2011 Lexus IS200d ratio

520
5-2. Steps to take in an emergency
IS250/220d/200d_EEAfter the operation is com-
pleted, reinstall the cover.
Hook the upper claw of the
cover onto the upper catch on
the vehicle side, and then push
on the lower side of the cover.
Make sure that the lower claw
of the cover is securely fastened
to the lower catch on the vehicle
side. If the cover is not securely
attached, it may fall off while
driving.
Trunk
Turn the mechanical key clock-
wise to open.
STEP3

5
525
5-2. Steps to take in an emergency
When trouble arises
IS250/220d/200d_EE
Right-hand vehicles
Positive (+) battery terminal on your vehicle
Positive (+) battery terminal on the second vehicle
Negative (-) battery terminal on the second vehicle
Connect the jumper cable to ground on your vehicle as shown
in the illustration.
Start the engine of the second vehicle. Increase the
engine speed slightly and maintain at that level for
approximately 5 minutes to recharge the battery of your
vehicle.
Open and close any of the doors with the “ENGINE
START STOP” switch OFF.
Maintain the engine speed of the second vehicle and turn
the “ENGINE START STOP” switch to IGNITION ON
mode, then start the vehicle's engine.
Once the vehicle’s engine has started, remove the jumper
cables in the exact reverse order in which they were con-
nected.
Once the engine starts, have the vehicle checked at any autho-
rized Lexus dealer or repairer, or another duly qualified and
STEP3
STEP4
STEP5
STEP6

5
531
5-2. Steps to take in an emergency
When trouble arises
IS250/220d/200d_EE
If you run out of fuel and the engine stalls (IS220d and IS200d)
NOTICE
When restarting the engine
Do not crank the engine before refueling and priming the fuel system. This
may damage the engine and fuel system.
If you run out of fuel and the engine dies:
Refuel your vehicle.
Prime the fuel system by
using the satellite switches.
Push “” or “” to select prim-
ing operation mode. ( )
Press the “ON/OFF” button to
select “ON”. ( )
The priming operation will
start.
Wait for 1 minute and start the engine. (P. 156)
The priming operation will automatically stop when the engine
starts.
If the engine does not start after the above steps performed,
wait for 10 seconds and try step 2 and step 3 again. If the
engine still does not start, contact any authorized Lexus dealer
or repairer, or another duly qualified and equipped profes-
sional.
fihidhl dllihl
STEP1
STEP2
STEP3

532
5-2. Steps to take in an emergency
IS250/220d/200d_EE
If the vehicle becomes stuck
CAUTION
When attempting to free a stuck vehicle
If you choose to rock the vehicle back and forth to free it, make sure the sur-
rounding area is clear, to avoid striking other vehicles, objects or persons.
The vehicle may also lunge forward or lunge back suddenly as it becomes
free. Use extreme caution.
When shifting the shift lever
With automatic transmission vehicles, be careful not to shift the shift lever
with the accelerator pedal depressed.
This may lead to unexpected rapid acceleration of the vehicle that may
cause an accident and result in death or serious injury.
Carry out the following procedures if the tires spin or the vehicle
becomes stuck in mud, dirt, or snow.
Stop the engine. Set the parking brake and shift the shift
lever to P (vehicles with an automatic transmission) or N
(vehicles with a manual transmission).
Remove the mud, snow, or sand from around the stuck
tire.
Place wood, stones or some other material to help pro-
vide traction under the tires.
Restart the engine.
Shift the shift lever to the D or R position (vehicles with
an automatic transmission) or 1 or R position (vehicles
with a manual transmission), release the parking brake
and carefully apply the accelerator to free the vehicle.
Turn off TRC and VSC if these functions are hampering
fhhil()STEP1
STEP2
STEP3
STEP4
STEP5

546
6-1. Specifications
IS250/220d/200d_EE
Automatic transmission
*: The fluid capacity is provided as a reference.
If replacement is necessary, contact any authorized Lexus dealer or
repairer, or another duly qualified and equipped professional.
Manual transmission
Clutch
Fluid capacity*7.5 L (7.9 qt., 6.6 Imp. qt.)
Fluid typeToyota Genuine ATF WS
NOTICE
Using automatic transmission fluid other than “Toyota Genuine ATF WS”
may cause deterioration in shift quality, locking up of your transmission
accompanied by vibration, and ultimately damage the automatic transmission
of your vehicle.
Gear oil capacity1.8 L (1.9 qt., 1.6 Imp. qt.)
Gear oil typeAPI GL-5
Recommended gear oil viscos-
itySAE75W-90
Clutch free play5  15 mm (0.2  0.6 in.)
Fluid typeSAE J1703 or FMVSS No.116 DOT 3

556
IS250/220d/200d_EE
6-2. Customization
Customizable features
ItemFunctionDefault settingCustomized
setting
Smart entry
& start sys-
tem
(
P. 37)
Operation signal
(Emergency flashers) OnOff
Your vehicle includes a variety of electronic features that can be per-
sonalized to your preferences. Programming these preferences
requires specialized equipment and may be performed by any autho-
rized Lexus dealer or repairer, or another duly qualified and equipped
professional.
Some function settings are changed simultaneously with other func-
tions being customized. Contact any authorized Lexus dealer or

557
6-2. Customization
6
Vehicle specifica-
IS250/220d/200d_EE
Wireless
remote con-
trol
(
P. 55)
Unlocking operation
All doors
unlocked in
one step
Driver's door
unlocked in
one step, all
doors
unlocked in
two steps
Time elapsed before
automatic door lock
function is activated if
door is not opened after
being unlocked
30 seconds
60 seconds
120 seconds
Operation signal
(Emergency flashers) OnOff
Door lock buzzerOnOff
Trunk unlocking func-
tionOnOff
Trunk unlocking opera-
tionPush and holdPush twice
One short push
ItemFunctionDefault settingCustomized
setting

558
6-2. Customization
IS250/220d/200d_EE
Door lock
(
P. 58)
Speed-detecting auto-
matic door lock func-
tion
OnOff
Opening driver's door
unlocks all doorsOn*1Off*1
Off*2On*2
Shifting gears to P
unlocks all doors*3OffOn
Shifting gears to a posi-
tion other than P locks
all doors*
3OffOn
Unlocking using a key
All doors
unlocked in
one step.
Driver's door
unlocked in
one step, all
doors
unlocked in
two steps
Steering
wheel
(
P. 80)
Auto tilt-away functionOnOff
Power win-
dows
(P. 8 5 )
Linked door key opera-
tionOpen and close
Off
Open only
Close only
Wireless remote con-
trol linked operation Off
Open only
Close only
Open and close
Linked entry functionOnOff
ItemFunctionDefault settingCustomized
setting