2011 Lexus CT200h torque

51
1
1-1. Hybrid system
Before driving
CT200h_EE (OM76041E)
Hybrid vehicle driving tips
For economical and ecological driving, pay attention to the following
points:
Using Eco drive mode
When using Eco drive mode, the torque corresponding to the accel-
erator pedal depression amount can be generated more smoothly
than it is in normal conditions. In addition, the operation of the air
conditioning system (heating/cooling) will be minimized, improv-
ing the fuel economy.
(P. 206)
Use of Hybrid System Indicator
The Eco-friendly driving is possible by keeping the indicate of
Hybrid System Indicator within Eco area. (P. 219)
When braking the vehicle
Make sure to operate the brakes gently and in good time. A greater
amount of electrical energy can be retained when slowing down.
Delays
Repeated acceleration and deceleration, as well as long waits at
traffic lights, will lead to bad fuel consumption. Check traffic
reports before leaving and avoid delays as much as possible. When
encountering a delay, gently release the brake pedal to allow the
vehicle to move forward slightly while avoiding overuse of the
accelerator pedal. Doing so can help control excessive gasoline
consumption.
Highway driving
Control your speed and keep at a constant speed. Also, before stop-
ping at a toll booth or similar, allow plenty of time to release the
ldllhbkA fli

194
2-1. Driving procedures
CT200h_EE (OM76041E)
NOTICE
When driving the vehicle
Do not depress the accelerator and brake pedals at the same time during
driving, as this may restrain driving torque.
Do not use the accelerator pedal or depress the accelerator and brake ped-
als at the same time to hold the vehicle on a hill.
Avoiding damage to vehicle parts
Do not turn the steering wheel fully in either direction and hold it there for
an extended period of time.
Doing so may damage the power steering motor.
When driving over bumps in the road, drive as slowly as possible to avoid
damaging the wheels, underside of the vehicle, etc.
If you get a flat tire while driving
A flat or damaged tire may cause the following situations. Hold the steering
wheel firmly and gradually depress the brake pedal to slow down the vehi-
cle.
It may be difficult to control your vehicle.
The vehicle will make abnormal sounds or vibrations.
The vehicle will lean abnormally.
Information on what to do in case of a flat tire (P. 586, 600)

206
2-1. Driving procedures
CT200h_EE (OM76041E)
Selecting a driving mode
The following modes can be selected to suit driving condi-
tions:
Normal mode
Eco drive mode
The torque generated in
response to accelerator pedal
depression will lessen com-
pared to normal, and air con-
ditioning operation (heating/
cooling) will be restrained,
thus suiting driving with
improved fuel efficiency.
When the driving mode
select switch is turned left,
the “ECO MODE” indicator
comes on in the instrument
cluster.
Press the switch to change
the driving mode to normal
mode.
Sport mode
Use when high levels of
response and feeling are
desirable, such as when driv-
ing in mountainous regions
or when overtaking.
When the driving mode
select switch is turned right,
the “SPORT MODE” indica-
tor comes on in the instru-
ment cluster

592
5-2. Steps to take in an emergency
CT200h_EE (OM76041E)Firmly tighten each wheel nut
two or three times in the order
shown in the illustration.
Tightening torque:
103 N•m (10.5 kgf•m, 76 ft•lbf)
Stow the flat tire, tire jack and all tools.
STEP4
STEP5

598
5-2. Steps to take in an emergency
CT200h_EE (OM76041E)
CAUTION
Replacing a flat tire
Do not touch the disc wheels or the area around the brakes immediately
after the vehicle has been driven.
After the vehicle has been driven the disc wheels and the area around the
brakes will be extremely hot. Touching these areas with hands, feet or
other body parts while changing a tire, etc. may result in burns.
Failure to follow these precautions could cause the wheel nuts to loosen
and the tire to fall off, resulting in death or serious injury.
• Have the wheel nuts tightened with a torque wrench to 103 N•m
(10.5 kgf•m, 76 ft•lbf) as soon as possible after changing wheels.
• When installing a tire, only use wheel nuts that have been specifically
designed for that wheel.
• If there are any cracks or deformations in the bolt screws, nut threads
or bolt holes of the wheel, have the vehicle inspected by any autho-
rized Lexus dealer or repairer, or another duly qualified and equipped
professional.
• When installing the wheel nuts, be sure to install then with the tapered
ends facing inward. (P. 510)

641
6-1. Specifications
6
Vehicle specifica-
CT200h_EE (OM76041E)
Fuel
Electric motor (traction motor)
Fuel type
EU area:
Unleaded gasoline conforming to European stan-
dard EN228 only.
Except EU area:
Unleaded gasoline only
Research octane num-
ber95 or higher
Fuel tank capacity
(Reference)45 L (11.9 gal., 9.9 lmp.gal.)
Ty p ePermanent magnet motor
Maximum output60 kW
Maximum torque207 N•m (21.1 kgf•m, 153 ft•lbf)

649
6-1. Specifications
6
Vehicle specifica-
CT200h_EE (OM76041E)
Tires and wheels
Ty p e A
Ty p e B
Tire size215/45R17 87W
Tire inflation pressure
(Recommended cold tire
inflation pressure)Front tire
230 kPa (2.3 kgf/cm2 or bar, 33 psi)
Rear tire
220 kPa (2.2 kgf/cm2 or bar, 32 psi)
Wheel size17  7 J
Wheel nut torque103 N•m (10.5 kgf•m, 76 ft•lbf)
Tire size205/55R16 91V
Tire inflation pressure
(Recommended cold tire
inflation pressure)
More than
160 km/h
(100 mph)240 kPa (2.4 kgf/cm2 or bar,
35 psi)
160 km/h
(100 mph)
or less220 kPa (2.2 kgf/cm2 or bar,
32 psi)
Wheel size16  6J
Wheel nut torque103 N•m (10.5 kgf•m, 76 ft•lbf)

650
6-1. Specifications
CT200h_EE (OM76041E)Ty p e C
Compact spare tire
Tire size195/65R15 91H
Tire inflation pressure
(Recommended cold tire
inflation pressure)
More than
160 km/h
(100 mph)250 kPa (2.5 kgf/cm2 or bar,
36 psi)
160 km/h
(100 mph) or
less
Normal pressure
230 kPa (2.3 kgf/cm2 or
bar, 33 psi)
ECO pressure
270 kPa (2.7 kgf/cm
2 or
bar, 39 psi)
Wheel size15  5 1/2J
Wheel nut torque103 N•m (10.5 kgf•m, 76 ft•lbf)
Tire sizeT125/70D17 98M
Spare tire inflation pressure
(Recommended cold tire infla-
tion pressure)
420 kPa (4.2 kgf/cm2 or bar, 60 psi)
Wheel size17  4 T
Wheel nut torque103 N•m (10.5 kgf•m, 76 ft•lbf)