2011 Lexus IS F high beam

IS F_EE
8
Headlights
(low/high beam)P. 172
Headlights (high beam) P. 172
Pictorial indexExterior
Front turn signal lights
P. 158
Front fog lights P. 175
Side turn signal lights P. 158
Front position lights P. 172
Windshield wipers P. 176
Moon roof 
P. 85
Outside rear view
mirrors
P. 80
Hood P. 362

165
2-2. Instrument cluster
2
When driving
IS F_EE
Indicators
The indicators inform the driver of the operating state of the
vehicle’s various systems.
*1:These lights turn on when the “ENGINE START STOP” switch
is turned to IGNITION ON mode to indicate that a system check
is being performed. They will turn off after the engine is started,
or after a few seconds. There may be a malfunction in a system if
a light does not come on, or if the lights do not turn off. Have the
vehicle inspected by any authorized Lexus dealer or repairer, or
another duly qualified and equipped professional, for details.
*2Th li ht fl h t i di t th t th t i ti
Turn signal indicator
(P. 159)Cruise control indicator
(P. 180, 184)
Headlight high beam
indicator (P. 172)
(if
equipped)
Lexus parking assist-
sensor indicator (P.
199)
Tail light indicator
(P. 172)Slip indicator (P.
206)
Front fog light indicator
(P. 175)VSC off indicator
(P. 206)
Rear fog light indicator
(P. 175)“TRC OFF” indicator
(P. 206)
“SNOW” indicator
(P. 152)SRS airbag on-off indi-
cator (P. 135)
“SPORT” indicator
(P. 152, 207)“DRL OFF” indicator
(P. 173)
*1,
*
*
*

172
IS F_EE
2-3. Operating the lights and windshield wipers
Headlight switch
Turning on the high beam headlights
With the headlights on, push
the lever forward to turn on
the high beams.
Pull the lever back to the center
position to turn the high beams
off.
Pull the lever toward you to
turn on the high beams.
Release to turn them off. You
can flash the high beams with
the headlights on or off.
The headlights can be operated manually or automatically.
The front position, tail,
license plate and
instrument panel lights
turn on.
The headlights and all
lights listed above turn
on.
The headlights, front
position lights and
other lights turn on
and off automatically.
(When the “ENGINE
START STOP” switch
is in IGNITION ON
mode)

401
4-3. Do-it-yourself maintenance
4
Maintenance and care
IS F_EE
13IG210 AIgnition system
14EFI NO. 210 A
Fuel system, exhaust system, mul-
tiport fuel injection system/sequen-
tial multiport fuel injection system
15H-LP R LWR15 AHeadlight low beam (right)
16H-LP L LWR15 AHeadlight low beam (left)
17F/PMP25 AFuel system
18EFI25 A
Multiport fuel injection system/
sequential multiport fuel injection
system, EFI NO. 2
19INJ25 A
Multiport fuel injection system/
sequential multiport fuel injection
system
20H-LP UPR20 AHeadlight high beams
21HORN10 AHorns
22WASHER20 AWindshield washer
23FR TAIL10 AFront position lights
24FR FOG15 AFront fog lights
FuseAmpereCircuit

407
4-3. Do-it-yourself maintenance
4
Maintenance and care
IS F_EE
Light bulbs
You may replace the following bulbs yourself. For more information
about replacing other light bulbs, contact any authorized Lexus dealer
or repairer, or another duly qualified and equipped professional.
Preparing a replacement light bulb
Check the wattage of the light bulb being replaced. (P. 481)
Removing the engine compartment cover
P. 367
Front bulb locations
Front fogHeadlight high
beamFront turn
signal light

408
4-3. Do-it-yourself maintenance
IS F_EE
Replacing light bulbs
Headlight high beams
When replacing the bulbs:
Left-side
Remove the wire harness
clamp.
Rear bulb locations
Rear fog light Rear turn signal
Back-up light
STEP1

415
4-3. Do-it-yourself maintenance
4
Maintenance and care
IS F_EERemove the connector and turn
the bulb base counterclockwise.
Remove the light bulb.
Bulbs other than the above
If any of the bulbs listed below has burnt out, have it replaced by
any authorized Lexus dealer or repairer, or another duly quali-
fied and equipped professional.
Headlight low and high beams (discharge bulbs)
Side turn signal lights
Stop/tail lights
Tail lights
High mounted stoplight
License plate lights
Front position lights
STEP2
STEP3

416
4-3. Do-it-yourself maintenance
IS F_EE
When replacing the front left headlight high beam bulb
Condensation build-up on the inside of the lens
Contact any authorized Lexus dealer or repairer, or another duly qualified
and equipped professional, for more information in the following situations.
Temporary condensation build-up on the inside of the headlight lens does
not indicate a malfunction.
Large drops of water are built up on the inside of the lens.
Water has built up inside the headlight.
Discharge headlights
If voltage to the discharge bulbs is insufficient, the bulbs may not come on,
or may go out temporarily. The discharge bulbs will come on when normal
power is restored.
LED tail lights, stop/tail lights, front position lights and high mounted stop-
light
The tail lights, stop/tail lights, front position lights and high mounted stop-
light consist of a number of LEDs. If any of the LEDs burn out, take your
vehicle to any authorized Lexus dealer or repairer, or another duly qualified
and equipped professional to have the light replaced.
Remove the securing bolt and move the
washer fluid filler opening to allow easy
access to the light bulbs.
After replacing the bulbs, make sure to
secure the washer fluid filler opening
with the bolt.