set the “ENGINE
START STOP” switch to IGNITION ON mode (but do not start the
engine because otherwise the reset mode will be cancelled). Con-
tinue to press and hold the button until the trip meter displays
“000000”.
STEP1
STEP2
STEP3